參數資料
型號: LT1715
廠商: Linear Technology Corporation
英文描述: 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
中文描述: 4ns的,150MHz的雙通道比較器與獨立的輸入/輸出設備
文件頁數: 10/16頁
文件大?。?/td> 239K
代理商: LT1715
10
LT1715
LT1715 is the significant reduction in these effects, which
is important whenever an LT1715 is used to detect a
threshold crossing in one direction only. In such a case,
the relevant trip point will be all that matters, and a stable
offset voltage with an unpredictable level of hysteresis, as
seen in competing comparators, is useless. The LT1715 is
many times better than prior generation comparators in
these regards. In fact, the CMRR and PSRR tests are
performed by checking for changes in either trip point to
the limits indicated in the specifications table. Because the
offset voltage is the average of the trip points, the CMRR
and PSRR of the offset voltage is therefore guaranteed to
be at least as good as those limits. This more stringent test
also puts a limit on the common mode and power supply
dependence of the hysteresis voltage.
Additional hysteresis may be added externally. The rail-to-
rail outputs of the LT1715 make this more predictable than
with TTL output comparators due to the LT1715’s small
variability of V
OH
(output high voltage).
To add additional hysteresis, set up positive feedback by
adding additional external resistor R3 as shown in Fig-
ure6. Resistor R3 adds a portion of the output to the
threshold set by the resistor string. The LT1715 pulls the
outputs to +V
S
and ground to within 200mV of the rails
with light loads, and to within 400mV with heavy loads. For
the load of most circuits, a good model for the voltage on
the right side of R3 is 300mV or +V
S
– 300mV, for a total
voltage swing of (+V
S
– 300mV) – (300mV) = +V
S
– 600mV.
At frequencies well beyond 100MHz, the toggling of one
channel may be impaired by toggling on the other. This is
a rather complex interaction of supply bypassing and bond
inductance, and it cannot be entirely prevented. However,
good bypassing and board layout techniques will effec-
tively minimize it.
Power Supply Sequencing
The LT1715 is designed to tolerate any power supply
sequencing at system turn-on and power down. In any of
the previously shown power supply configurations, the
various supplies can activate in any order without exces-
sive current drain by the LT1715.
As always, the Absolute Maximum Ratings must not be
exceeded, either on the power supply terminals or the
input terminals. Power supply sequencing problems can
occur when input signals are powered from supplies that
are independent of the LT1715’s supplies. No problems
should occur if the input signals are powered from the
same V
CC
and V
EE
supplies as the LT1715.
Unused Comparators
If a comparator is unused, its output should be left floating
to minimize load current. The unused inputs can be tied off
to the rails and power consumption can be further mini-
mized if the inputs are connected to the power rails to
induce an output low. Connecting the inverting input to
V
CC
and the noninverting input to V
EE
will likely be the
easiest method.
Hysteresis
The LT1715 includes internal hysteresis, which makes it
easier to use than many other similar speed comparators.
The input-output transfer characteristic is illustrated in
Figure 5 showing the definitions of V
OS
and V
HYST
based
upon the two measurable trip points. The hysteresis band
makes the LT1715 well behaved, even with slowly moving
inputs.
The exact amount of hysteresis will vary from part to part
as indicated in the specifications table. The hysteresis
level will also vary slightly with changes in supply voltage
and common mode voltage. A key advantage of the
APPLICATIOU
W
U
U
Figure 5. Hysteresis I/O Characteristics
V
HYST
(= V
TRIP+
– V
TRIP–
)
V
HYST
/2
V
OL
1715 F05
V
OH
V
TRIP–
V
TRIP+
V
IN
= V
IN+
– V
IN–
V
TRIP+
+ V
TRIP–
2
V
OS
=
V
O
0
相關PDF資料
PDF描述
LT1715CMS 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
LT1715IMS 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
LT1761 100mA, Low Noise, LDO Micropower Regulators in SOT-23(可調輸出,100mA,低噪聲,低壓差穩壓器(SOT-23封裝))
LT1761-1.8 100mA, Low Noise, LDO Micropower Regulators in SOT-23(1.8V輸出,100mA,低噪聲,低壓差穩壓器(SOT-23封裝))
LT1761-2 100mA, Low Noise, LDO Micropower Regulators in SOT-23(2V輸出,100mA,低噪聲,低壓差穩壓器(SOT-23封裝))
相關代理商/技術參數
參數描述
LT1715_1 制造商:LINER 制造商全稱:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
LT1715CMS 功能描述:IC COMPARATOR 150MHZ DUAL 10MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS,推挽式,滿擺幅,TTL 電壓 - 電源,單路/雙路(±):2.5 V ~ 5.5 V,±1.25 V ~ 2.75 V 電壓 - 輸入偏移(最小值):5mV @ 5.5V 電流 - 輸入偏壓(最小值):1pA @ 5.5V 電流 - 輸出(標準):- 電流 - 靜態(最大值):24µA CMRR, PSRR(標準):80dB CMRR,80dB PSRR 傳輸延遲(最大):450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA,CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586
LT1715CMS#PBF 功能描述:IC COMPARATOR 150MHZ DUAL 10MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:帶電壓基準 元件數:4 輸出類型:開路漏極 電壓 - 電源,單路/雙路(±):2.5 V ~ 11 V,±1.25 V ~ 5.5 V 電壓 - 輸入偏移(最小值):10mV @ 5V 電流 - 輸入偏壓(最小值):- 電流 - 輸出(標準):0.015mA @ 5V 電流 - 靜態(最大值):8.5µA CMRR, PSRR(標準):80dB CMRR,80dB PSRR 傳輸延遲(最大):- 磁滯:- 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 安裝類型:表面貼裝 包裝:管件 產品目錄頁面:1386 (CN2011-ZH PDF)
LT1715CMS#PBF 制造商:Linear Technology 功能描述:High Speed Comparator IC
LT1715CMS#PBF 制造商:Linear Technology 功能描述:IC HIGH SPEED COMPARATOR