參數資料
型號: LT1054Y
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, UUC8
封裝: DIE
文件頁數: 3/30頁
文件大?。?/td> 607K
代理商: LT1054Y
LT1054
SWITCHED-CAPACITOR VOLTAGE CONVERTERS
WITH REGULATORS
SLVS033F FEBRUARY 1990 REVISED NOVEMBER 2004
11
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
regulation
The feedback/shutdown (FB/SD) terminal has two functions. Pulling FB/SD below the shutdown threshold
(
≈ 0.45 V) puts the device into shutdown. In shutdown, the reference/regulator is turned off and switching stops.
The switches are set such that both CIN and COUT are discharged through the output load. Quiescent current
in shutdown drops to approximately 100
μA. Any open-collector gate can be used to put the LT1054 into
shutdown. For normal (unregulated) operation, the device will restart when the external gate is shut off. In
LT1054 circuits that use the regulation feature, the external resistor divider can provide enough pulldown to keep
the device in shutdown until the output capacitor (COUT) has fully discharged. For most applications, where the
LT1054 is run intermittently, this does not present a problem because the discharge time of the output capacitor
is short compared to the off time of the device. In applications where the device has to start up before the output
capacitor (COUT) has fully discharged, a restart pulse must be applied to FB/SD of the LT1054. Using the circuit
shown in Figure 16, the restart signal can be either a pulse (tp > 100 μs) or a logic high. Diode coupling the restart
signal into FB/SD allows the output voltage to rise and regulate without overshoot. The resistor divider R3/R4
shown in Figure 16 should be chosen to provide a signal level at FB/SD of 0.71.1 V.
FB/SD also is the inverting input of the LT1054 error amplifier and, as such, can be used to obtain a regulated
output voltage.
VIN
R2
R1
R4
R3
Restart
Shutdown
C1
5
6
7
8
+
CIN
10-
μF
Tantalum
4
3
2
1
LT1054
VOUT
VREF
OSC
VCC
CAP
GND
CAP+
FB/SD
VOUT
Where: R1 = 20 k
Ω
VREF = 2.5 V Nominal
+
2.2
μF
For example: To get VO = 5 V, referenced to the ground terminal of the LT1054
Choose the closest 1% value.
Pin numbers shown are for the P package.
COUT
100-
μF
Tantalum
R2
+ R1
V
OUT
V
REF
2
* 40 mV
) 1
+ 20 kW
|–5 V|
2.5 V
2
* 40 mV
) 1
+ 102.6 kW
+
Figure 16. Basic Regulation Configuration
相關PDF資料
PDF描述
LT1054CDWRE4 SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDSO16
LT1054IPE4 SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDIP8
LT1054MJ8/883 SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
5962-8956201PX SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
5962-8956201PA SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
相關代理商/技術參數
參數描述
LT1055AMH/883 制造商:Linear Technology 功能描述:OP Amp Single GP ±20V 8-Pin TO-5
LT1055CH 制造商:Linear Technology 功能描述:OP Amp Single GP ±20V 8-Pin TO-5 制造商:Linear Technology 功能描述:OP Amp Single GP 20V 8-Pin TO-5
LT1055CN8 功能描述:IC PREC OP-AMP JFET HI-SPD 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
LT1055CN8#PBF 功能描述:IC PREC OP-AMP JFET HI-SPD 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
LT1055CN8#PBF 制造商:Linear Technology 功能描述:IC OP AMP HIGH SPEED 4.5MHZ