參數資料
型號: LT1054Y
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, UUC8
封裝: DIE
文件頁數: 2/30頁
文件大小: 607K
代理商: LT1054Y
LT1054
SWITCHED-CAPACITOR VOLTAGE CONVERTERS
WITH REGULATORS
SLVS033F FEBRUARY 1990 REVISED NOVEMBER 2004
10
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
The voltage reference (Vref) output provides a 2.5-V reference point for use in LT1054-based regulator circuits. The
temperature coefficient (TC) of the reference voltage has been adjusted so that the TC of the regulated output voltage
is near zero. As seen in the typical performance curves, this requires the reference output to have a positive TC. This
nonzero drift is necessary to offset a drift term inherent in the internal reference divider and comparator network tied
to the feedback terminal. The overall result of these drift terms is a regulated output that has a slight positive TC at
output voltages below 5 V and a slight negative TC at output voltages above 5 V. For regulator feedback networks,
reference output current should be limited to approximately 60
μA. Vref draws approximately 100 μA when shorted
to ground and does not affect the internal reference/regulator. This terminal also can be used as a pullup for LT1054
circuits that require synchronization.
CAP+ is the positive side of input capacitor CIN and is driven alternately between VCC and ground. When driven to
VCC, CAP+ sources current from VCC. When driven to ground, CAP+ sinks current to ground. CAP is the negative
side of the input capacitor and is driven alternately between ground and VOUT. When driven to ground, CAP sinks
current to ground. When driven to VOUT, CAP sources current from COUT. In all cases, current flow in the switches
is unidirectional, as should be expected when using bipolar switches.
OSC can be used to raise or lower the oscillator frequency or to synchronize the device to an external clock. Internally,
OSC is connected to the oscillator timing capacitor (Ct ≈ 150 pF), which is charged and discharged alternately by
current sources of
±7 μA, so that the duty cycle is approximately 50%. The LT1054 oscillator is designed to run in
the frequency band where switching losses are minimized. However, the frequency can be raised, lowered, or
synchronized to an external system clock if necessary.
The frequency can be increased by adding an external capacitor (C2 in Figure 15) in the range of 520 pF from CAP+
to OSC. This capacitor couples a charge into Ct at the switch transitions. This shortens the charge and discharge
times and raises the oscillator frequency. Synchronization can be accomplished by adding an external pullup resistor
from OSC to Vref. A 20-kΩ pullup resistor is recommended. An open-collector gate or an npn transistor then can be
used to drive OSC at the external clock frequency as shown in Figure 15.
The frequency can be lowered by adding an external capacitor (C1 in Figure 15) from OSC to ground. This increases
the charge and discharge times, which lowers the oscillator frequency.
C1
LT1054
VOUT
VREF
OSC
VCC
CAP
GND
CAP+
FB/SD
C2
VIN
Pin numbers shown are for the P package.
+
1
2
3
4
8
7
6
5
Figure 15. External-Clock System
相關PDF資料
PDF描述
LT1054CDWRE4 SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDSO16
LT1054IPE4 SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDIP8
LT1054MJ8/883 SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
5962-8956201PX SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
5962-8956201PA SWITCHED CAPACITOR REGULATOR, 25 kHz SWITCHING FREQ-MAX, CDIP8
相關代理商/技術參數
參數描述
LT1055AMH/883 制造商:Linear Technology 功能描述:OP Amp Single GP ±20V 8-Pin TO-5
LT1055CH 制造商:Linear Technology 功能描述:OP Amp Single GP ±20V 8-Pin TO-5 制造商:Linear Technology 功能描述:OP Amp Single GP 20V 8-Pin TO-5
LT1055CN8 功能描述:IC PREC OP-AMP JFET HI-SPD 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
LT1055CN8#PBF 功能描述:IC PREC OP-AMP JFET HI-SPD 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
LT1055CN8#PBF 制造商:Linear Technology 功能描述:IC OP AMP HIGH SPEED 4.5MHZ