參數資料
型號: LPC2103FBD48
廠商: NXP Semiconductors N.V.
元件分類: 數學處理器
英文描述: Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC
封裝: LPC2101FBD48<SOT313-2 (LQFP48)|<<http://www.nxp.com/packages/SOT313-2.html<1<Always Pb-free,;LPC2102FBD48<SOT313-2 (LQFP48)|<<http://www.nxp.com/packages/SOT313-2.html<
文件頁數: 13/37頁
文件大?。?/td> 192K
代理商: LPC2103FBD48
LPC2101_02_03_4
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 04 — 2 June 2009
13 of 37
NXP Semiconductors
LPC2101/02/03
Single-chip 16-bit/32-bit microcontrollers
6.7 Fast general purpose parallel I/O
Device pins that are not connected to a specific peripheral function are controlled by the
GPIO registers. Pins may be dynamically configured as inputs or outputs. Separate
registers allow setting or clearing any number of outputs simultaneously. The value of the
output register may be read back, as well as the current state of the port pins.
LPC2101/02/03 introduce accelerated GPIO functions over prior LPC2000 devices:
GPIO registers are relocated to the ARM local bus for the fastest possible I/O timing.
Mask registers allow treating sets of port bits as a group, leaving other bits
unchanged.
All GPIO registers are byte addressable.
Entire port value can be written in one instruction.
6.7.1
Features
Bit-level set and clear registers allow a single instruction set or clear of any number of
bits in one port.
Direction control of individual bits.
Separate control of output set and clear.
All I/O default to inputs after reset.
6.8 10-bit ADC
The LPC2101/02/03 contain one ADC. It is a single 10-bit successive approximation ADC
with eight channels.
6.8.1
Features
Measurement range of 0 V to 3.3 V.
Each converter capable of performing more than 400,000 10-bit samples per second.
Burst conversion mode for single or multiple inputs.
Optional conversion on transition on input pin or Timer Match signal.
Every analog input has a dedicated result register to reduce interrupt overhead.
6.9 UARTs
The LPC2101/02/03 each contain two UARTs. In addition to standard transmit and
receive data lines, UART1 also provides a full modem control handshake interface.
Compared to previous LPC2000 microcontrollers, UARTs in LPC2101/02/03 include a
fractional baud rate generator for both UARTs. Standard baud rates such as 115200 can
be achieved with any crystal frequency above 2 MHz.
6.9.1
Features
16 byte Receive and Transmit FIFOs.
Register locations conform to 16C550 industry standard.
Receiver FIFO trigger points at 1, 4, 8, and 14 bytes
相關PDF資料
PDF描述
LPC2103FHN48 Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC
LPC2104FBD48 Single-chip 32-bit microcontrollers; 128 kB ISP-IAP flash with 16-32-64 kB RAM
LPC2105FBD48 Single-chip 32-bit microcontrollers; 128 kB ISP-IAP flash with 16-32-64 kB RAM
LPC2106FBD48 Single-chip 32-bit microcontrollers; 128 kB ISP-IAP flash with 16-32-64 kB RAM
LPC2106FHN48 Single-chip 32-bit microcontrollers; 128 kB ISP-IAP flash with 16-32-64 kB RAM
相關代理商/技術參數
參數描述
LPC2103FBD48,118 功能描述:ARM微控制器 - MCU 32K FL/8K RAM/8CH RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2103FBD48,151 功能描述:ARM微控制器 - MCU ARM7 32KF/8KR/10BADC RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2103FBD48.151 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 16-bit/32-bit microcontrollers; 8 kB/16 kB/32 kB flash with ISP/IAP, fast ports and 10-bit ADC
LPC2103FBD48151 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU ARM7 70MHZ LQFP-48
LPC2103FBD48CP3255 制造商:NXP Semiconductors 功能描述:- Tape and Reel