參數資料
型號: LPC1342FBD48,151
廠商: NXP Semiconductors
文件頁數: 13/74頁
文件大?。?/td> 0K
描述: IC MCU 32BIT 48LQFP
標準包裝: 250
系列: LPC13xx
核心處理器: ARM? Cortex?-M3
芯體尺寸: 32-位
速度: 72MHz
連通性: I²C,Microwire,SPI,SSI,SSP,UART/USART,USB
外圍設備: 欠壓檢測/復位,POR,WDT
輸入/輸出數: 42
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: 閃存
RAM 容量: 4K x 8
電壓 - 電源 (Vcc/Vdd): 2 V ~ 3.6 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 48-LQFP
包裝: 托盤
其它名稱: 568-5214
LPC1311_13_42_43
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 5 — 6 June 2012
20 of 74
NXP Semiconductors
LPC1311/13/42/43
32-bit ARM Cortex-M3 microcontroller
On the LPC1311/13/42/43, all GPIO pins (except PIO0_4 and PIO0_5) are pulled up
to 2.6 V (VDD = 3.3 V) if their pull-up resistor is enabled in the IOCONFIG block.
On the LPC1311/01 and LPC1313/01, all GPIO pins (except PIO0_4 and PIO0_5) are
pulled up to 3.3 V (VDD = 3.3 V) if their pull-up resistor is enabled in the IOCONFIG
block.
7.9 USB interface (LPC1342/43 only)
The Universal Serial Bus (USB) is a 4-wire bus that supports communication between a
host and one or more (up to 127) peripherals. The host controller allocates the USB
bandwidth to attached devices through a token-based protocol. The bus supports
hot-plugging and dynamic configuration of the devices. All transactions are initiated by the
host controller.
The LPC1342/43 USB interface is a device controller with on-chip PHY for device
functions.
7.9.1 Full-speed USB device controller
The device controller enables 12 Mbit/s data exchange with a USB Host controller. It
consists of a register interface, serial interface engine, and endpoint buffer memory. The
serial interface engine decodes the USB data stream and writes data to the appropriate
endpoint buffer. The status of a completed USB transfer or error condition is indicated via
status registers. An interrupt is also generated if enabled.
7.9.1.1
Features
Dedicated USB PLL available.
Fully compliant with USB 2.0 specification (full speed).
Supports 10 physical (5 logical) endpoints with up to 64 bytes buffer RAM per
endpoint (see Table 5).
Supports Control, Bulk, Isochronous, and Interrupt endpoints.
Supports SoftConnect feature.
Double buffer implementation for Bulk and Isochronous endpoints.
Table 5.
USB device endpoint configuration
Logical
endpoint
Physical
endpoint
Endpoint type
Direction
Packet size
(byte)
Double buffer
0
Control
out
64
no
0
1
Control
in
64
no
1
2
Interrupt/Bulk
out
64
no
1
3
Interrupt/Bulk
in
64
no
2
4
Interrupt/Bulk
out
64
no
2
5
Interrupt/Bulk
in
64
no
3
6
Interrupt/Bulk
out
64
yes
3
7
Interrupt/Bulk
in
64
yes
4
8
Isochronous
out
512
yes
4
9
Isochronous
in
512
yes
相關PDF資料
PDF描述
C8051F501-IQ IC 8051 MCU 64K FLASH 48-QFP
P89LPC935FDH,529 IC 80C51 MCU FLASH 8K 28-TSSOP
C8051F504-IQ IC 8051 MCU 32K FLASH 48-QFP
LPC11U14FBD48/201, IC MCU 32BIT 32K 48LQFP
P87LPC767FD,512 IC 80C51 MCU 4K OTP 20-SOIC
相關代理商/技術參數
參數描述
LPC1342FHN33 制造商:NXP Semiconductors 功能描述:MCU 32BIT 16KFLASH CORTEX-M3 33HVQFN 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, 16KFLASH, CORTEX-M3, 33HVQFN
LPC1342FHN33,518 功能描述:8位微控制器 -MCU 32B ARM CORTEXM3 MCU 16KB FL 4KB SRAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
LPC1342FHN33,551 功能描述:ARM微控制器 - MCU 32-bit ARM Cortex-M3 16kb Flash RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC1342FHN33551 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU ARM 72MHZ HVQFN-33 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX M3 32HVQFN
LPC1343 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 microcontroller up to 32 kB flash and 8 kB SRAM USB device