- 您現在的位置：買賣IC網 > PDF目錄299411 > LP3985IM5-285/NOPB (NATIONAL SEMICONDUCTOR CORP) 2.85 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 PDF資料下載
參數資料
| 型號： | LP3985IM5-285/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 固定正電壓?jiǎn)温份敵鯨DO穩壓器 |
| 英文描述： | 2.85 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
| 封裝： | SOT-23, SOP-5 |
| 文件頁數： | 5/17頁 |
| 文件大小： | 993K |
| 代理商： | LP3985IM5-285/NOPB |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
Typical Performance Characteristics Unless otherwise specified, C
IN =COUT = 1 F Ceramic,
CBYPASS = 0.01 F, VIN =VOUT + 0.2V, TA = 25C, Enable pin is tied to VIN. (Continued)
Output Impedance (V
IN = 4.2V)
Output Impedance (V
IN =VOUT + 0.2V)
10136465
10136466
Application Hints
EXTERNAL CAPACITORS
Like any low-dropout regulator, the LP3985 requires external
capacitors for regulator stability. The LP3985 is specifically
designed for portable applications requiring minimum board
space and smallest components. These capacitors must be
correctly selected for good performance.
INPUT CAPACITOR
An input capacitance of ) 1F is required between the
LP3985 input pin and ground (the amount of the capacitance
may be increased without limit).
This capacitor must be located a distance of not more than
1cm from the input pin and returned to a clean analog
ground. A ceramic capacitor is recommended although a
good quality tantalum or film capacitor may be used at the
input.
Important: Tantalum capacitors can suffer catastrophic fail-
ures due to surge current when connected to a low-
impedance source of power (like a battery or a very large
capacitor). If a tantalum capacitor is used at the input, it must
be guaranteed by the manufacturer to have a surge current
rating sufficient for the application.
There are no requirements for the ESR on the input capaci-
tor, but tolerance and temperature coefficient must be con-
sidered when selecting the capacitor to ensure the capaci-
tance will remain within the operational range over the full
range of temperature and operating conditions.
OUTPUT CAPACITOR
Correct selection of the output capacitor is important to
ensure stable operation in the intended application.
The output capacitor must meet all the requirements speci-
fied in the recommended capacitor table over all conditions
in the application. These conditions include DC-bias, fre-
quency and temperature. Unstable operation will result if the
capacitance drops below the minimum specified value. (See
the next section Capacitor Characteristics).
The LP3985 is designed specifically to work with very small
ceramic output capacitors. A 1.0F ceramic capacitor (dia-
lectric type X7R) with ESR between 5m
to 500m is
suitable in the LP3985 application circuit. X5R capacitors
may be used but have a narrower temperature range. With
these and other capacitor types (Y5V, Z6U) that may be
used, selection is dependant on the range of operating con-
ditions and temperature range for that application. (see sec-
tion on Capacitor Characteristics).
It may also be possible to use tantalum or film capacitors at
the output, but these are not as attractive for reasons of size
and cost (see next section Capacitor Characteristics).
It is also recommended that the output capacitor be placed
within 1cm from the output pin and returned to a clean
ground line.
CAPACITOR CHARACTERISTICS
The LP3985 is designed to work with ceramic capacitors on
the output to take advantage of the benefits they offer: for
capacitance values in the range of 1F to 4.7F range,
ceramic capacitors are the smallest, least expensive and
have the lowest ESR values (which makes them best for
eliminating high frequency noise). The ESR of a typical 1F
ceramic capacitor is in the range of 20 m
to 40 m, which
easily meets the ESR requirement for stability by the
LP3985.
For both input and output capacitors careful interpretation of
the capacitor specification is required to ensure correct de-
vice operation. The capacitor value can change greatly de-
pendant on the conditions of operation and capacitor type.
In particular the output capacitor selection should take ac-
count of all the capacitor parameters to ensure that the
specification is met within the application. Capacitance value
can vary with DC bias conditions as well as temperature and
frequency of operation. Capacitor values will also show
some decrease over time due to aging. The capacitor pa-
rameters are also dependant on the particular case size with
smaller sizes giving poorer performance figures in general.
As an example Figure 3 shows a typical graph showing a
comparison of capacitor case sizes in a Capacitance vs. DC
Bias plot. As shown in the graph, as a result of the DC Bias
condition the capacitance value may drop below the mini-
mum capacitance value given in the recommended capacitor
table (0.7F in this case). Note that the graph shows the
capacitance out of spec for the 0402 case size capacitor at
higher bias voltages. It is therefore recommended that the
capacitor manufacturers’ specifications for the nominal value
LP3985
www.national.com
13
相關PDF資料 |
PDF描述 |
|---|---|
| LP3985IM5X-2.6/NOPB | 2.6 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
| LP3985IM5X-2.9/NOPB | 2.9 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
| LP3985IM5X-3.1/NOPB | 3.1 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
| LP3985IM5X-3.2/NOPB | 3.2 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
| LP61L1008AS-10 | 128K x 8 bit high speed 3.3V center power CMOS SRAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3985IM5-3.0 | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP3985IM5-3.0/NOPB | 功能描述:低壓差穩壓器 - LDO 150Ma Low Noise CMOS LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP3985IM5-3.0/NOPB | 制造商:Texas Instruments 功能描述:Linear Voltage Regulator IC |
| LP3985IM53.1 | 制造商:Texas Instruments 功能描述: |
| LP3985IM5-3.1 | 制造商:NATL SEMI 功能描述:3.1 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 制造商:Texas Instruments 功能描述:3.1 V FIXED POSITIVE LDO REGULATOR, 0.1 V DROPOUT, PDSO5 |
發布緊急采購，3分鐘左右您將得到回復。