參數資料
型號: LMF100CIWM
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 模擬濾波器
英文描述: High Performance Dual Switched Capacitor Filter
中文描述: DUAL SWITCHED CAPACITOR FILTER, RESISTOR PROGRAMMABLE, UNIVERSAL, PDSO20
封裝: SOP-20
文件頁數: 21/28頁
文件大?。?/td> 868K
代理商: LMF100CIWM
3.0 Applications Information
(Continued)
3.1 DESIGN EXAMPLE
In order to design a filter using the LMF100, we must define
the necessary values of three parameters for each
second-order section: f
, the filter section’s center frequency;
H
, the passband gain; and the filter’s Q. These are deter-
mined by the characteristics required of the filter being de-
signed.
As an example, let’s assume that a system requires a
fourth-order Chebyshev low-pass filter with 1 dB ripple, unity
gain at dc, and 1000 Hz cutoff frequency. As the system or-
der is four, it is realizable using both second-order sections
of an LMF100. Many filter design texts (and National’s
Switched Capacitor Filter Handbook) include tables that list
the characteristics (f
and Q) of each of the second-order fil-
ter sections needed to synthesize a given higher-order filter.
For the Chebyshev filter defined above, such a table yields
the following characteristics:
f
0A
= 529 Hz
Q
A
= 0.785
f
0B
= 993 Hz
Q
B
= 3.559
For unity gain at dc, we also specify:
H
0A
= 1
H
0B
= 1
The desired clock-to-cutoff-frequency ratio for the overall fil-
ter of this example is 100 and a 100 kHz clock signal is avail-
able. Note that the required center frequencies for the two
second-order
sections
will
clock-to-center-frequency ratios of 50 or 100. It will be nec-
essary to adjust
not
be
obtainable
with
externally. From Table 1 we see that Mode 3 can be used to
produce a low-pass filter with resistor-adjustable center fre-
quency.
In most filter designs involving multiple second-order stages,
it is best to place the stages with lower Q values ahead of
stages with higher Q, especially when the higher Q is greater
than 0.707. This is due to the higher relative gain at the cen-
ter frequency of a higher-Q stage. Placing a stage with lower
Q ahead of a higher-Q stage will provide some attenuation at
the center frequency and thus help avoid clipping of signals
near this frequency. For this example, stage A has the lower
Q (0.785) so it will be placed ahead of the other stage.
For the first section, we begin the design by choosing a con-
venient value for the input resistance: R
= 20k. The abso-
lute value of the passband gain H
OLPA
is made equal to 1 by
choosing R
such that: R
= H
R
= R
= 20k. If
the 50/100/CL pin is connected to mid-supply for nominal
100:1 clock-to-center-frequency ratio, we find R
2A
by:
The resistors for the second section are found in a similar
fashion:
The complete circuit is shown in Figure 19 for split
±
5V
power supplies. Supply bypass capacitors are highly
recommended.
www.national.com
21
相關PDF資料
PDF描述
LMF100ACN IC-MONOLITHIC FILTER
LMF380 LMF380 Triple One-Third Octave Switched-Capacitor Active Filter
LMF380C1J LMF380 Triple One-Third Octave Switched-Capacitor Active Filter
LMF380CIN SERIAL ATA SIGNAL CABLE
LMF380CIV LMF380 Triple One-Third Octave Switched-Capacitor Active Filter
相關代理商/技術參數
參數描述
LMF100CIWM/NOPB 功能描述:有源濾波器 HI PERF DUAL SWITCH CAPACITOR FILTER RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube
LMF100CIWMX 功能描述:有源濾波器 RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube
LMF100CIWMX/NOPB 功能描述:有源濾波器 RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube
LMF100J WAF 制造商:Texas Instruments 功能描述:
LMF11C202W2851 制造商:Vishay Dale 功能描述:KIT LM F 11 C 202 W02851 E3 - Rail/Tube