- 您現在的位置：買賣IC網 > PDF目錄385476 > LM1971 (National Semiconductor Corporation) LM1971 Overture⑩ Audio Attenuator Series Digitally Controlled 62 dB Audio Attenuator with/Mute PDF資料下載
參數資料
| 型號： | LM1971 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | LM1971 Overture⑩ Audio Attenuator Series Digitally Controlled 62 dB Audio Attenuator with/Mute |
| 中文描述： | LM1971音頻序曲⑩衰減器系列數控六十二分貝音頻衰減器與/靜音 |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 248K |
| 代理商： | LM1971 |
Application Information
(Continued)
μPOT LADDER ARCHITECTURE
The μPot contains a chain of R1/R2 resistor dividers in a lad-
der form, as shown in Figure 4 Each R1 is actually a series
of 8 resistors, with a CMOS switch that taps into the resistor
chain according to the attenuation level chosen. For any
given attenuation setting, there is only one CMOS switch
closed (no paralleling of ladders). The input impedance
therefore remains constant, while the output impedance
changes as the attenuation level changes. It is important to
note that the architecture is a series of resistor dividers, and
not a straight, tapped resistor, so the μPot is not a variable
resistor; it is a variable voltage divider.
ATTENUATION STEP SCHEME
The fundamental attenuation step scheme for the LM1971 is
shown in Figure 5 It is also possible to obtain any integer
value attenuation step through programming, in addition to
the 2 dB and 4 dB steps shown in Figure 5All higher attenu-
ation step schemes can have clickless and popless perfor-
mance. Although it is possible to “skip” attenuation points by
not sending all of the data, clickless and popless perfor-
mance will suffer. It is highly recommended that all of the
data points should be sent for each attenuation level. This
ensures flawless operation and performance when making
steps larger than 1 dB.
INPUT IMPEDANCE
The input impedance of a μPot is constant at a nominal
40 k
. Since the LM1971 is a single-supply operating de-
vice, it is necessary to have both input and output coupling
caps as shown in Figure 1 To ensure full low-frequency re-
sponse, a 1 μF coupling cap should be used.
OUTPUT IMPEDANCE
The output impedance of a μPot varies typically between
25 k
and 35 k
and changes nonlinearly with step
changes. Since a μPot is made up of a resistor ladder net-
work with logarithmic attenuation, the output impedance is
nonlinear. Due to this configuration, a μPot cannot be con-
sidered as a linear potentiometer; it is a logarithmic attenua-
tor.
The linearity of a μPot cannot be measured directly without a
buffer because the input impedance of most measurement
systems is not high enough to provide the required accuracy.
The lower impedance of the measurement system would
load down the output and an incorrect reading would result.
To prevent loading, a JFET input op amp should be used as
the buffer/amplifier.
OUTPUT BUFFERING
There are two performance issues to be aware of that are re-
lated to a μPot’s output stage. The first concern is to prevent
audible clicks with attenuation changes, while the second is
to prevent loading and subsequent linearity errors. The out-
put stage of a μPot needs to be buffered with a low input bias
DS012353-4
FIGURE 3. Serial Data Format Transfer Process
DS012353-5
FIGURE 4. Resistor Ladder Architecture
LM 1971 Channel Attenuation
vs Digital Step Value
(1 dB, 2 dB, and 4 dB Steps)
DS012353-6
FIGURE 5. LM1971 Attenuation Step Scheme
www.national.com
7
相關PDF資料 |
PDF描述 |
|---|---|
| LM1971M | LM1971 Overture⑩ Audio Attenuator Series Digitally Controlled 62 dB Audio Attenuator with/Mute |
| LM1971N | LM1971 Overture⑩ Audio Attenuator Series Digitally Controlled 62 dB Audio Attenuator with/Mute |
| LM1972 | Pot 2-Channel 78dB Audio Attenuator with Mute |
| LM1972MX | Tone/Volume/Balance Control |
| LM1972M | Pot 2-Channel 78dB Audio Attenuator with Mute |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1971M | 功能描述:衰減器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰減:18 dB 容差: 阻抗: 功率額定值:30 dBm 安裝風格:SMD/SMT 工作溫度范圍:- 40 C to + 85 C |
| LM1971M | 制造商:Texas Instruments 功能描述:AUDIO ATTENUATOR 62DB 1971 SOIC8 |
| LM1971M/NOPB | 功能描述:有源衰減器 DIG CONTROLLED 62 DB AUDIO ATTENUATOR RoHS:否 制造商:TriQuint Semiconductor 通道數量: 最大頻率: 阻抗: 最大 VSWR: 位數: 最大工作溫度: 最小工作溫度: |
| LM1971M/NOPB | 制造商:Texas Instruments 功能描述:IC, AUDIO ATTENTUATOR, SOIC-8 |
| LM1971MX | 功能描述:衰減器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰減:18 dB 容差: 阻抗: 功率額定值:30 dBm 安裝風格:SMD/SMT 工作溫度范圍:- 40 C to + 85 C |
發布緊急采購，3分鐘左右您將得到回復。