- 您現在的位置：買賣IC網 > PDF目錄384594 > LM1276AAA (National Semiconductor Corporation) 150 MHz I2C Compatible RGB Preamplifier with Internal 512 Character OSD ROM, 512 Character RAM and 4 DACs PDF資料下載
參數資料
| 型號： | LM1276AAA |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | 150 MHz I2C Compatible RGB Preamplifier with Internal 512 Character OSD ROM, 512 Character RAM and 4 DACs |
| 中文描述： | 150 MHz的I2C兼容的RGB前置放大器512個字符OSD光盤，512個字符RAM和4 DAC的內置 |
| 文件頁數： | 12/50頁 |
| 文件大?。?/td> | 2597K |
| 代理商： | LM1276AAA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
Typical Performance
Characteristics
V
CC
= 5V, T
A
= 25C unless
otherwise specified (Continued)
VIDEO PROCESSING
Emphasis, Center Frequency at Maximum
20096963
Center Frequency, Emphasis at Maximum
These two plots show the processing done by the LM1276
on the video input signal. There are two variables for the
video processing, emphasis and center frequency.
Empha-
sis is controlled by bits 0-2 in registers 0x85C8, 0x85CA,
or 0x85CC.
This gives 8 different levels of emphasis. In the
top plot the center frequency is set at its maximum level and
the 8 different levels of emphasis are measured. The video
with no emphasis is adjusted to a 0.7 V
level. Using
maximum emphasis the video is increased to a 0.9 V
level at the rising edge of the video. If the falling edge was
measured it would show a similar waveform, but going in the
negative direction.
Center frequency is shown in the bottom plot.
Control of the
center frequency is done with bits 4-7 in register
0x85C1
. This gives 16 adjustments for this feature. Every
other adjustment is shown in the bottom plot, since showing
all 16 adjustments would have made the plot too difficult to
read. The curves closely approximate the peaking of an RC
network. Therefore, the term center frequency means the
RC time constant that is approximated by each curve in the
above plot. A true RC peaking network would give very large
overshoot. The LM1276 has special circuitry to clip the very
large overshoot, yet has the complete benefit of the RC
peaking. This special circuitry allows for much more over-
shoot than one could do with RC peaking and still not
saturate the video channel.
Note that the video channel with the emphasis also has its
own independent contrast control. This allows the user to
adjust his monitor for a brighter picture within the Hi-Brite
window and optimize the emphasis for the resolution he is
using with the monitor. Now, the monitor user can give his
pictures or video a special “sparkle” when using the capa-
bilities of the LM1276.
OSD PHASE LOCKED LOOP
The PLL in the LM1276 serves both the OSD as well as the
Hi-Brite Window generation. The pixels per line range for the
LM1276 OSD is from 704 to 1152 pixels per line, in incre-
ments of 64. The maximum OSD pixel frequency available is
111 MHz. For example, if the horizontal scan rate is 106 kHz,
1024 pixels per line would be acceptable to use, since the
OSD pixel frequency is:
Horizontal Scan Rate X PPL =
106kHz X 1024 = 108.5 MHz
If 1152 pixels per line is being used, the horizontal scan rate
would have to be lower than 106 kHz in order to not exceed
the maximum OSD pixel frequency of 111 MHz. The maxi-
mum number of video lines that may be used is 1536 lines as
in a 2048x1536 display. At this line rate, using a PPL setting
of 4 is recommended. The LM1276 has a
PLL Auto
feature,
which will automatically select an internal PLL frequency
range setting that will guarantee optimal OSD locking for any
horizontal scan rate and for improved jitter performance over
a wider temperature range. This eliminates the need for PLL
register settings determined by the user, as well as improved
PLL performance. To initialize the PLL Auto feature, set bit,
0x8439[4] to 1. This will effectively perform all necessary
calibrations and activate the PLL Auto mode, which takes
approximately 2–4 vertical scan period to complete, and
must be done while the video is blanked.
Table 2
shows the
recommended horizontal scan rate ranges (in kHz) for each
pixels per line register setting, 0x8401[7:5]. These ranges
are recommended for chip ambient temperatures of 0
o
70
o
C, and the recommended PLL filter values are 6.2 k
,
0.01 uF, and 1000 pF. While the OSD PLL will lock for other
register combinations and at scan rates outside these
ranges, the performance of the loop will be improved if these
recommendations are followed.
PLL AUTO MODE INITIALIZATION SEQUENCE
Blank video.
Set 0x8539[4] to 1.
Wait for at least 2–4 vertical periods or vertical sync
pulses to pass.
Unblank Video.
This sequence must be done by the microcontroller at sys-
tem power up, as well as each time there is a horizontal line
rate change from the video source, for the PLLAuto mode to
function properly.
L
www.national.com
12
相關PDF資料 |
PDF描述 |
|---|---|
| LM139JAN | Low Power Low Offset Voltage Quad Comparators |
| LM1403 | Precision 2.50V Reference |
| LM1403A | Precision 2.50V Reference |
| LM1403AN | Precision 2.50V Reference |
| LM1403N | Precision 2.50V Reference |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1279 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:110 MHz RGB Video Amplifier System with OSD |
| LM12791DL WAF | 制造商:Texas Instruments 功能描述: |
| LM1279A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| LM1279AN | 功能描述:IC AMP RGB VIDEO SYSTEM 20-DIP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| LM1279DL WAF | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。