- 您現在的位置：買賣IC網 > PDF目錄358757 > LC65P1104 (Sanyo Electric Co.,Ltd.) On-Chip UVEPROM 4-Bit Single-Chip Microcontroller PDF資料下載
參數資料
| 型號： | LC65P1104 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | On-Chip UVEPROM 4-Bit Single-Chip Microcontroller |
| 中文描述： | 片上UVEPROM 4位單片機 |
| 文件頁數： | 6/19頁 |
| 文件大?。?/td> | 265K |
| 代理商： | LC65P1104 |
Port C and D reset output level options
Either of the following two options may be selected for the C and D I/O ports. Note that these options are specified in 4-
bit units.
Port output configuration option
All shared-function I/O ports have an open-drain output circuit in the LC65E1104.
Watchdog reset option
This option specifies the use of the PE1/WDR pin. This pin can be specified to function either as the normal port PE1 or
as the WDR watchdog reset pin.
Usage Notes
1. Option specification
The SU60K.EXE program is used for option specification. The option code for the option specification area
(addresses 1000 to 100A (hexadecimal)) is created by assembling the output of the SU60K.EXE program using the
Sanyo M60K.EXE macro assembler and then linking the macro assembler output with the Sanyo L60K.EXE linker.
It is also possible to load data directly into the option specification area. Specify options according to the option code
creation table on page 8.
2. PROM programming
LC65E1104 can be programmed with a general-purpose EPROM programmer using either the W65EP1104D or
W65EP1104M adapter.
Recommended EPROM programmers
The Intel 27512 (VPP: 12.5 V) high-speed programming method must be used to program this device. The address
range must be set to 0 to 100A (hexadecimal) and the DASEC jumper must be set to the off position.
3. Using the data security function
The data security function prevents data already written to the microcontroller's PROM from being overwritten.
LC651104 data security function procedure
Move the DASEC jumper on the EPROM programming pin adapter to the on position. This enables the data
security function.
Attempt to reprogram the EPROM.
Since the data security function is enabled, the EPROM programmer will display an error. Note that this error is not
due to an error in either the programmer or the LSI.
No. 5221-6/19
LC65E1104
Option name
Conditions
1. Output at reset: high
All 4 bits of the selected port(s) (C or D or both)
1. Output at reset: low
All 4 bits of the selected port(s) (C or D or both)
Option
Circuit
Conditions and notes
1. Open drain output
Ports A, C, D, E and F
Manufacturer
EPROM programmer
Advantest
R4945, R4944, R4943 or equivalent programmer
Ando
AF-9704
AVAL
—
Minato electronics
—
相關PDF資料 |
PDF描述 |
|---|---|
| LC662106A | Four-Bit Single-Chip Microcontrollers with 4, 6, and 8 KB of On-Chip ROM |
| LC662306A | Four-Bit Single-Chip Microcontrollers with 6 KB of On-Chip ROM(4位單片微控制器(帶6K字節片上ROM)) |
| LC662308A | Four-Bit Single-Chip Microcontroller with 16 KB of On-Chip OTP PROM |
| LC662508A | Four-Bit Single-Chip Microcontrollers with 8, 12, and 16 KB of On-Chip ROM |
| LC66306A | 6K-Byte ROM-Contained Single-Chip 4-Bit Microcontroller for Control-Oriented Application(用于控制導向的單片4位微控制器(帶6K字節ROM)) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC65P29 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:One-Time Programmable 4-Bit Single-Chip Microcontroller |
| LC65P3608 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| LC65P43 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:One-Time Programmable 4-Bit Single-Chip Microcontroller |
| LC65PG99 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| LC660Z | 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED |
發布緊急采購，3分鐘左右您將得到回復。