- 您現在的位置：買賣IC網 > PDF目錄376110 > LBC2518 (Monolithic Power Systems, Inc.) 1.7MHz, 600mA Synchronous Step-Down Converter PDF資料下載
參數資料
| 型號： | LBC2518 |
| 廠商： | Monolithic Power Systems, Inc. |
| 英文描述： | 1.7MHz, 600mA Synchronous Step-Down Converter |
| 中文描述： | 為1.7MHz，600mA的同步降壓轉換器 |
| 文件頁數： | 9/10頁 |
| 文件大?。?/td> | 454K |
| 代理商： | LBC2518 |
MP2104 – 1.7MHz 600mA SYNCHRONOUS STEP-DOWN CONVERTER
NOTICE:
MPS believes the information in this document to be accurate and reliable. However, it is subject to change without
notice. Contact MPS for current specifications. MPS encourages users of its products to ensure that third party Intellectual
Property rights are not infringed upon when integrating MPS products into any application. MPS cannot assume any legal
responsibility for any said applications.
MP2104 Rev. 1.0
10/4/05
2004 MPS, Inc.
Monolithic Power Systems, Inc.
983 University Avenue, Building A, Los Gatos, CA 95032 USA
Tel: 408-357-6600
Fax: 408-357-6601
www.MonolithicPower.com
9
TM
Input Capacitor Selection
The input capacitor reduces the surge current
drawn from the input and switching noise from
the device. The input capacitor impedance at
the switching frequency shall be less than input
source impedance to prevent high frequency
switching current passing to the input. Ceramic
capacitors with X5R or X7R dielectrics are
highly recommended because of their low ESR
and small temperature coefficients. For most
applications, a 4.7μF capacitor is sufficient.
Output Capacitor Selection
The output capacitor keeps output voltage
ripple small and ensures regulation loop stable.
The output capacitor impedance shall be low at
the switching frequency. Ceramic capacitors
with X5R or X7R dielectrics are recommended.
The output ripple
V
OUT
is approximately:
(
×
×
L
f
V
OSC
IN
)
×
×
+
×
×
≤
3
C
f
8
1
ESR
V
V
V
V
OSC
OUT
IN
OUT
OUT
PC Board Layout
The high current paths (GND, IN and SW)
should be placed very close to the device with
short, direct and wide traces. Input capacitor C1
needs to be as close as possible to the IN and
GND pins. The external feedback resistors shall
be placed next to the FB pin. Keep the
switching node SW short and away from the
feedback network. Figure 3 illustrates an
example of PCB layout and signal routing.
Figure 3—MP2104 Suggested Layout
For the fixed output versions (MP2104DJ-1.5
and MP2104-1.8), R1 is shorted and R2 is
open.
MP2104
SW
FB
EN
GND
IN
OUTPUT
1.8V
600mA
INPUT
2.5V - 6V
MP2104_F04
OFF ON
3
5
2
1
4
100
90
80
70
60
50
40
30
20
10
0
E
10
100
1000
LOAD CURRENT (mA)
MP2104-EC02
Efficiency vs
Load Current
V
IN
= 3.3V
V
IN
= 4.2V
Figure 4—V
IN
= 2.5V to 6V, V
OUT
= 1.8V, I
LOAD
= 600mA Step-Down Circuit
(L = 10μH for Higher Light-Load Efficiency)
相關PDF資料 |
PDF描述 |
|---|---|
| LC70A | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC10 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC10A | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC11 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC9.0 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LBC2518T100 | 制造商:TAIYO-YUDEN 制造商全稱:Taiyo Yuden (U.S.A.), Inc 功能描述:WOUND CHIP INDUCTORS |
| LBC2518T100K | 功能描述:固定電感器 INDCTR HI CUR WND 1007 10uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LBC2518T100KV | 功能描述:10μH Unshielded Wirewound Inductor 375mA 360 mOhm Nonstandard 制造商:taiyo yuden 系列:LB 包裝:剪切帶（CT） 零件狀態:有效 類型:繞線 材料 - 磁芯:- 電感:10μH 容差:±10% 額定電流:375mA 電流 - 飽和值:- 屏蔽:無屏蔽 DC 電阻（DCR）:360 毫歐 不同頻率時的 Q 值:- 頻率 - 自諧振:30MHz 等級:AEC-Q200 工作溫度:-40°C ~ 105°C 頻率 - 測試:2.52MHz 安裝類型:表面貼裝 封裝/外殼:非標準 大小/尺寸:0.098" 長 x 0.071" 寬（2.50mm x 1.80mm） 高度 - 安裝（最大值）:0.079"（2.00mm） 標準包裝:1 |
| LBC2518T100M | 功能描述:固定電感器 INDCTR HI CUR WND 1007 10uH 20% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LBC2518-T100MK | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:Surface Mount Ferrite Products |
發布緊急采購，3分鐘左右您將得到回復。