- 您現在的位置：買賣IC網 > PDF目錄376110 > LBC2518 (Monolithic Power Systems, Inc.) 1.7MHz, 600mA Synchronous Step-Down Converter PDF資料下載
參數資料
| 型號： | LBC2518 |
| 廠商： | Monolithic Power Systems, Inc. |
| 英文描述： | 1.7MHz, 600mA Synchronous Step-Down Converter |
| 中文描述： | 為1.7MHz，600mA的同步降壓轉換器 |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 454K |
| 代理商： | LBC2518 |
MP2104 – 1.7MHz 600mA SYNCHRONOUS STEP-DOWN CONVERTER
MP2104 Rev. 1.3
10/4/2005
www.MonolithicPower.com
7
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
2005 MPS. All Rights Reserved.
TM
IN
EN
OUT
GND
SW
+
+
--
PWMCMP
PWM
OSC
+
--
EAMP
ICS
SLOPE COMP
FEEDBACK
ERROR
AMP
0.6V
EAO
CC
17pF
BIAS
&
VOLTAGE
REFERENCE
PWM
CONTROL
LOGIC
1.7MHz
OSCILLATOR
IAMP
10X
CURRENT
SENSE
AMP
DH
DL
+
--
MAIN
SWITCH
(PCH)
SYNCHRONOUS
RECTIFIER
(NCH)
MP2104_BD01
Figure 2—Functional Block Diagram (MP2104DJ-1.5 / MP2104DJ-1.8)
Current Mode PWM Control
Slope compensated current mode PWM control
provides stable switching and cycle-by-cycle
current limit for superior load and line response
and protection of the internal main switch and
synchronous rectifier. The MP2104 switches at a
constant frequency (1.7MHz) and regulates the
output voltage. During each cycle the PWM
comparator modulates the power transferred to the
load by changing the inductor peak current based
on the feedback error voltage. During normal
operation, the main switch is turned on for a certain
time to ramp the inductor current at each rising
edge of the internal oscillator, and switched off
when the peak inductor current is above the error
voltage. When the main switch is off, the
synchronous rectifier will be turned on immediately
and stay on until either the next cycle starts.
Dropout Operation
The MP2104 allows the main switch to remain on
for more than one switching cycle and increases
the duty cycle while the input voltage is dropping
close to the output voltage. When the duty cycle
reaches 100%, the main switch is held on
continuously to deliver current to the output up to
the PFET current limit. The output voltage then is
the input voltage minus the voltage drop across
the main switch and the inductor.
Short Circuit Protection
The MP2104 has short circuit protection. When
the output is shorted to ground, the oscillator
frequency is reduced to prevent the inductor
current from increasing beyond the PFET current
limit. The PFET current limit is also reduced to
lower the short circuit current. The frequency and
current limit will return to the normal values once
the short circuit condition is removed and the
feedback voltage reaches 0.6V.
Maximum Load current
The MP2104 can operate down to 2.5V input
voltage, however the maximum load current
decreases at lower input due to large IR drop on
the main switch and synchronous rectifier. The
slope compensation signal reduces the peak
inductor current as a function of the duty cycle to
prevent sub-harmonic oscillations at duty cycles
greater than 50%. Conversely the current limit
increases as the duty cycle decreases.
相關PDF資料 |
PDF描述 |
|---|---|
| LC70A | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC10 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC10A | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC11 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
| LC9.0 | 1500 WATT LOW CAPACITANCE TRANSIENT VOLTAGE SUPPRESSOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LBC2518T100 | 制造商:TAIYO-YUDEN 制造商全稱:Taiyo Yuden (U.S.A.), Inc 功能描述:WOUND CHIP INDUCTORS |
| LBC2518T100K | 功能描述:固定電感器 INDCTR HI CUR WND 1007 10uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LBC2518T100KV | 功能描述:10μH Unshielded Wirewound Inductor 375mA 360 mOhm Nonstandard 制造商:taiyo yuden 系列:LB 包裝:剪切帶（CT） 零件狀態:有效 類型:繞線 材料 - 磁芯:- 電感:10μH 容差:±10% 額定電流:375mA 電流 - 飽和值:- 屏蔽:無屏蔽 DC 電阻（DCR）:360 毫歐 不同頻率時的 Q 值:- 頻率 - 自諧振:30MHz 等級:AEC-Q200 工作溫度:-40°C ~ 105°C 頻率 - 測試:2.52MHz 安裝類型:表面貼裝 封裝/外殼:非標準 大小/尺寸:0.098" 長 x 0.071" 寬（2.50mm x 1.80mm） 高度 - 安裝（最大值）:0.079"（2.00mm） 標準包裝:1 |
| LBC2518T100M | 功能描述:固定電感器 INDCTR HI CUR WND 1007 10uH 20% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LBC2518-T100MK | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:Surface Mount Ferrite Products |
發布緊急采購，3分鐘左右您將得到回復。