參數資料
型號： L8708H
廠商： ZiLOG, Inc.
英文描述： IR/Low-Voltage Microcontroller
中文描述： 紅外/低電壓微控制器
文件頁數： 50/66頁
文件大?。?/td> 599K
代理商： L8708H
Z86L88/81/86/87/89/73
IR/Low-Voltage Microcontroller
50
P R E L I M I N A R Y
DS96LV00800
SCLK/TCLK Divide-by-16 Select
(D0). D0 of the SMR
controls a Divide-by-16 prescaler of SCLK/TCLK. The pur-
pose of this control is to selectively reduce device power
consumption during normal processor execution (SCLK
control) and/or HALT mode (where TCLK sources interrupt
logic). After Stop-Mode Recovery, this bit is set to a 0.
Stop-Mode Recovery Source
(D2, D3, and D4). These
three bits of the SMR specify the wake up source of the
STOP recovery (Figure 41 and Table 7).
Note:
Any Port 2 bit defined as an output will drive the cor-
responding input to the default state to allow the remaining
inputs to control the AND/OR function. Refer to SMR2 reg-
ister for other recover sources.
Stop-Mode Recovery Delay Select
(D5). This bit, if low,
disables the 5 ms /RESET delay after Stop-Mode Recov-
ery. The default configuration of this bit is one. If the "fast"
wake up is selected, the Stop-Mode Recovery source
needs to be kept active for at least 5TpC.
Stop-Mode Recovery Edge Select
(D6). A 1 in this bit po-
sition indicates that a High level on any one of the recovery
sources wakes the Z86LXX from STOP mode. A 0 indi-
cates Low level recovery. The default is 0 on POR (Figure
36).
Cold or Warm Start
(D7). This bit is set by the device
upon entering STOP mode. It is a Read Only Flag bit. A 1
in D7 (warm) indicates that the device will awaken from a
SMR source or a WDT while in STOP mode. A 0 in this bit
(cold) indicates that the device will be reset by a POR,
WDT while not in STOP, or the device awakened from a
low voltage standby mode.
Stop-Mode Recovery Register 2
(SMR2). This register
determines the mode of Stop-Mode Recovery for SMR2
Figure 42).
If SMR2 is used in conjunction with SMR, either of the
specified events will cause a Stop-Mode Recovery.
Note:
Port pins configured as outputs are ignored as a
SMR or SMR2 recovery source. For example, if the NAND
or P23-P20 is selected as the recovery source and P20 is
configured as an output then the remaining SMR pins
(P23-P21) form the NAND equation.
Table 7. Stop-Mode Recovery Source
SMR:432
Operation
Description of Action
Description of Action
D4
0
D3
0
D2
0
POR and/or external reset
recovery
Reserved
P31 transition
P32 transition
P33 transition
P27 transition
Logical NOR of P20
through P23
Logical NOR of P20
through P27
0
0
0
1
1
1
0
1
1
0
0
1
1
0
1
0
1
0
1
1
1
相關PDF資料
PDF描述
L88M09T 3.3 to 12 V, 0.5 A Low Dropout Voltage Regulator
L88MS08T 8V 0.5A Low Dropout Voltage Regulators with On/Off Function(輸出電壓為8V，輸出電流為500mA的低壓差電源穩壓器（帶輸出電壓控制的開/關功能）)
L88MS33T 3.3V 0.5A Low Dropout Voltage Regulators with On/Off Function(輸出電壓為3.3V，輸出電流為500mA的低壓差電源穩壓器（帶輸出電壓控制的開/關功能）)
L88R05 5V, 1A Voltage-regulator ICs with Reset Function
L88R05C 5V, 1A Voltage-regulator ICs with Reset Function
相關代理商/技術參數
參數描述
L8711P 制造商:POLYFET 制造商全稱:Polyfet RF Devices 功能描述:SILICON GATE ENHANCEMENT MODE RF POWER LDMOS TRANSISTOR
L8712(FECONLY) 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC TUBE FOR TO-220 508MM
L871E 制造商:VERMASON 功能描述:END PLUG TO-220 TUBE
L87207304 制造商:Molex 功能描述:
L8721 制造商:Leviton Manufacturing Co 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*