參數資料
型號: L8708H
廠商: ZiLOG, Inc.
英文描述: IR/Low-Voltage Microcontroller
中文描述: 紅外/低電壓微控制器
文件頁數: 22/66頁
文件大?。?/td> 599K
代理商: L8708H
Z86L88/81/86/87/89/73
IR/Low-Voltage Microcontroller
22
P R E L I M I N A R Y
DS96LV00800
PIN FUNCTIONS
(Continued)
Port 3
(P37-P31). Port 3 is a 7-bit, CMOS compatible three
fixed input and four fixed output port. Port 3 consists of
three fixed input (P33-P31) and four fixed output (P37-
P34), and can be configured under software control for In-
put/Output, Interrupt, Port handshake, Data Memory func-
tions and output from the counter/timers. P31, P32, and
P33 are standard CMOS inputs; outputs are push-pull.
Two on-board comparators process analog signals on P31
and P32 with reference to the voltage on Pref1 and P33.
The analog function is enabled by programming the Port 3
Mode Register (bit 1). P31 and P32 are programmable as
rising, falling, or both edge triggered interrupts (IRQ regis-
ter bits 6 and 7). Pref1 and P33 are the comparator refer-
ence voltage inputs. Access to the Counter Timer edge de-
tection circuit is through P31 or P20 (see CTR1
description). Other edge detect and IRQ modes are de-
scribed in Tables (3-6). Handshake lines Ports 0, 1, and 2
are available on P31 through P36.
Port 3 provides the following control functions: handshake
for Ports 0, 1, and 2 (/DAV and RDY); three external inter-
rupt request signals (IRQ2-IRQ0); Data Memory Select
(/DM) (Table 3).
Port 3 also provides output for each of the counter/timers
and the AND/OR Logic. Control is performed by program-
ming bits D5-D4 of CTR1, bit 0 of CTR0 and bit 0 of CTR2.
Comparator Inputs
.
In Analog Mode, Port 3 (P31 and
P32) have a comparator front end. The comparator refer-
ence is supplied to P33 and Pref1. In this mode, the P33
internal data latch and its corresponding IRQ1 is diverted
to the SMR sources (excluding P31,P32, and P33) as
shown in figure 41. In digital mode, P33 is used as D3 of
the Port 3 input register which then generates IRQ1 as
shown in Figure 17.
When P31 is used for counter timer input (demodulation
mode), input is always taken from the P31 digital input
buffer whether or not analog mode is enabled).
Notes:
Comparators are powered down by entering STOP
mode. For P31-P33 to be used in a Stop-Mode Recovery
source, these inputs must be placed into digital mode.
Comparator Outputs
.
These may be programmed to be
outputted on P34 and P37 through the PCON register (Fig-
ures 16,38).
/RESET
(Input, active Low). Initializes the MCU. Reset is
accomplished either through Power-On, Watch-Dog Tim-
er, Stop-Mode Recovery, Low Voltage detection, or exter-
nal reset. During Power-On Reset and Watch-Dog Timer
Reset, the internally generated reset drives the reset pin
Low for the POR time. Any devices driving the external re-
set line should be open-drain in order to avoid damage
from a possible conflict during reset conditions. Pull-up is
provided internally.
Table 3. Pin Assignments
Pin
Pref1
P31
P32
P33
P34
P35
P36
P37
P20
I/O
IN
IN
IN
IN
OUT
OUT
OUT
OUT
I/O
C/T
Comp.
RF1
AN1
AN2
RF2
AO1
Int.
P0 HS
P1 HS
P2 HS
Ext
IN
IRQ2
IRQ0
IRQ1
D/R
D/R
D/R
R/D
T8
T16
T8/16
DM
R/D
R/D
AO2
IN
Notes:
D = /DAV
R = RDY
HS = Handshake Signals
相關PDF資料
PDF描述
L88M09T 3.3 to 12 V, 0.5 A Low Dropout Voltage Regulator
L88MS08T 8V 0.5A Low Dropout Voltage Regulators with On/Off Function(輸出電壓為8V,輸出電流為500mA的低壓差電源穩(wěn)壓器(帶輸出電壓控制的開/關功能))
L88MS33T 3.3V 0.5A Low Dropout Voltage Regulators with On/Off Function(輸出電壓為3.3V,輸出電流為500mA的低壓差電源穩(wěn)壓器(帶輸出電壓控制的開/關功能))
L88R05 5V, 1A Voltage-regulator ICs with Reset Function
L88R05C 5V, 1A Voltage-regulator ICs with Reset Function
相關代理商/技術參數
參數描述
L8711P 制造商:POLYFET 制造商全稱:Polyfet RF Devices 功能描述:SILICON GATE ENHANCEMENT MODE RF POWER LDMOS TRANSISTOR
L8712(FECONLY) 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC TUBE FOR TO-220 508MM
L871E 制造商:VERMASON 功能描述:END PLUG TO-220 TUBE
L87207304 制造商:Molex 功能描述:
L8721 制造商:Leviton Manufacturing Co 功能描述: