參數資料
型號： L7585F
英文描述： Full-Feature,Low-Power SLIC and Switch
中文描述： 全功能，低功耗SLIC和開關
文件頁數： 19/22頁
文件大?。?/td> 441K
代理商： L7585F
Agere Communications Inc.
19
Data Sheet
September 2001
L7585F Full-Feature, Low-Power SLIC and Switch
Applications
(continued)
Ring Trip
Ring trip is set by the value of RS1.
The ring trip threshold at the ring trip inputs is
±2.5 V
minimum, ±3.5 V maximum.
A resistor value of 500
, as shown in Figure 4, will set
the ring trip current threshold to ±6.0 mA typical.
Ring trip is asserted upon entering the ringing mode
until the second zero crossing of ringing. This is either
a positive-going zero crossing between –40 V and
–30 V at –50 V V
BAT
) or a negative-going zero crossing
(between –10 V and –20 V at –50 V V
BAT
). The different
threshold for positive-going and negative-going zero
crossings is the result of hysteresis of approximately
20 V.
Ring trip will not be asserted unless the ring trip thresh-
old is exceeded for two zero crossings. This is either a
positive-going zero crossing between –40 V and –30 V
at –50 V V
BAT
) or a negative-going zero crossing
(between –10 V and –20 V at –50 V V
BAT
). The different
threshold for positive-going and negative-going zero
crossings is the result of hysteresis of approximately
20 V.
Note that since the ringing voltage is monitored at
RSW, one zero crossing can occur at switch turn-on
depending on initial conditions.
Ring trip is asserted immediately if the ring trip input is
15 V ± 3 V.
False On-Hook Transients
I
If the L7585F is off-hook in the ground-start/tip open
state, the ground-start/tip ground state, or the
ground-start/tip amplifier state, due to an applied ring
ground, and it is switched to the forward battery
active state, it will not generate a false on-hook
longer than 10 ms in duration. This applies for loop
resistances of 0
to 2000
,
providing that all of the
following criteria are satisfied:
— A loop closure is applied before the L7585F
switches to the forward battery active state.
— The loop closure resistance (telephone set) is less
than 430
.
— The ring ground and loop closure are applied at
the same end of the loop.
— If the ring ground is removed while the L7585F is
in the forward battery active state, then the ring
ground resistance must be greater than 225
when the dc current limit is 40 mA, or greater than
430
when the dc current is 28 mA.
相關PDF資料
PDF描述
L7585G Full-Feature,Low-Power SLIC and Switch
L7590C CAP CER 10PF 100V C0G 0603
L7591 Subscriber Line Interface Circuit Protector
L77-100 Logic IC
L77-101 Logic IC
相關代理商/技術參數
參數描述
L7585G 制造商:AGERE 制造商全稱:AGERE 功能描述:Full-Feature,Low-Power SLIC and Switch
L7590 制造商:Bahco 功能描述:PLIER ROUND NOSE 121MM 制造商:Bahco 功能描述:PLIER, ROUND NOSE 121MM
L7590C 制造商:AGERE 制造商全稱:AGERE 功能描述:Telephone Ringing Driver
L7590CAE 制造商:Alcatel-Lucent 功能描述:7590CAE
L7591 制造商:AGERE 制造商全稱:AGERE 功能描述:Subscriber Line Interface Circuit Protector
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*