參數資料
型號: L6591TR
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, PDSO16
封裝: ROHS COMPLIANT, SOP-16
文件頁數: 9/32頁
文件大小: 560K
代理商: L6591TR
L6591
Application information
Doc ID 14821 Rev 4
17/32
Figure 10.
How the L6591 can switch off a PFC controller at light load
5.3
PWM control block
The device is specific for secondary feedback. Typically, there is a TL431 at the secondary
side and an optocoupler that transfers output voltage information to the PWM control at the
primary side, crossing the isolation barrier. The PWM control input (pin #7, COMP) is driven
directly by the phototransistor’s collector (the emitter is grounded) to modulate the duty
cycle. It is recommended to place a small filter capacitor between the pin and GND (#11), as
close to the IC as possible to reduce switching noise pick up, to set a pole in the output-to-
control transfer function.
5.4
PWM comparator, PWM latch and hiccup-mode OCP
The PWM comparator senses the voltage across the current sense resistor (Rs) and, by
comparing it with the programming signal derived by the voltage on pin COMP (#7),
determines the exact time when the high-side MOSFET is to be switched off. The PWM
latch avoids spurious switching, which might be caused by the noise generated (“double-
pulse suppression”).
A second comparator senses the voltage on the current sense input and shuts the IC down
if the voltage at the pin exceeds 1.5 V. Such an anomalous condition is typically generated
by either a short circuit of one of the secondary rectifiers or a shorted secondary winding or
a saturated transformer. This condition is latched as long as the IC is supplied; hence if the
IC is supplied by an external source it is necessary to disconnect the source to restart the
IC.
To distinguish an actual malfunction from a disturbance (e.g. induced during ESD tests), the
first time the comparator is tripped the protection circuit enters a “warning state”. If in the
next switching cycle the comparator is not tripped, a temporary disturbance is assumed and
the protection logic will be reset in its idle state; if the comparator will be tripped again a real
malfunction is assumed and the L6591 will be stopped.
If the device is self-supplied no energy is coming from the self-supply circuit, then the
voltage on the Vcc capacitor will decay and cross the UVLO threshold after some time,
which clears the latch. The internal start-up generator is still off, then the Vcc voltage still
needs to go below its restart voltage before the Vcc capacitor is charged again and the IC
restarted. Ultimately, either of the above mentioned failures will result in a low-frequency
intermittent operation (Hiccup-mode operation), with very low stress on the power circuit.
The timing diagram of Figure 11 illustrates this operation.
L6591
PFC_STOP
8
L6562
6
Vref
ZCD
5.6 k
47 k
BC547
B C547
L6591
PFC_STOP
8
L6563
PFC_OK
(AC_OK)
L6591
PFC_STOP
8
L6562
6
Vref
ZCD
5.6 k
47 k
BC547
B C547
L6591
PFC_STOP
8
L6563
PFC_OK
(AC_OK)
相關PDF資料
PDF描述
L6599AN SWITCHING CONTROLLER, DIP16
L6599ATDTR SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
L6599D 0.8 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
L6599N 0.8 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP16
L6599TR 0.8 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
L6598 功能描述:PMIC 解決方案 High Volt Reson Cont RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
L6598_04 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HIGH VOLTAGE RESONANT CONTROLLER
L6598D 功能描述:PMIC 解決方案 High Volt Reson Cont RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
L6598D013TR 功能描述:PMIC 解決方案 High Volt Reson Cont RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
L6598D016TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High voltage resonant controller