FN6148.5 September 21, 2010 SOG Slicer The SOG input has programmable threshold, 40mV of hysteresis, and an optional low pass filter tha" />
參數資料
型號: ISL98001CQZ-210
廠商: Intersil
文件頁數: 17/31頁
文件大?。?/td> 0K
描述: IC TRPL VIDEO DIGITIZER 128-MQFP
標準包裝: 660
類型: 視頻數字轉換器
應用: 數字電視,顯示器,數字 KVM,圖形處理
安裝類型: 表面貼裝
封裝/外殼: 128-BFQFP
供應商設備封裝: 128-MQFP(14x20)
包裝: 托盤
24
FN6148.5
September 21, 2010
SOG Slicer
The SOG input has programmable threshold, 40mV of
hysteresis, and an optional low pass filter that can be used to
remove high frequency video spikes (generated by overzealous
video peaking in a DVD player, for example) that can cause
false SOG triggers. The SOG threshold sets the comparator
threshold relative to the sync tip (the bottom of the SOG pulse).
SYNC Status and Polarity Detection
The SYNC Status register (0x01) and the SYNC Polarity
register (0x02) continuously monitor all 6 sync inputs
(VSYNCIN, HSYNCIN, and SOGIN for each of 2 channels)
and report their status. However, accurate sync activity
detection is always a challenge. Noise and repetitive video
patterns on the Green channel may look like SOG activity
when there actually is no SOG signal, while non-standard
SOG signals and trilevel sync signals may have amplitudes
below the default SOG slicer levels and not be easily
detected. As a consequence, not all of the activity detect bits
in the ISL98001 are correct under all conditions.
Table 7 shows how to use the SYNC Status register (0x01)
to identify the presence of and type of a sync source. The
firmware should go through the table in the order shown,
stopping at the first entry that matches the activity indicators
in the SYNC Status register.
Final validation of composite sync sources (SOG or
Composite sync on HSYNC) should be done by setting the
Input Configuration register (0x05) to the composite sync
source determined by this table, and confirming that the
CSYNC detect bit is set.
The accuracy of the Trilevel Sync detect bit can be increased
by multiple reads of the Trilevel Sync detect bit. See the
Trilevel Sync Detect section for more details.
For best SOG operation, the SOG low pass filter (register
0x04[4] should always be enabled to reject the high
frequency peaking often seen on video signals.
HSYNC and VSYNC Activity Detect
Activity on these bits always indicates valid sync pulses, so
they should have the highest priority and be used even if the
SOG activity bit is also set.
SOG Activity Detect
The SOG activity detect bit monitors the output of the SOG
slicer, looking for 64 consecutive pulses with the same period
and duty cycle. If there is no signal on the Green (or Y)
channel, the SOG slicer will clamp the video to a DC level and
will reject any sporadic noise. There should be no false
positive SOG detects if there is no video on Green (or Y).
If there is video on Green (or Y) with no valid SOG signal,
the SOG activity detect bit may sometimes report false
positives (it will detect SOG when no SOG is actually
present). This is due to the presence of video with a
repetitive pattern that creates a waveform similar to SOG.
For example, the desktop of a PC operating system is black
during the front porch, horizontal sync, and back porch, then
increases to a larger value for the video portion of the
screen. This creates a repetitive video waveform very similar
to SOG that may falsely trigger the SOG Activity detect bit.
However, in these cases where there is active video without
SOG, the SYNC information will be provided either as
separate H and V sync on HSYNCIN and VSYNCIN, or
composite sync on HSYNCIN. HSYNCIN and VSYNCIN
should therefore be used to qualify SOG. The SOG Active bit
should only be considered valid if HSYNC Activity
Detect = 0. Note: Some pattern generators can output
HSYNC and SOG simultaneously, in which case both the
HSYNC and the SOG activity bits will be set, and valid. Even
in this case, however, the monitor should still choose
HSYNC over SOG.
TriLevel Sync Detect
Unlike SOG detect, the TriLevel Sync detect function does
not check for 64 consecutive trilevel pulses in a row, and is
therefore less robust than the SOG detect function. It will
report false positives for SOG-less video for the same
reasons the SOG activity detect does, and should therefore
be qualified with both HSYNC and SOG. TriLevel Sync
Detect should only be considered valid if HSYNC Activity
Detect = 0 and SOG Activity Detect = 1.
If there is a SOG signal, the TriLevel Detect bit will operate
correctly for standard trilevel sync levels (600mVP-P). In
some real-world situations, the peak-to-peak sync amplitude
TABLE 7. SYNC SOURCE DETECTION TABLE
HSYNC
DETECT
VSYNC
DETECT
SOG
DETECT
TRILEVEL
DETECT
RESULT
1
X
Sync is on HSYNC and VSYNC
1
0
X
Sync is composite sync on HSYNC. Set Input configuration register to CSYNC on
HSYNC and confirm that CSYNC detect bit is set.
0
1
0
Sync is composite sync on SOG. It is possible that trilevel sync is present but amplitude
is too low to set trilevel detect bit. Use video mode table to determine if this video mode
is likely to have trilevel sync, and set clamp start, width values appropriately if it is.
0
1
Sync is composite sync on SOG. Sync is likely to be trilevel.
0
X
No valid sync sources on any input.
ISL98001
相關PDF資料
PDF描述
ISL59921IRZ IC ANLG VID LINE TRPL 20-QFN
C091 31K107 100 2 CONN CIR MALE 7POS R/A CABLE
A3FBAU CONN PLUG CORD FMAL 3PIN BLK/AU
PX0921/03/S CONN RCPT 3POS W/SOCKET
09CL4M CONN DIN MALE PLUG 4POS STR
相關代理商/技術參數
參數描述
ISL98001CQZ-240 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話,手機,視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064
ISL98001CQZ-275 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話,手機,視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064
ISL98001CQZ-EVALZ 功能描述:EVALUATION BOARD ISL98001CQZ RoHS:是 類別:編程器,開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口,收發器,PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板
ISL98001CQZ-R5296 制造商:Intersil Corporation 功能描述:ISL98001CQZ PB-FREE TRIPLE VIDEO DIGITIZER W/ DIGITAL PLL, T - Trays
ISL98001IQZ-140 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 標準包裝:250 系列:- 類型:電平移位器 應用:LCD 電視機/監控器 安裝類型:表面貼裝 封裝/外殼:28-WFQFN 裸露焊盤 供應商設備封裝:28-WQFN(4x4)裸露焊盤 包裝:帶卷 (TR) 其它名稱:296-32523-2TPS65198RUYT-ND