參數資料
| 型號： | ISL90843WIU1027Z-TK |
| 廠商： | Intersil |
| 文件頁數： | 8/10頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC XDCP 256-TAP 10OHM 10-MSOP |
| 標準包裝： | 1,000 |
| 系列： | XDCP™ |
| 接片： | 256 |
| 電阻（歐姆）： | 10k |
| 電路數： | 4 |
| 存儲器類型： | 易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
7
FN8095.2
March 29, 2006
Principles of Operation
The ISL90843 is an integrated circuit incorporating four
DCPs with their associated registers, and an I2C serial
interface providing direct communication between a host
and the potentiometers.
DCP Description
Each DCP is implemented with a combination of resistor
elements and CMOS switches. The physical ends of each
DCP are equivalent to the fixed terminals of a mechanical
potentiometer (RH and RL pins). The RW pin of each DCP is
connected to intermediate nodes, and is equivalent to the
wiper terminal of a mechanical potentiometer. The position
of the wiper terminal within the DCP is controlled by an 8-bit
volatile Wiper Register (WR). Each DCP has its own WR.
When the WR of a DCP contains all zeroes (WR<7:0>: 00h),
its wiper terminal (RW) is closest to its “Low” terminal (RL).
When the WR of a DCP contains all ones (WR<7:0>: FFh),
its wiper terminal (RW) is closest to its “High” terminal (RH).
As the value of the WR increases from all zeroes (00h) to all
ones (255 decimal), the wiper moves monotonically from the
position closest to RL to the closest to RH. At the same time,
the resistance between RW and RL increases monotonically,
while the resistance between RH and RW decreases
monotonically.
While the ISL90843 is being powered up, all four WRs are
reset to 80h (128 decimal), which locates RW roughly at the
center between RL and RH.
The WRs can be read or written directly using the I2C serial
interface as described in the following sections. The I2C
interface Address Byte has to be set to 00hex, 01hex,
02hex, and 03hex to access the WR of DCP0, DCP1, DCP2,
and DCP3 respectively.
I2C Serial Interface
The ISL90843 supports a bidirectional bus oriented protocol.
The protocol defines any device that sends data onto the
FIGURE 7. END TO END RTOTAL % CHANGE vs
TEMPERATURE
FIGURE 8. TC FOR VOLTAGE DIVIDER MODE IN ppm
FIGURE 9. MIDSCALE GLITCH, CODE 80h TO 7Fh (WIPER 0)
FIGURE 10. LARGE SIGNAL SETTLING TIME
Typical Performance Curves (Continued)
-1.50
-1.00
-0.50
0.00
0.50
1.00
1.50
-40
-20
0
204060
80
TEMPERATURE (°C)
END
TO
E
N
D
R
TOTA
L
CHANGE
(%)
5.5V
2.7V
-20
-10
0
10
20
32
82
132
182
232
TAP POSITION (DECIMAL)
TC
(ppm
/°C)
Wiper Movement Mid Point
From 80h to 7fh
Signal at Wiper (Wiper Unloaded)
SCL
Signal at Wiper
(Wiper Unloaded Movement
From ffh to 00h)
ISL90843
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J1M-MZ-F1 | CONVERTER MINIMOD DC/DC 10V 25W |
| 74VHCT138ASJ | DECODER/DEMUX 3-TO-8 16SOP |
| MK3721DTR | IC VCXO DTV/SET-TOP 8-SOIC |
| MK3711DMLFTR | IC VCXO DTV/SET-TOP 8-SOIC |
| ICS501AMILFT | IC PLL CLK MULTIPLIER 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL9103 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:500mA 2.4MHz Low IQ High Efficiency Synchronous Buck Converter |
| ISL9103A | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:500mA 2.4MHz Low IQ High Efficiency Synchronous Buck Converter |
| ISL9103AIRUAZ-T | 功能描述:IC REG BUCK SYNC ADJ 0.5A 6UTDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz，1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 包裝:管件 供應商設備封裝:8-MSOP |
| ISL9103AIRUBZ-T | 功能描述:IC REG BUCK SYNC 1.5V .5A 6UTDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz，1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 包裝:管件 供應商設備封裝:8-MSOP |
| ISL9103AIRUCZ-T | 功能描述:IC REG BUCK SYNC 1.8V .5A 6UTDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz，1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 包裝:管件 供應商設備封裝:8-MSOP |
發布緊急采購，3分鐘左右您將得到回復。