- 您現在的位置：買賣IC網 > PDF目錄384528 > ISL6753AAZA-T (INTERSIL CORP) ZVS Full-Bridge PWM Controller PDF資料下載
參數資料
| 型號： | ISL6753AAZA-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | ZVS Full-Bridge PWM Controller |
| 中文描述： | 0.1 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, ROHS COMPLIANT, PLASTIC, QSOP-16 |
| 文件頁數： | 14/15頁 |
| 文件大小： | 465K |
| 代理商： | ISL6753AAZA-T |
14
FN9182.1
March 10, 2005
RESDEL is set properly, switch LL will be turned on at this
time.
The second power transfer period commences when switch
LL closes. With switches UR and LL on, the primary and
secondary currents flow as indicated below.
The UR - LL power transfer period terminates when switch
LL turns off as determined by the PWM. The current flowing
in the primary must find an alternate path. The current flows
into the parasitic switch capacitance which charges the node
to VIN and then forward biases the body diode of upper
switch UL. The primary leakage inductance, L
L
, maintains
the current, which now circulates around the path of switch
UR, the transformer primary, and switch UL. When switch LL
opens, the output inductor current free-wheels through both
output diodes, D1 and D2. This condition persists through
the remainder of the half-cycle.
When the upper switches toggle, the primary current that
was flowing through UR must find an alternate path. It
charges/discharges the parasitic capacitance of switches UR
and LR until the body diode of LR is forward biased. If
RESDEL is set properly, switch LR will be turned on at this
time.
The first power transfer period commences when switch LR
closes and the cycle repeats. The ZVS transition requires
that the leakage inductance has sufficient energy stored to
fully charge the parasitic capacitances. Since the energy
stored is proportional to the square of the current (1/2 L
L
I
P2
,
the ZVS resonant transition is load dependent. If the leakage
inductance is not able to store sufficient energy for ZVS, a
discrete inductor may be added in series with the
transformer primary.
Fault Conditions
A fault condition occurs if VREF or VDD fall below their
undervoltage lockout (UVLO) thresholds or if the thermal
protection is triggered. When a fault is detected, the soft-
start capacitor is quickly discharged, and the outputs are
disabled low. When the fault condition clears and the soft-
start voltage is below the reset threshold, a soft-start cycle
begins.
An overcurrent condition is not considered a fault and does
not result in a shutdown.
Thermal Protection
Internal die over temperature protection is provided. An
integrated temperature sensor protects the device should
the junction temperature exceed 140°C. There is
approximately 15°C of hysteresis.
Ground Plane Requirements
Careful layout is essential for satisfactory operation of the
device. A good ground plane must be employed. VDD and
VREF should be bypassed directly to GND with good high
frequency capacitance.
References
[1] Ridley, R., “A New Continuous-Time Model for Current
Mode Control”, IEEE Transactions on Power
Electronics, Vol. 6, No. 2, April 1991.
VIN+
VIN-
UL
LL
UR
LR
VOUT+
RTN
L
L
D2
D1
I
S
I
P
FIGURE 13. UPPER SWITCH TOGGLE AND RESONANT
TRANSITION
VIN+
VIN-
UL
LL
UR
LR
VOUT+
RTN
L
L
D2
D1
FIGURE 14. UR - LL POWER TRANSFER
FIGURE 15. UR - UL FREE-WHEELING PERIOD
VIN+
VIN-
UL
LL
UR
LR
VOUT+
RTN
I
P
I
S
L
L
D2
D1
VIN+
VIN-
UL
LL
UR
LR
VOUT+
RTN
I
P
I
S
L
L
D2
D1
FIGURE 16. UPPER SWITCH TOGGLE AND RESONANT
TRANSITION
ISL6753
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6753AAZA | Octal Buffers/Drivers With 3-State Outputs 20-SO -40 to 85 |
| ISL6801AB | High Voltage Bootstrap High Side Driver |
| ISL6801AB-T | High Voltage Bootstrap High Side Driver |
| ISL6801 | Octal Buffers/Drivers With 3-State Outputs 20-SO -40 to 85 |
| ISL7124SRHQF | 1.0 Amp Power Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6754AAZA | 功能描述:IC REG CTRLR PWM CM/VM 20-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6754AAZA-T | 功能描述:IC REG CTRLR PWM CM/VM 20-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6754DBEVAL1Z | 功能描述:BOARD DEMO FOR ISL6754 RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:* 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓?fù)浣Y(jié)構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
| ISL6755AAZA | 功能描述:IC REG CTRLR PWM CM/VM 20-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6755AAZA-T | 功能描述:IC REG CTRLR PWM CM/VM 20-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。