參數資料
型號: ISL6745
廠商: Intersil Corporation
英文描述: Octal Buffers/Drivers With 3-State Outputs 20-SOIC -40 to 85
中文描述: 橋控制器精密死區時間控制
文件頁數: 7/8頁
文件大小: 226K
代理商: ISL6745
7
variation in dV with R
TD
(Figure 5), and in charge current
(Figure 4), results from Equation 2 would differ from the
calculated frequency. The typical performance curves may
be used as a tool along with the previous equations as a
more accurate tool to estimate the operating frequency more
accurately.
The maximum duty cycle, D, and deadtime, DT, can be
calculated from:
Soft-Start Operation
The ISL6745 features a soft-start using an external capacitor
in conjunction with an internal current source. Soft-start
reduces stresses and surge currents during start-up.
The oscillator capacitor signal, C
T
, is compared to the soft-
start voltage, SS, in the SS comparator which drives the
PWM latch. While the SS voltage is less than 3.5V, duty
cycle is limited. The output pulse width increases as the soft-
start capacitor voltage increases up to 3.5V. This has the
effect of increasing the duty cycle from zero to the maximum
pulse width during the soft-start period. When the soft-start
voltage exceeds 3.5V, soft-start is completed. Soft-start
occurs during start-up and after recovery from an overcurrent
shutdown. The soft-start voltage is clamped to 4V.
Gate Drive
The ISL6745 is capable of sourcing and sinking 1A peak
current, and may also be used in conjunction with a
MOSFET driver such as the ISL6700 for level shifting. To
limit the peak current through the IC, an external resistor
may be placed between the totem-pole output of the IC
(OUTA or OUTB pin) and the gate of the MOSFET. This
small series resistor also damps any oscillations caused by
the resonant tank of the parasitic inductances in the traces of
the board and the FET’s input capacitance.
Overcurrent Operation
Overcurrent delayed shutdown is enabled once the soft-start
cycle is complete. If an overcurrent condition is detected, the
soft-start charging current source is disabled and the soft-
start capacitor is allowed to discharge through a 15μA
source. At the same time a 50μs retriggerable one-shot timer
is activated. It remains active for 50μs after the overcurrent
condition ceases. If the soft-start capacitor discharges to
3.9V, the output is disabled. This state continues until the
soft-start voltage reaches 270mV, at which time a new soft-
start cycle is initiated. If the overcurrent condition stops at
least 50μs prior to the soft-start voltage reaching 3.9V, the
soft-start charging currents revert to normal operation and
the soft-start voltage is allowed to recover.
Thermal Protection
An internal temperature sensor protects the device should
the junction temperature exceed 145°C. There is
approximately 15°C of hysteresis.
Ground Plane Requirements
Careful layout is essential for satisfactory operation of the
device. A good ground plane must be employed. V
DD
should
be bypassed directly to GND with good high frequency
capacitance.
D
T
C
T
OSC
=
(EQ. 5)
DT
1
D
(
)
T
OSC
=
s
(EQ. 6)
ISL6745
相關PDF資料
PDF描述
ISL6752 Octal Buffers/Drivers With 3-State Outputs 20-PDIP -40 to 85
ISL6752AAZA-T ZVS Full-Bridge Current-Mode PWM with Adjustable Synchronous Rectifier Control
ISL6752AAZA Octal Buffers/Drivers With 3-State Outputs 20-PDIP -40 to 85
ISL6753 Octal Buffers/Drivers With 3-State Outputs 20-SO -40 to 85
ISL6753AAZA-T ZVS Full-Bridge PWM Controller
相關代理商/技術參數
參數描述
ISL6745AAUZ 功能描述:IC REG CTRLR PWM VM 10-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)
ISL6745AAUZ-T 功能描述:IC REG CTRLR PWM VM 10-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)
ISL6745AAUZ-TS2712 功能描述:IC REG CTRLR PWM VM 10-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)
ISL6745ALEVAL3Z 功能描述:EVAL BOARD 3 FOR ISL6745 RoHS:是 類別:編程器,開發系統 >> 評估板 - DC/DC 與 AC/DC(離線)SMPS 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC,步升 輸出及類型:1,非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
ISL6745AU 功能描述:IC REG CTRLR PWM VM 10-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP(0.300",7.62mm) 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)