- 您現在的位置：買賣IC網 > PDF目錄384522 > ISL5585GCRZ (INTERSIL CORP) 3.3V Ringing SLIC Family for Voice Over Broadband (VOB) PDF資料下載
參數資料
| 型號： | ISL5585GCRZ |
| 廠商： | INTERSIL CORP |
| 元件分類： | 模擬傳輸電路 |
| 英文描述： | 3.3V Ringing SLIC Family for Voice Over Broadband (VOB) |
| 中文描述： | TELECOM-SLIC, PQCC32 |
| 封裝： | 7 X 7 MM, LEAD FREE, PLASTIC, MO-220VKKC, QFN-32 |
| 文件頁數： | 19/24頁 |
| 文件大?。?/td> | 455K |
| 代理商： | ISL5585GCRZ |
19
When the forward loop back mode is initiated internal
switches connect a 600
load across the outputs of the Tip
and Ring amplifiers.
DC Verification
When the internal signal path is provided, DC current will
flow from Tip to Ring. The DC current will force DET low,
indicating the presence of loop current. In addition, the ALM
output will also go low. This does not indicate a thermal
alarm condition. Rather, proper logic operation is verified in
the event of a thermal shutdown. In addition to verifying
device functionality, toggling the logic outputs verifies the
interface to the system controller.
AC Verification
The entire AC loop of the device is active during the forward
loop back mode. Therefore a 4-wire to 4-wire level test
capability is provided. Depending on the transhybrid balance
implementation, test coverage is provided by a one or two
step process.
System architectures which cannot disable the transhybrid
function would require a two step process. The first step
would be to send a test tone to the device while on hook and
not in forward loop back mode. The return signal would be
the test level times the gain R
F
/R
A
of the transhybrid
amplifier. Since the device would not be terminated,
cancellation would not occur. The second step would be to
program the device to FLB and resend the test tone. The
return signal would be much lower in amplitude than the first
step, indicating the device was active and the internal
termination attenuated the return signal. System
architectures which disable the transhybrid function would
achieve test coverage with a signal step. Once the
transhybrid function is disable, program the device for FLB
and send the test tone. The return signal level is determined
by the 4-wire to 4-wire gain of the device.
Tip Open
Overview
The tip open mode (110) is intended for compatibility for PBX
type interfaces. Used during idle line conditions, the device
does not provide transmission. Loop supervision is provided
by either the switch hook detector (E0 = 1) or the ground key
detector (E0 = 0). The ground key detector will be used in
most applications. The device may be operated from either
high or low battery.
Functionality
During tip open operation, the Tip switch is disabled and the
Ring switch is enabled. The minimum Tip impedance is
30k
. The only active path through the device will be the
Ring switch.
In keeping with the MTU characteristics of the device, Ring
will not exceed -56V when operating from the high battery.
Though MTU does not apply to tip open, safety requirements
are satisfied.
FIGURE 13. FORWARD LOOP BACK INTERNAL TERMINATION
RING AMP
TIP AMP
RING
TIP
600
ISL5585
相關PDF資料 |
PDF描述 |
|---|---|
| ISL5586 | Low Power Ringing SLIC for Home Gateways(家用網關的低功耗振鈴芯片) |
| ISL5627 | Dual 8-bit, +3.3V, 260+MSPS, High Speed D/A Converter |
| ISL5627EVAL1 | Dual 8-bit, +3.3V, 260+MSPS, High Speed D/A Converter |
| ISL5627IN | Dual 8-bit, +3.3V, 260+MSPS, High Speed D/A Converter |
| ISL5640 | Dual 8-Bit, A/D Converter with Internal Voltage Reference(雙路8位帶內部電壓基準的A/D轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL5585GCRZ-T | 制造商:Intersil Corporation 功能描述:PB-FREE RINGING SLIC W/3.3V VCC, 100V/53DB, T&R - Tape and Reel |
| ISL5585GCRZ-TK | 制造商:Intersil Corporation 功能描述:SLIC 1CH 53DB 45MA 3.3V/-18V/-24V/-28V 32QFN EP - Tape and Reel |
| ISL5585XEVAL1 | 功能描述:EVALUATION BOARD FOR ISL5585 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| ISL5586 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power Ringing SLIC for Home Gateways |
| ISL5586_04 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power Ringing SLIC for Home Gateways |
發布緊急采購，3分鐘左右您將得到回復。