- 您現在的位置：買賣IC網 > PDF目錄9423 > ISL23425WFRUZ-T7A (Intersil)IC DGTL POT DUAL 10K 16UTQFN PDF資料下載
參數資料
| 型號： | ISL23425WFRUZ-T7A |
| 廠商： | Intersil |
| 文件頁數： | 6/20頁 |
| 文件大小： | 0K |
| 描述： | IC DGTL POT DUAL 10K 16UTQFN |
| 標準包裝： | 1 |
| 系列： | XDCP™ |
| 接片： | 256 |
| 電阻（歐姆）： | 10k |
| 電路數： | 2 |
| 溫度系數： | 標準值 125 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | 4 線 SPI（芯片選擇） |
| 電源電壓： | 1.2 V ~ 5.5 V，1.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-UFQFN |
| 供應商設備封裝： | 16-UTQFN（2.6x1.8） |
| 包裝： | 標準包裝 |
| 其它名稱： | ISL23425WFRUZ-T7ADKR |
ISL23425
14
FN7873.0
June 20, 2011
When the device enters shutdown, all current DCP WR settings are
maintained. When the device exits shutdown, the wipers will
return to the previous WR settings after a short settling time
(see Figure 26).
SPI Serial Interface
The ISL23425 supports an SPI serial protocol, mode 0. The
device is accessed via the SDI input and SDO output with data
clocked in on the rising edge of SCK, and clocked out on the
falling edge of SCK. CS must be LOW during communication with
the ISL23425. The SCK and CS lines are controlled by the host or
master. The ISL23425 operates only as a slave device.
All communication over the SPI interface is conducted by
sending the MSB of each byte of data first.
Protocol Conventions
The SPI protocol contains Instruction Byte followed by one or more
Data Bytes. A valid Instruction Byte contains instruction as the three
MSBs, with the following five register address bits (see Table 3).
The next byte sent to the ISL23425 is the Data Byte.
Table 4 contains a valid instruction set for ISL23425.
If the [R4:R0] bits are zero or one, then the read or write is to the
WRi register. If the [R4:R0] are 10000, then the operation is to
the ACR.
FIGURE 26. SHUTDOWN MODE WIPER RESPONSE
POWER-UP
USER PROGRAMMED
MID SCALE = 80H
SHDN ACTIVATED
SHDN RELEASED
AFTER SHDN
W
IPE
R
VO
LT
A
G
E,
V
RW
(V
)
SHDN MODE
TIME (s)
WIPER RESTORE TO
THE ORIGINAL POSITION
0
TABLE 3. INSTRUCTION BYTE FORMAT
BIT #
7
654321
0
I2
I1
I0
R4
R3
R2
R1
R0
TABLE 4. INSTRUCTION SET
INSTRUCTION SET
OPERATION
I2
I1
I0
R4
R3
R2
R1
R0
0
XXX
XX
NOP
0
1
XXX
XX
ACR READ
0
1
XXX
XX
ACR WRTE
1
0
R4R3R2R1R0
WRi or ACR READ
1
0
R4R3R2R1R0
WRi or ACR WRTE
Where X means “do not care”.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B2K-MY-F1 | CONVERTER MOD DC/DC 40V 50W |
| VE-B2J-MY-F4 | CONVERTER MOD DC/DC 36V 50W |
| X9313WSZT1 | IC POT DGTL 10K OHM 8-SOIC |
| VE-B2J-MY-F3 | CONVERTER MOD DC/DC 36V 50W |
| ISL1208IB8Z-TK | IC RTC LP BATT BACKED SRAM 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL23425WFRUZ-TK | 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 16LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23425WFVZ | 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23425WFVZ-T7A | 功能描述:數字電位計 IC 256 TAPVOLATILE SPI DUAL FL RNG IND 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23425WFVZ-TK | 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23428 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Dual, 128-Tap, Low Voltage Digitally Controlled Potentiometer (XDCP?) |
發布緊急采購，3分鐘左右您將得到回復。