TCV (Note 12) Ratiometric Temperature Coefficient DCP register set to 40 h" />

        參數資料
        型號: ISL22346WFV20Z-TK
        廠商: Intersil
        文件頁數: 12/16頁
        文件大?。?/td> 0K
        描述: IC POT DGTL 128TP LN LP 20-TSSOP
        標準包裝: 1,000
        系列: XDCP™
        接片: 128
        電阻(歐姆): 10k
        電路數: 4
        溫度系數: 標準值 ±50 ppm/°C
        存儲器類型: 非易失
        接口: I²C(設備位址)
        電源電壓: 2.7 V ~ 5.5 V
        工作溫度: -40°C ~ 125°C
        安裝類型: 表面貼裝
        封裝/外殼: 20-TSSOP(0.173",4.40mm 寬)
        供應商設備封裝: 20-TSSOP
        包裝: 帶卷 (TR)
        5
        FN6177.2
        September 3, 2009
        TCV
        (Note 12)
        Ratiometric Temperature Coefficient
        DCP register set to 40 hex
        ±4
        ppm/°C
        RESISTOR MODE (Measurements between RWi and RLi with RHi not connected, or between RWi and RHi with RLi not connected. i = 0, 1, 2 or 3)
        RINL
        (Note 16)
        Integral Non-linearity
        DCP register set between 10h and 7Fh;
        monotonic over all tap positions
        -1
        1
        MI
        (Note 13)
        RDNL
        (Note 15)
        Differential Non-linearity
        DCP register set between 10h and 7Fh;
        monotonic over all tap positions, W option
        -1
        1
        MI
        (Note 13)
        DCP register set between 10h and 7Fh;
        monotonic over all tap positions, U option
        -0.5
        0.5
        MI
        (Note 13)
        Roffset
        (Note 14)
        Offset
        W option
        0
        1
        5
        MI
        (Note 13)
        U option
        0
        0.5
        2
        MI
        (Note 13)
        RMATCH
        (Note 17)
        DCP to DCP Matching
        Any two DCPs at the same tap position with
        the same terminal voltages
        -2
        2
        MI
        (Note 13)
        Analog Specifications
        Over recommended operating conditions, unless otherwise stated. (Continued)
        SYMBOL
        PARAMETER
        TEST CONDITIONS
        MIN
        (Note 21)
        TYP
        (Note 5)
        MAX
        (Note 21)
        UNIT
        Operating Specifications Over the recommended operating conditions, unless otherwise specified.
        SYMBOL
        PARAMETER
        TEST CONDITIONS
        MIN
        (Note 21)
        TYP
        (Note 5)
        MAX
        (Note 21)
        UNIT
        ICC1
        VCC Supply Current (Volatile
        Write/Read)
        fSCL = 400kHz; SDA = Open; (for I
        2C,
        active, read and write states)
        0.5
        mA
        ICC2
        VCC Supply Current (Non-volatile
        Write/Read)
        fSCL = 400kHz; SDA = Open; (for I
        2C,
        active, read and write states)
        3mA
        ISB
        VCC Current (Standby)
        VCC = +5.5V @ +85°C, I
        2C interface in
        standby state
        5A
        VCC = +5.5V @ +125°C, I
        2C interface in
        standby state
        7A
        VCC = +3.6V @ +85°C, I
        2C interface in
        standby state
        3A
        VCC = +3.6V @ +125°C, I
        2C interface in
        standby state
        5A
        ISD
        VCC Current (Shutdown)
        VCC = +5.5V @ +85°C, I
        2C interface in
        standby state
        3A
        VCC = +5.5V @ +125°C, I
        2C interface in
        standby state
        5A
        VCC = +3.6V @ +85°C, I
        2C interface in
        standby state
        2A
        VCC = +3.6V @ +125°C, I
        2C interface in
        standby state
        4A
        ILkgDig
        Leakage Current, at Pins A0, A1, A2,
        SHDN, SDA and SCL
        Voltage at pin from GND to VCC
        -1
        1
        A
        tWRT
        (Note 20)
        DCP Wiper Response Time
        SCL falling edge of last bit of DCP data byte
        to wiper new position
        1.5
        s
        tShdnRec
        (Note 20)
        DCP Recall Time from Shutdown
        Mode
        From rising edge of SHDN signal to wiper
        stored position and RH connection
        1.5
        s
        SCL falling edge of last bit of ACR data byte
        to wiper stored position and RH connection
        1.5
        s
        Vpor
        Power-on Recall Voltage
        Minimum VCC at which memory recall
        occurs
        2.0
        2.6
        V
        ISL22346
        相關PDF資料
        PDF描述
        M83723/84W1831N CONN RCPT 31POS JAM NUT W/SCKT
        DS1007S-2/T&R IC DELAY LINE 4NS 16-SOIC
        DS1007S-12/T&R IC DELAY LINE 3NS 16-SOIC
        VI-B5B-MY-F1 CONVERTER MOD DC/DC 95V 50W
        ISL22346UFRT20Z-TK IC POT DGTL 128TP LN LP 20-TQFN
        相關代理商/技術參數
        參數描述
        ISL22346WMVEP 制造商:Intersil Corporation 功能描述:DGTL POTENTIOMETER 128POS 10KOHM QUAD 20TSSOP - Rail/Tube
        ISL22346WMVEP-TK 制造商:Intersil Corporation 功能描述:DGTL POTENTIOMETER 128POS 10KOHM QUAD 20TSSOP - Tape and Reel
        ISL22349 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Quad Digitally Controlled Potentiometers
        ISL22349_09 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Quad Digitally Controlled Potentiometers
        ISL22349UFV14Z 功能描述:IC POT DGTL 128TP LN LP 14-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:XDCP™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 接片:32 電阻(歐姆):50k 電路數:1 溫度系數:標準值 50 ppm/°C 存儲器類型:易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型,TSOT-23-6 供應商設備封裝:TSOT-23-6 包裝:帶卷 (TR)