參數資料
型號: ISD5008ED
廠商: Electronic Theatre Controls, Inc.
英文描述: SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
中文描述: 單片語音記錄重放設備4 - ,5 - ,6 - ,8 -一分鐘工期
文件頁數: 16/47頁
文件大?。?/td> 1174K
代理商: ISD5008ED
ISD5008 Product
13
ISD
4
SERIAL PERIPHERAL INTERFACE (SPI) DESCRIPTION
The ISD5008 product operates from an SPI serial in-
terface. The SPI interface operates with the following
protocol.
The data transfer protocol assumes that the mi-
crocontrollers SPI shift registers are clocked on the
falling edge of the SCLK. With the ISD5008, data is
clocked in on the MOSI pin on the rising clock
edge. Data is clocked out on the MISO pin on the
falling clock edge.
1.
All serial data transfers begin with the falling
edge of SS pin.
2.
SS is held LOW during all serial communica-
tions and held HIGH between instructions.
3.
Data is clocked in on the rising clock edge
and data is clocked out on the falling clock
edge.
4.
Play and Record operations are initiated by
enabling the device by asserting the SS pin
LOW, shifting in an opcode and an address
field to the ISD5008 device (refer to the Op-
code Summary on the page 14).
5.
The opcodes and address fields are as fol-
lows: < 8 control bits> and < 16 address
bits> .
6.
Each operation that ends in an EOM or
Overflow will generate an interrupt, includ-
ing the Message Cueing cycles. The Inter-
rupt will be cleared the next time an SPI
cycle is completed.
7.
As Interrupt data is shifted out of the
ISD5008 MISO pin, control and address
data is simultaneously being shifted into
the MOSI pin. Care should be taken such
that the data shifted in is compatible with
current system operation. It is possible to
read interrupt data and start a new opera-
tion within the same SPI cycle.
8.
A record or playback operation begins with
the RUN bit set and the operation ends with
the RUN bit reset.
9.
All operations begin with the rising edge
of SS.
4.1
MESSAGE CUEING
Message cueing allows the user to skip through
messages, without knowing the actual physical lo-
cation of the message. This operation is used dur-
ing playback. In this mode, the messages are
skipped 1600 times faster than in normal play-
back mode. It will stop when an EOM marker is
reached. Then, the internal address counter will
point to the next message.
相關PDF資料
PDF描述
ISD5008EI SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
ISD5008P SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
ISD5008S SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
ISD5008SD SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
ISD5008SI SINGLE CHIP VOICE RECORD PLAYBACK DEVICE 4-, 5-, 6-, AND 8- MINUTE DURATIONS
相關代理商/技術參數
參數描述
ISD5008EDR 功能描述:IC VOICE REC/PL 4-8MIN EX 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5008EI 功能描述:IC VOICE REC/PL 4-8MIN IN 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5008EIR 功能描述:IC VOICE REC/PL 4-8MIN IN 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5008EY 功能描述:IC VOICE REC/PLAY 4-8MIN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5008EYI 功能描述:IC VOICE REC/PLAY 4-8MIN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000