參數資料
型號: IL3222E
廠商: NVE Corp/Isolation Products
文件頁數: 18/18頁
文件大?。?/td> 0K
描述: TXRX ISO BUS 1MBS RS422 16SOIC
產品培訓模塊: IsoLoop® Isolator
產品目錄繪圖: IL3122, 3222, 3422 Circuit
特色產品: Wide-Body SOIC-16 Isolators
標準包裝: 50
系列: IsoLoop®
類型: 收發器,隔離式
驅動器/接收器數: 1/1
規程: RS422
電源電壓: 3.3V,5V
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 16-SOIC
包裝: 管件
產品目錄頁面: 2771 (CN2011-ZH PDF)
其它名稱: 390-1098-5
IL3285/IL3222
9
NVE Corporation
11409 Valley View Road, Eden Prairie, MN 55344-3617
Phone: (952) 829-9217
www.isoloop.com
iso-info@nve.com
NVE Corporation
Cabling, Data Rate and Terminations
Cabling
Use twisted-pair cable. The cable can be unshielded if it is short (less than 10 meters) and the data rate is slow (less than
100 Kbps). Otherwise, use screened cable with the shield tied to earth ground at one end only. Do not tie the shield to digital
ground. The other end of the shield may be tied to earth ground through an RC network. This prevents a DC ground loop in the
shield. Shielded cable minimizes EMI emissions and external noise coupling to the bus.
Data Rate
The longer the cable, the slower the data rate. The RS-485 bus can transmit ground over 4,000 feet (1,200 meters) or at 10 Mbps,
but not both at the same time. Transducer and cable characteristics combine to act as a filter with the general response shown in
Figure 3. Other parameters such as acceptable jitter affect the final cable length versus data rate tradeoff. Less jitter means better
signal quality but shorter cable lengths or slower data rates. Figure 4 shows a generally accepted 30% jitter and a corresponding
data rate versus cable length.
Figure 3. Cable Length vs. Data Rate (30% jitter).
Terminations
Transmission lines should be terminated to avoid reflections that cause data errors. In RS-485 systems both ends of the bus, not
every node, should be terminated. In RS-422 systems only the receiver end should be terminated.
100
Unterminated
Parallel
Proper termination is imperative when using IL3285 and IL3222 to minimize reflections. Unterminated lines are only suitable for
very low data rates and very short cable runs, otherwise line reflections cause problems. Parallel terminations are the most popular.
They allow high data rates and excellent signal quality.
Occasionally in noisy environments, fast pulses or noise appearing on the bus lines cause errors. One way of alleviating such errors
without adding circuit delays is to place a series resistor in the bus line. Depending on the power supply, the resistor should be
between 300 (3 V supply) and 500 (5 V supply).
1000
100
40
4000
100
1K
10K
100K
1M
10M
Data Rate (bps)
Cable Length (feet)
相關PDF資料
PDF描述
UP050CH4R7K-KEC CAP CER 4.7PF 50V 10% AXIAL
VI-B01-MX-F3 CONVERTER MOD DC/DC 12V 75W
MAX4951CTP+ IC RE-DRIVER SATA 20TQFN-EP
VE-25V-IV-B1 CONVERTER MOD DC/DC 5.8V 150W
UP050CH4R7K-B-B CAP CER 4.7PF 50V 10% AXIAL
相關代理商/技術參數
參數描述
IL3222ETR13 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Fractional Load RS485 and RS422 Transceivers
IL3222TR13 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Fractional Load RS485 and RS422 Transceivers
IL324 制造商:IKSEMICON 制造商全稱:IK Semicon Co., Ltd 功能描述:Low Power Quad Operational Amplifier
IL324_11 制造商:IKSEMICON 制造商全稱:IK Semicon Co., Ltd 功能描述:Low Power Quad Operational Amplifier
IL324D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Low Power Quad Operational Amplifier