- 您現在的位置：買賣IC網 > PDF目錄384478 > ICL8052A (Intersil Corporation) Precision 4 1/2 Digit, A/D Converter PDF資料下載
參數資料
| 型號： | ICL8052A |
| 廠商： | Intersil Corporation |
| 英文描述： | Precision 4 1/2 Digit, A/D Converter |
| 中文描述： | 精密4 1 / 2位，A / D轉換 |
| 文件頁數： | 10/23頁 |
| 文件大?。?/td> | 582K |
| 代理商： | ICL8052A |
10
Component Value Selection
For optimum performance of the analog section, care must
be taken in the selection of values for the integrator capacitor
and resistor, auto-zero capacitor, reference voltage, and
conversion rate. These values must be chosen to suit the
particular application.
Integrating Resistor
The integrating resistor is determined by the full scale input
voltage and the output current of the buffer used to charge
the integrator capacitor. This current should be small
compared to the output short circuit current such that
thermal effects are kept to a minimum and linearity is not
affected. Values of 5
μ
A to 40
μ
A give good results with a
nominal of 20
μ
A. The exact value may be chosen by:
NOTE: If gain is used in the buffer amplifier, then:
Integrating Capacitor
The product of integrating resistor and capacitor is selected
to give 9V swing for full scale inputs. This is a compromise
between possibly saturating the integrator (at +14V) due to
tolerance buildup between the resistor, capacitor and clock
and the errors a lower voltage swing could induce due to
offsets referred to the output of the comparator. In general,
the value of C
INT
is given by:
A very important characteristic of the integrating capacitor is
that it has low dielectric absorption to prevent roll-over or
ratiometric errors. A good test for dielectric absorption is to
use the capacitor with the input tied to the reference.
This ratiometric condition should be read half scale 1.0000,
and any deviation is probably due to dielectric absorption.
Polypropylene capacitors give undetectable errors at
reasonable cost. Polystyrene and polycarbonate capacitors
may be used in less critical applications.
Auto-Zero and Reference Capacitor
The size of the auto-zero capacitor has some influence on
the noise of the system, with a larger value capacitor giving
less noise. The reference capacitor should be large enough
such that stray capacitance to ground from its nodes is
negligible.
When gain is used in the buffer amplifier the reference
capacitor should be substantially larger than the auto-zero
capacitor. As a rule of thumb, the reference capacitor should
be approximately the gain times the value of the auto-zero
capacitor. The dielectric absorption of the reference cap and
auto-zero cap are only important at power-on or when the
circuit is recovering from an overload. Thus, smaller or
cheaper caps can be used here if accurate readings are not
required for the first few seconds of recovery.
FIGURE 5. TIMING DIAGRAM FOR OUTPUTS
AUTO
ZERO
COUNTS
FULL MEASUREMENT CYCLE
40,002/4,002 COUNTS
10,001
INTEGRATOR
OUTPUT
BUSY
SIGNAL
INTEG.
COUNTS
10,000
REFERENCE
INTEGRATE
COUNTS MAX
20,001 / 2,001
D
5
D
4
D
3
D
2
D
1
AUTO ZERO
DIGIT SCAN
FOR OVER-RANGE
SIGNAL
INTEGRATE
REFERENCE
INTEGRATE
D
1
D
2
D
3
D
4
D
5
FIRST D
5
OF AZ AND REF INT
ONE COUNT LONGER
STROBE
1000
/100 COUNTS
DIGIT SCAN
FOR OVER-RANGE
EXPANDED SCALE BELOW
OVER-RANGE
WHEN APPLICABLE
UNDER-RANGE
WHEN APPLICABLE
R
INT
------------------------------------------------------------------------------
=
R
INT
-------------------------------------------------------------------------------------------
(
=
C
INT
10,000(4-1/2 Digit)
Clock Period
×
20
μ
A
(
)
×
-------------------------------------------------------------------------------------------------------------------------
=
ICL8052A/ICL71C03, ICL8068A/ICL71C03
相關PDF資料 |
PDF描述 |
|---|---|
| ICL8068A | Precision 4 1/2 Digit, A/D Converter |
| ICL8068 | Precision 4 1/2 Digit, A/D Converter |
| ICL8068ACDD | 14-Bit/16-Bit, Microprocessor- Compatible, 2-Chip, A/D Converter |
| ICL8068CDD | 14-Bit/16-Bit, Microprocessor- Compatible, 2-Chip, A/D Converter |
| ICL71C03 | Precision 4 1/2 Digit, A/D Converter(精密4 1/2 位A/D轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICL8052ACDD | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| ICL8052ACPD | 制造商:Harris Corporation 功能描述: |
| ICL8052CDD | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Data Acquisition |
| ICL8052CDL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Converter IC |
| ICL8052CJD | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。