參數資料
型號: IBM25NPE405L-3FA200C
廠商: APPLIEDMICRO INC
元件分類: 微控制器/微處理器
英文描述: PowerNP
中文描述: 32-BIT, 200 MHz, RISC PROCESSOR, PBGA324
封裝: 23 X 23 MM, PLASTIC, EBGA-324
文件頁數: 37/54頁
文件大?。?/td> 460K
代理商: IBM25NPE405L-3FA200C
Preliminary
PowerNP NPe405L Embedded Processor Data Sheet
35
[DMAReq0:3]
DMA request. Used by peripherals to request a data
transfer. Following a system reset, the default mode of the
signals is active-low. They may be programmed to active-
high using the DMA0_POL register.
I
5V tolerant
3.3V LVTTL
1
[DMAAck0:3]
DMA acknowledge. Used to indicate to peripherals that
data transfer is complete. Following a system reset, the
default mode of the signals is active-low. They may be
programmed to active-high using the DMA0_POL register.
O
5V tolerant
3.3V LVTTL
[EOT0:3/TC0:3]
End Of Transfer/Terminal Count. Indication by peripherals
that all data has been transfered, or by DMA controller that
programmed amount of data has been transfered.
Following a system reset, the default mode of the signals is
active-low. They may be programmed to active-high using
the DMA0_POL register.
I/O
5V tolerant
3.3V LVTTL
1
Internal Peripheral Interface
UARTSerClk
Serial Clock used to provide an alternative clock to the
internally generated serial clock. Used in cases where the
allowable internally generated baud rates are not
satisfactory. This input can be individually connected to
either or both UART0 and UART1.
I
5V tolerant
3.3V LVTTL
1
UART0_Rx
UART0 Receive data.
I
5V tolerant
3.3V LVTTL
1
UART0_Tx
UART0 Transmit data.
O
5V tolerant
3.3V LVTTL
[UART0_DCD]
UART0 Data Carrier Detect.
I
5V tolerant
3.3V LVTTL
1
[UART0_DSR]
UART0 Data Set Ready.
I
5V tolerant
3.3V LVTTL
1
[UART0_CTS]
UART0 Clear To Send.
I
5V tolerant
3.3V LVTTL
1
[UART0_DTR]
UART0 Data Terminal Ready.
O
5V tolerant
3.3V LVTTL
[UART0_RTS]
UART0 Request To Send.
O
5V tolerant
3.3V LVTTL
[UART0_RI]
UART0 Ring Indicator.
I
5V tolerant
3.3V LVTTL r
1
Signal Functional Description
(Part 4 of 6)
Notes:
1. Receiver input has hysteresis.
2. Must pull up. See “Pull-up and Pull-down Resistors” on page 30 for recommended termination values.
3. Must pull down. See “Pull-up and Pull-down Resistors” on page 30 for recommended termination values.
4. If not used, must pull up.
5. If not used, must pull down.
6. Strapping input during reset; pull up or pull down as required.
7. Pull-up may be required. See “External Peripheral Bus Control Signals” on page 31.
Signal Name
Description
I/O
Type
Notes
相關PDF資料
PDF描述
IBM25NPE405L-3FA200CZ PowerNP
IBM25NPE405L-3FA266C PowerNP
IBM25NPE405L-3FA266CZ PowerNP
IC41LV16105 1M X 16 (16-MBIT) DYNAMIC RAM WITH FAST PAGE MODE
IC41LV16105-50K 1M X 16 (16-MBIT) DYNAMIC RAM WITH FAST PAGE MODE
相關代理商/技術參數
參數描述
IBM25NPE405L-3FA200CZ 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerNP
IBM25NPE405L-3FA266C 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerNP
IBM25NPE405L-3FA266CZ 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerNP
IBM25PPC403GAJC33C1 制造商:IBM 功能描述:
IBM25PPC405CR-3BC200C 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MICROPROCESSOR|32-BIT|CMOS|BGA|316PIN|PLASTIC