- 您現在的位置：買賣IC網 > PDF目錄385400 > HT48R06A-1 (Holtek Semiconductor Inc.) 8-Bit High Performance RISC-like OTP Microcontroller(8位、高性能、類似RISC、一次可編程微控制器，用于多I/O接口設備) PDF資料下載
參數資料
| 型號： | HT48R06A-1 |
| 廠商： | Holtek Semiconductor Inc. |
| 英文描述： | 8-Bit High Performance RISC-like OTP Microcontroller(8位、高性能、類似RISC、一次可編程微控制器，用于多I/O接口設備) |
| 中文描述： | 8位高性能RISC樣檢察官辦公室的微控制器（8位，高性能，類似的RISC，一次可編程微控制器，用于多的I / O接口設備） |
| 文件頁數： | 8/44頁 |
| 文件大小： | 291K |
| 代理商： | HT48R06A-1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
HT48R06A-1
8
November 29, 2000
Instruction
Table Location
*9
*8
*7
*6
*5
*4
*3
*2
*1
*0
TABRDC [m]
P9
P8
@7
@6
@5
@4
@3
@2
@1
@0
TABRDL [m]
1
1
@7
@6
@5
@4
@3
@2
@1
@0
Table location
Note: *9~*0: Table location bits
P9, P8: Current program counter bits
@7~@0: Table pointer bits
Routine) both employ the table read instruc-
tion, the contents of the TBLH in the main
routine are likely to be changed by the table
read instruction used in the ISR. Errors can
occur. In other words, using the table read in-
struction in the main routine and the ISR si-
multaneously should be avoided. However, if
the table read instruction has to be applied in
both the main routine and the ISR, the inter-
rupt is supposed to be disabled prior to the ta-
ble read instruction. It will not be enabled
until the TBLH has been backed up. All table
relatedinstructionsrequiretwocyclestocom-
plete the operation. These areas may function
as normal program memory depending upon
the requirements.
Stack register
STACK
This is a special part of the memory which is
used to save the contents of the program coun-
ter (PC) only. The stack is organized into 2 lev-
els and is neither part of the data nor part of the
program space, and is neither readable nor
writable. The activated level is indexed by the
stack pointer (SP) and is neither readable nor
writeable. At a subroutine call or interrupt ac-
knowledgment, the contents of the program
counter are pushed onto the stack. At the end of
a subroutine or an interrupt routine, signaled
by a return instruction (RET or RETI), the pro-
gram counter is restored to its previous value
from the stack. After a chip reset, the SP will
point to the top of the stack.
If the stack is full and a non-masked interrupt
takes place, the interrupt request flag will be
recorded but the acknowledgment will be inhib-
ited. When the stack pointer is decremented (by
RET or RETI), the interrupt will be serviced.
This feature prevents stack overflow allowing
the programmer to use the structure more eas-
ily. In a similar case, if the stack is full and a
"CALL" is subsequently executed, stack over-
flow occurs and the first entry will be lost (only
themostrecent2returnaddressesarestored).
Data memory
RAM
The data memory is designed with 81 8 bits.
The data memory is divided into two func-
tional groups: special function registers and
general purpose data memory (64 8). Most are
read/write, but some are read only.
The special function registers include the indi-
rect addressing register (00H), timer/event
counter (TMR;0DH), timer/event counter con-
trol register (TMRC;0EH), program counter
lower-order byte register (PCL;06H), memory
pointer register (MP;01H), accumulator
(ACC;05H), table pointer (TBLP;07H), table
higher-order byte register (TBLH;08H), status
register (STATUS;0AH), interrupt control reg-
ister (INTC;0BH), Watchdog Timer option set-
ting register (WDTS;09H), I/O registers
(PA;12H, PB;14H, PC;16H) and I/O control
registers (PAC;13H, PBC;15H, PCC;17H). The
remaining space before the 40H is reserved for
future expanded usage and reading these loca-
tions will get "00H". The general purpose data
memory, addressed from 40H to 7FH, is used
for data and control information under in-
struction commands.
相關PDF資料 |
PDF描述 |
|---|---|
| HT48R10A-1 | 8-Bit High Performance RISC-like Microcontroller Suitable for Multiple I/O Application(高性能、指令類似RISC的8位微控制器，用于多I/O接口設備) |
| HT48R10A | 8-BIT MICROCONTROLLER |
| HT48R30A-1 | 8-Bit High Performance RISC-like Microcontroller Suitable for Multiple I/O Application(高性能、指令類似RISC的8位微控制器，用于多I/O接口設備) |
| HT48R30A | 8-BIT MICROCONTROLLER |
| HT48R31-1 | 8-bit OTP Microcontrollers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT48R07A-1 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Cost-Effective I/O Type 8-Bit MCU |
| HT48R0AA-1 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Cost-Effective I/O Type 8-Bit OTP MCU |
| HT48R10A | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:8-Bit Microcontroller |
| HT48R10A-1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit I/O Type OTP MCU |
| HT48R10A-1(24SKDIP) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。