- 您現在的位置：買賣IC網 > PDF目錄385398 > HT24LC08 (Holtek Semiconductor Inc.) The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each PDF資料下載
參數資料
| 型號： | HT24LC08 |
| 廠商： | Holtek Semiconductor Inc. |
| 元件分類： | DRAM |
| 英文描述： | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| 中文描述： | 該CAT24FC02是一個2 KB的EEPROM的國內256個8位每字舉辦的串行CMOS |
| 文件頁數： | 3/11頁 |
| 文件大?。?/td> | 160K |
| 代理商： | HT24LC08 |
Symbol
Parameter
Remark
Standard Mode*
V
CC
=5V 10%
Unit
Min.
Max.
Min.
Max.
t
AA
Output Valid from Clock
3500
900
ns
t
BUF
Bus Free Time
Time in which the bus
must be free before a new
transmission can start
4700
1200
ns
t
SP
Input Filter Time Constant
(SDA and SCL Pins)
Noise suppression time
100
50
ns
t
WR
Write Cycle Time
5
5
ms
Notes: These parameters are periodically sampled but not 100% tested
* The standard mode means V
CC
=2.2V to 5.5V
For relative timing, refer to timing diagrams
HT24LC08
Rev. 1.30
3
November 25, 2003
Functional Description
Serial clock (SCL)
The SCLinput is used for positive edge clock data into
each EEPROM device and negative edge clock data
out of each device.
Serial data (SDA)
The SDA pin is bidirectional for serial data transfer.
The pin is open drain driven and may be wired-OR
with any number of other open drain or open collector
devices.
A0, A1, A2
The HT24LC08 uses the A2 input for hard wire ad-
dressing and a total of two 8K devices may be ad-
dressed on a single bus system. The A0 and A1 pins
have no connection.
Write protect (WP)
The HT24LC08 has a write protect pin that provides
hardware data protection. The write protect pin allows
normal read/write operations when the connection is
grounded. When the write protect pin is connected to
V
CC
, the write protection feature is enabled and oper-
ates as shown in the following table.
WP Pin Status
Protect Array
At V
CC
Full Array (8K)
At V
SS
Normal Read/Write Operations
Memory Organization
Internally organized with 1024 8-bit words, the 8K re-
quires a 10-bit data word address for random word ad-
dressing.
Device Operations
Clock and data transition
Data transfer may be initiated only when the bus is not
busy. During data transfer, the data line must remain
stable whenever the clock line is high. Changes in
data line while the clock line is high will be interpreted
as a START or STOP condition.
Start condition
Ahigh-to-low transition of SDAwith SCLhigh is a start
condition which must precede any other command
(refer to Start and Stop Definition Timing diagram).
Stop condition
Alow-to-high transition of SDAwith SCLhigh is a stop
condition. After a read sequence, the stop command
will place the EEPROM in a standby power mode (re-
fer to Start and Stop Definition Timing Diagram).
Acknowledge
All addresses and data words are serially transmitted
to and from the EEPROM in 8-bit words. The
EEPROM sends a zero to acknowledge that it has re-
ceivedeachword.Thishappensduringtheninthclock
cycle.
Device Addressing
The 8K EEPROM device requires an 8-bit device ad-
dress word following a start condition to enable the chip
for a read or write operation. The device address word
consist of a mandatory one, zero sequence for the first
four most significant bits (refer to the diagram showing
the Device Address). This is common to all the
EEPROM device.
The 8K EEPROM uses the A2 device address bit with
the next two bits for memory page addressing. The A2
bit must compare its corresponding hard-wired input
pin. The A1 and A0 pins have no connection.
( ( ) (
/
!
) 0 (
! !
" " )
(
1
/
!
2 (
!
.
!
(
)
!
3
)
4
" (
相關PDF資料 |
PDF描述 |
|---|---|
| HT24LC16 | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| HT25LC512 | CMOS 64Kx8-Bit SPI Serial OTP EPROM |
| HT27C010 | 128K x 8-Bit CMOS OTP EPROM(128K x 8位 CMOS一次可編程EPROM) |
| HT27C020 | OTP CMOS 256Kx 8-Bit EPROM |
| HT27C040 | 512K x 8-Bit CMOS OTP EPROM(512K x 8位 CMOS一次可編程EPROM) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT24LC08(8DIP) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:I2C Serial EEPROM |
| HT24LC08(8SOIC) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:I2C Serial EEPROM |
| HT24LC08(8SOP) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
| HT24LC08-8DIP-A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
| HT24LC08-8SOP-A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
發布緊急采購，3分鐘左右您將得到回復。