- 您現在的位置：買賣IC網 > PDF目錄385388 > HMS87C1302AD (HYNIX SEMICONDUCTOR INC) CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | HMS87C1302AD |
| 廠商： | HYNIX SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| 中文描述： | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDSO24 |
| 封裝： | SOP-24 |
| 文件頁數： | 51/70頁 |
| 文件大?。?/td> | 977K |
| 代理商： | HMS87C1302AD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
HYUNDAI MicroElectronics
HMS87C1304A/HMS87C1302A
Jan. 2001
Preliminary
51
[RETI].
Interrupt acceptance
1. The interrupt master enable flag (I-flag) is cleared to
“0” to temporarily disable the acceptance of any follow-
ing maskable interrupts. When a non-maskable inter-
rupt is accepted, the acceptance of any following
interrupts is temporarily disabled.
2. Interrupt request flag for the interrupt source accepted is
cleared to “0”.
3. The contents of the program counter (return address)
and the program status word are saved (pushed) onto the
stack area. The stack pointer decreases 3 times.
4. The entry address of the interrupt service program is
read from the vector table address and the entry address
is loaded to the program counter.
5. The instruction stored at the entry address of the inter-
rupt service program is executed.
Figure 15-3 Timing chart of Interrupt Acceptance and Interrupt Return Instruction
A interrupt request is not accepted until the I-flag is set to
“1” even if a requested interrupt has higher priority than
that of the current interrupt being serviced.
When nested interrupt service is required, the I-flag should
be set to “1” by “EI” instruction in the interrupt service
program. In this case, acceptable interrupt sources are se-
lectively enabled by the individual interrupt enable flags.
Saving/Restoring General-purpose Register
During interrupt acceptance processing, the program
counter and the program status word are automatically
saved on the stack, but accumulator and other registers are
not saved itself. These registers are saved by the software
if necessary. Also, when multiple interrupt services are
nested, it is necessary to avoid using the same data memory
area for saving registers.
The following method is used to save/restore the general-
purpose registers.
V.L.
System clock
Address Bus
PC
SP
SP-1
SP-2
V.H.
New PC
V.L.
Data Bus
Not used
PCH
PCL
PSW
ADL
OP code
ADH
Instruction Fetch
Internal Read
Internal Write
Interrupt Processing Step
Interrupt Service Task
V.L. and V.H. are vector addresses.
ADL and ADH are start addresses of interrupt service routine as vector contents.
Basic Interval Timer
Vector Table Address
012
H
0E3
H
0FFE6
H
0FFE7
H
0E
H
2E
H
0E312
H
0E313
H
Entry Address
Correspondence between vector table address for BIT interrupt
and the entry address of the interrupt service program.
Preimnary
相關PDF資料 |
PDF描述 |
|---|---|
| HMS87C1304AD | CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| HMS99C51 | 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| HMS99C52 | 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| HMS9XC7132 | DATA SHEET REV.2.0(PRELIMINARY) |
| HMU16GC-35 | 16 x 16-Bit CMOS Parallel Multipliers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMS87C13042A | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
| HMS87C1304A | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| HMS87C1304AD | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| HMS87C1404B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
| HMS87C1404BD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
發(fā)布緊急采購，3分鐘左右您將得到回復。