- 您現在的位置：買賣IC網 > PDF目錄367208 > HMC263 (美國訊泰微波有限公司上海代表處) GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz PDF資料下載
參數資料
| 型號： | HMC263 |
| 廠商： | 美國訊泰微波有限公司上海代表處 |
| 英文描述： | GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz |
| 中文描述： | 砷化鎵MMIC低噪聲放大器，24 - 36千兆赫 |
| 文件頁數： | 6/8頁 |
| 文件大小： | 212K |
| 代理商： | HMC263 |
MICROWAVE CORPORATION
1 - 7
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
12 Elizabeth Drive, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373
Order Online at www.hittite.com
A
1
HMC263
GaAs MMIC LOW NOISE
AMPLIFIER, 24 - 36 GHz
v02.0701
Mounting & Bonding Techniques for Millimeterwave GaAs MMICs
The die should be attached directly to the ground plane eutectically or with conductive epoxy (see HMC general Han-
dling, Mounting, Bonding Note).
50 Ohm Microstrip transmission lines on 0.127mm (5 mil) thick alumina thin film substrates are recommended for bring-
ing RF to and from the chip (Figure 1). If 0.254mm (10 mil) thick alumina thin film substrates must be used, the die
should be raised 0.150mm (6 mils) so that the surface of the die is coplanar with the surface of the substrate. One
way to accomplish this is to attach the 0.102mm (4 mil) thick die to a 0.150mm (6 mil) thick molybdenum heat spreader
(moly-tab) which is then attached to the ground plane (Figure 2).
Microstrip substrates should brought as close to the die as possible in order to minimize bond wire length. Typical die-
to-substrate spacing is 0.076mm to 0.152 mm (3 to 6 mils).
An RF bypass capacitor should be used on the Vdd input. A 100 pF single layer capacitor (mounted eutectically or by
conductive epoxy) placed no further than 0.762mm (30 Mils) from the chip is recommended.
Assembly Diagrams
Ribbon Bond
Ribbon Bond
相關PDF資料 |
PDF描述 |
|---|---|
| HMC264LC3B | GaAs MMIC SUB-HARMONIC SMT MIXER, 21 - 31 GHz |
| HMC264LM3 | GaAs MMIC SUB-HARMONIC SMT MIXER, 20 - 30 GHz |
| HMC264 | GaAs MMIC SUB-HARMONICALLY PUMPED MIXER, 20 - 32 GHz |
| HMC265 | 600000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
| HMC265LM3 | 600000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMC263_07 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz |
| HMC263LP4_09 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz |
| HMC263LP4E | 制造商:Hittite Microwave Corp 功能描述:IC AMP LNA 20-36GHZ 24QFN |
| HMC263LP4E_09 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz |
| HMC263LP4E_10 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs MMIC LOW NOISE AMPLIFIER, 24 - 36 GHz |
發布緊急采購，3分鐘左右您將得到回復。