- 您現在的位置：買賣IC網 > PDF目錄384406 > HGTG12N60B3D (FAIRCHILD SEMICONDUCTOR CORP) 36 MACROCELL 3.3 VOLT ISP CPLD PDF資料下載
參數資料
| 型號： | HGTG12N60B3D |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 功率晶體管 |
| 英文描述： | 36 MACROCELL 3.3 VOLT ISP CPLD |
| 中文描述： | 27 A, 600 V, N-CHANNEL IGBT, TO-247 |
| 文件頁數： | 7/8頁 |
| 文件大?。?/td> | 124K |
| 代理商： | HGTG12N60B3D |
2001 Fairchild Semiconductor Corporation
HGTG12N60C3D Rev. B
Handling Precautions for IGBTs
Insulated Gate Bipolar Transistors are susceptible to
gate-insulation damage by the electrostatic discharge of
energy through the devices. When handling these devices,
care should be exercised to assure that the static charge
built in the handler’s body capacitance is not discharged
through the device. With proper handling and application
procedures, however, IGBTs are currently being extensively
used in production by numerous equipment manufacturers in
military, industrial and consumer applications, with virtually
no damage problems due to electrostatic discharge. IGBTs
can be handled safely if the following basic precautions are
taken:
1. Prior to assembly into a circuit, all leads should be kept
shorted together either by the use of metal shorting
springs or by the insertion into conductive material such
as “ECCOSORBD
LD26” or equivalent.
2. When devices are removed by hand from their carriers,
the hand being used should be grounded by any suitable
means, for example, with a metallic wristband.
3. Tips of soldering irons should be grounded.
4. Devices should never be inserted into or removed from
circuits with power on.
5.
Gate Voltage Rating
- Never exceed the gate-voltage
rating of V
GEM
. Exceeding the rated V
GE
can result in
permanent damage to the oxide layer in the gate region.
6.
Gate Termination
- The gates of these devices are
essentially capacitors. Circuits that leave the gate open-
circuited or floating should be avoided. These conditions
can result in turn-on of the device due to voltage buildup on
the input capacitor due to leakage currents or pickup.
7.
Gate Protection
- These devices do not have an internal
monolithic Zener Diode from gate to emitter. If gate
protection is required an external Zener is recommended.
Operating Frequency Information
Operating frequency information for a typical device (Figure 13)
is presented as a guide for estimating device performance
for a specific application. Other typical frequency vs collector
current (I
CE
) plots are possible using the information shown
for a typical unit in Figures 4, 7, 8, 11 and 12. The operating
frequency plot (Figure 13) of a typical device shows f
MAX1
or
f
MAX2
whichever is smaller at each point. The information is
based on measurements of a typical device and is bounded
by the maximum rated junction temperature.
f
MAX1
is defined by f
MAX1
= 0.05/(t
D(OFF)I
+ t
D(ON)I
).
Deadtime (the denominator) has been arbitrarily held to 10%
of the on-state time for a 50% duty factor. Other definitions
are possible. t
D(OFF)I
and t
D(ON)I
are defined in Figure 21.
Device turn-off delay can establish an additional frequency
limiting condition for an application other than T
JM
. t
D(OFF)I
is important when controlling output ripple under a lightly
loaded condition.
f
MAX2
is defined by f
MAX2
= (P
D
- P
C
)/(E
OFF
+ E
ON
). The
allowable dissipation (P
D
) is defined by P
D
= (T
JM
- T
C
)/R
θ
JC
.
The sum of device switching and conduction losses must not
exceed P
D
. A 50% duty factor was used (Figure 13) and the
conduction losses (P
C
) are approximated by
P
C
= (V
CE
x I
CE
)/2.
E
ON
and E
OFF
are defined in the switching waveforms
shown in Figure 21. E
ON
is the integral of the instantaneous
power loss (I
CE
x V
CE
) during turn-on and E
OFF
is the
integral of the instantaneous power loss during turn-off. All
tail losses are included in the calculation for E
OFF
; i.e. the
collector current equals zero (I
CE
= 0).
HGTG12N60C3D
相關PDF資料 |
PDF描述 |
|---|---|
| HGTP12N60B3D | 27A, 600V, UFS Series N-Channel IGBTs with Anti-Parallel Hyperfast Diode |
| HGTP12N60B3D | Aluminum Electrolytic Radial Leaded General Purpose Capacitor; Capacitance: 470uF; Voltage: 25V; Case Size: 10x12.5 mm; Packaging: Bulk |
| HGT1S12N60B3DS | 27A, 600V, UFS Series N-Channel IGBTs with Anti-Parallel Hyperfast Diode |
| HGTG12N60C3D | 24A, 600V, UFS Series N-Channel IGBTs(24A, 600V, UFS系列 N溝道絕緣柵雙極型晶體管) |
| HGTG20N60A4D | 600V, SMPS Series N-Channel IGBT with Anti-Parallel Hyperfast Diode(600V,SMPS系列N溝道絕緣柵雙極型晶體管（帶反并行超快速二極管）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HGTG12N60C3D | 功能描述:IGBT 晶體管 24a 600V IGBT UFS N-Channel RoHS:否 制造商:Fairchild Semiconductor 配置: 集電極—發射極最大電壓 VCEO:650 V 集電極—射極飽和電壓:2.3 V 柵極/發射極最大電壓:20 V 在25 C的連續集電極電流:150 A 柵極—射極漏泄電流:400 nA 功率耗散:187 W 最大工作溫度: 封裝 / 箱體:TO-247 封裝:Tube |
| HGTG12N60C3DR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HGTG12N60D1 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:12A, 600V N-Channel IGBT with Anti-Parallel Ultrafast Diode |
| HGTG12N60D1D | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris 功能描述:Harris TO-247 NXC6A, NXF7D 制造商:Harris Corporation 功能描述: |
| HGTG12N60DID | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。