參數資料
型號： HFA3861BIN
廠商： INTERSIL CORP
元件分類： 無繩電話/電話
英文描述： Direct Sequence Spread Spectrum Baseband Processor
中文描述： TELECOM, CELLULAR, BASEBAND CIRCUIT, PQFP64
封裝： 10 X 10 MM, PLASTIC, MS-026ACD, TQFP-64
文件頁數： 29/36頁
文件大?。?/td> 733K
代理商： HFA3861BIN
29
CONFIGURATION REGISTER ADDRESS 34 (44h) R/W TEST BUS ADDRESS
Bits 7:0
address bits for various tests. See Tech Brief #TBD for a description of the factory test modes
CONFIGURATION REGISTER ADDRESS 35 (46h) R/W CMF COEFFICIENT CONTROL THRESHOLD
Bit 7
CMF Threshold control. Also controls CR49. This bit must be set to a “1” when using manual control of default and calculated
weights.
0 = threshold is relative to noise floor
1 = threshold is absolute.
Bits 6:0
Default weights RSSI Threshold. In half dB steps. This sets the SNR at which the decision to use either calculated or default
CMF weights is made in the absence of CW interference.
For 100% calculated weights, set to 80h and set CR49 to 00h.
For 100% default weights, set to ffh and set CR49 to 7fh.
CONFIGURATION REGISTER ADDRESS 36 (48h) R/W SCRAMBLER SEED LONG PREAMBLE
Bit 7
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
Bit 6:0
Scrambler seed for long preamble
bit 3 of CR5 selects CR36 or CR 37
CONFIGURATION REGISTER ADDRESS 37 (4Ah) R/W SCRAMBLER SEED SHORT PREAMBLE
Bit 7
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
Bit 6:0
Scrambler seed for short preamble
bit 3 of CR5 selects CR36 or CR 37
CONFIGURATION REGISTER ADDRESS 38 (4Ch) R/W ED THRESHOLD
Bit 7
CR_AGC_EDmode.
0 = noise floor + CR_AGC_EDthresh
1 = absolute threshold
Bit 7:0
CR_AGC_EDthresh. Energy detect threshold, (range 0-127)
CONFIGURATION REGISTER ADDRESS 39 (4Eh) R/W CMF SCALE THRESHOLD
Bit 7:6
Unused
Channel Matched filter scale threshold (range 0-255). After CMF is in operation, 8 correlation peaks are accumulated and
compared to threshold to determine if there is headroom to scale gain up by a factor. Set all to 03h to disable scaling.
Bits 5:4
Threshold for scaling gain by 2.5 if accumulated peak is less than:
00 = 10
01 = 20
10 = 30
11 = 40
Bits 3:2
Threshold for scaling gain by 1.5 if accumulated peak is less than:
00 = 20
01 = 50
10 = 60
11 = 70
Bits 1:0
Threshold for scaling gain by 0.5 if accumulated peak is less than:
00 = 250
01 = 350
10 = 450
11 = 750
CONFIGURATION REGISTER ADDRESS 40 (50h) R/W RSSI ANTENNA THRESHOLD
Bit 7
Threshold. RSSI below this threshold will result in an antenna search, above will result in sticking with the first antenna.
0 = threshold is relative to noise floor
1 = threshold is absolute
Bits 6:0
Threshold for antenna decision (CR_AGC_AntSearchThresh), range 0-127
HFA3861B
相關PDF資料
PDF描述
HFA3861BIN96 Direct Sequence Spread Spectrum Baseband Processor
HFA3925IA null2.4GHz - 2.5GHz 250mW Power Amplifier
HFA3925IA96 null2.4GHz - 2.5GHz 250mW Power Amplifier
HFA50PA60C RxxP2xx Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 05V; Output Voltage (Vdc): 15V; Power: 2W; EN 60950 certified, rated for 250VAC; UL-60950-1 / CSA C22.2 certified; 5.2kVDC Isolation for 1 Minute; Optional Continuous Short Circuit Protected; Wide Operating Temperature Range atfull 2 Watts Load, ?40??C to +85??C; Twin Chamber Transformer System; UL94V-0 Package Material; Efficiency to 80%
HFB50PA60C Ultrafast, Soft Recovery Diode
相關代理商/技術參數
參數描述
HFA3861BIN96 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3861IV 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3861IV96 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3863 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3863IN 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*