- 您現在的位置：買賣IC網 > PDF目錄385287 > G781 (Electronic Theatre Controls, Inc.) 【1∑C Remote and Local Temperature Sensor with SMBus Serial Interface PDF資料下載
參數資料
| 型號： | G781 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 溫度/濕度傳感器 |
| 英文描述： | 【1∑C Remote and Local Temperature Sensor with SMBus Serial Interface |
| 中文描述： | 【1ΣC遠程和本地溫度傳感器，帶有SMBus串行接口 |
| 文件頁數： | 5/14頁 |
| 文件大?。?/td> | 342K |
| 代理商： | G781 |
Ver: 1.0
Oct 02, 2002
TEL: 886-3-5788833
http://www.gmt.com.tw
5
Global Mixed-mode Technology Inc.
G781
A/D Conversion Sequence
If a Start command is written (or generated automati-
cally in the free-running auto-convert mode), both
channels are converted, and the results of both meas-
urements are available after the end of conversion. A
BUSY status bit in the status byte shows that the de-
vice is actually performing a new conversion; however,
even if the ADC is busy, the results of the previous
conversion are always available.
Remote Diode Selection
Temperature accuracy depends on having a good-
quality, diode-connected small-signal transistor. The
G781 can also directly measure the die temperature of
CPUs and other integrated circuits having on-board
temperature-sensing diodes.
The transistor must be a small-signal type with a rela-
tively high forward voltage; otherwise, the A/D input
voltage range can be violated. The forward voltage
must be greater than 0.25V at 10μA; check to ensure
this is true at the highest expected temperature. The
forward voltage must be less than 0.95V at 300μA;
check to ensure this is true at the lowest expected
temperature. Large power transistors don’t work at all.
Also, ensure that the base resistance is less than
100
. Tight specifications for forward-current gain
(+50 to +150, for example) indicate that the manufac-
turer has good process controls and that the devices
have consistent V
be
characteristics.
Thermal Mass and Self-Heating
Thermal mass can seriously degrade the G781’s ef-
fective accuracy. The thermal time constant of the
SOP- package is about 140 in still air. For the G781
junction temperature to settle to within +1°C after a
sudden +100°C change requires about five time con-
stants or 12 minutes. The use of smaller packages for
remote sensors, such as SOT23s, improves the situa-
tion. Take care to account for thermal gradients be-
tween the heat source and the sensor, and ensure that
stray air currents across the sensor package do not
interfere with measurement accuracy. Self-heating
does not significantly affect measurement accuracy.
Remote-sensor self-heating due to the diode current
source is negligible. For the local diode, the worst-case
error occurs when auto-converting at the fastest rate
and simultaneously sinking maximum current at the
ALERT
output. For example, at an 8Hz rate and with
ALERT
sinking 1mA, the typical power dissipation is
VCC x 320μA plus 0.4V x 1mA. Package theta J-A is
about 120°C /W, so with VCC = 3.3V and no copper PC
board heat-sinking, the resulting temperature rise is:
dT = 1.45mW x 120°C /W = 0.17°C
Even with these contrived circumstances, it is difficult
to introduce significant self-heating errors.
Table 1. Remote-Sensor Transistor Manufacturers
MANUFACTURER
Philips
Motorola(USA)
National Semiconductor (USA)
Note:Transistors must be diode-connected (base
shorted to collector).
MODEL NUMBER
PMBS3904
MMBT3904
MMBT3904
ADC Noise Filtering
The ADC is an integrating type with inherently good
noise rejection. Micropower operation places con-
straints on high-frequency noise rejection; therefore,
careful PC board layout and proper external noise fil-
tering are required for high-accuracy remote meas-
urements in electrically noisy environments.
High-frequency EMI is best filtered at DXP and DXN
with an external 2200pF capacitor. This value can be
increased to about 3300pF(max), including cable ca-
pacitance. Higher capacitance than 3300pF introduces
errors due to the rise time of the switched current
source.
Nearly all noise sources tested cause the ADC meas-
urements to be higher than the actual temperature,
typically by +1°C to 10°C, depending on the frequency
and amplitude.
PC Board Layout
Place the G781 as close as practical to the remote
diode. In a noisy environment, such as a computer
motherboard, this distance can be 4 in. to 8 in. (typical)
or more as long as the worst noise sources (such as
CRTs, clock generators, memory buses, and ISA/PCI
buses) are avoided.
相關PDF資料 |
PDF描述 |
|---|---|
| G8912B | Aluminum Snap-In Capacitor; Capacitance: 3300uF; Voltage: 63V; Case Size: 22x45 mm; Packaging: Bulk |
| G8912BC | Aluminum Snap-In Capacitor; Capacitance: 3900uF; Voltage: 63V; Case Size: 30x35 mm; Packaging: Bulk |
| G8912BCI | Aluminum Snap-In Capacitor; Capacitance: 4700uF; Voltage: 63V; Case Size: 25x50 mm; Packaging: Bulk |
| G8912BD | Aluminum Snap-In Capacitor; Capacitance: 4700uF; Voltage: 63V; Case Size: 30x40 mm; Packaging: Bulk |
| G8912BDI | Aluminum Snap-In Capacitor; Capacitance: 6800uF; Voltage: 63V; Case Size: 30x50 mm; Packaging: Bulk |
相關代理商/技術參數 |
參數描述 |
|---|---|
| G7816E | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SHORTING BAR-G70A-16A |
| G78-16-E | 功能描述:SHORTING BAR-G70A-16A RoHS:是 類別:工業控制，儀表 >> 配件 系列:* 標準包裝:1 系列:Aero-Motive® 130117 附件類型:拖車帶 適用于相關產品:標準盒式跟蹤系統 其它名稱:WM6183 |
| G78-16-P2RF-E | 制造商:OMRON Electronic Components LLC 功能描述: 制造商:Omron Americas 功能描述:BUSBAR 16WAY 制造商:Omron Americas 功能描述:BUSBAR, 16WAY 制造商:Omron Corporation 功能描述:BUSBAR, 16WAY, Accessory Type:Jumper, For Use With:G70A Series I/O Blocks, No. o 制造商:Omron Corporation 功能描述:Busbar for G2R-SNI power relay 制造商:OK Industries 功能描述:COMMON BUSBAR |
| G784B | 制造商:IDEA 制造商全稱:IDEA 功能描述:T-1, (3-mm) Round, Bi-level PCB Mount LED Indicator |
| G7853-245-1.5B | 功能描述:環形MIL規格后蓋 RoHS:否 制造商:Amphenol PCD MIL 類型:MIL-DTL-38999 III, IV 系列:AS85049 產品類型:Environmental EMI/RFI Backshells 外殼類型:Straight 外殼大小:18 外殼材質:Aluminum Alloy |
發布緊急采購，3分鐘左右您將得到回復。