- 您現在的位置：買賣IC網 > PDF目錄382970 > FT245BQ (Electronic Theatre Controls, Inc.) FT245BQ USB FIFO ( USB - Parallel ) I.C. PDF資料下載
參數資料
| 型號： | FT245BQ |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | FT245BQ USB FIFO ( USB - Parallel ) I.C. |
| 中文描述： | FT245BQ USB先進先出（USB端口-并行）集成電路 |
| 文件頁數： | 18/24頁 |
| 文件大?。?/td> | 505K |
| 代理商： | FT245BQ |
DS245BL Version 1.6 Future Technology Devices Intl. Ltd. 2005
Page 18 of 24
FT245BL USB FIFO ( USB - Parallel ) I.C.
Figure 8
USB Self Powered Configuration
Figure 8 illustrates a typical USB self powered configuration. A USB Self Powered device gets its power from its own
POWER SUPPLY and does not draw current from the USB bus. The basic rules for USB Self power devices are as
follows –
a) A Self-Powered device should not force current down the USB bus when the USB Host or Hub Controller is
powered down.
b) A Self Powered Device can take as much current as it likes during normal operation and USB suspend as it has its
own POWER SUPPLY.
c) A Self Powered Device can be used with any USB Host and both Bus and Self Powered USB Hubs
The USB power descriptor option in the EEPROM should be programmed to a value of zero (self powered).
To meet requirement a) the 1.5K pull-up resistor on USBDP is connected to RSTOUT# as per the bus-power circuit.
However, the USB Bus Power is used to control the RESET# Pin of the FT245BL device. When the USB Host or Hub
is powered up RSTOUT# will pull the 1.5K resistor on USB DP to 3.3V, thus identifying the device as a full speed
device to USB. When the USB Host or Hub power is off, RESET# will go low and the device will be held in reset. As
RESET# is low, RSTOUT# will also be low, so no current will be forced down USBDP via the 1.5K pull-up resistor
when the host or hub is powered down. Failure to do this may cause some USB host or hub controllers to power up
erratically.
Note : When the FT245BL is in reset, the FIFO interface pins all go tri-state. These pins have internal 200K pull-up
resistors to VCCIO so they will gently pull high unless driven by some external logic.
VCC
27R
USB "B"
Connector
27R
USB DM
RSTOUT#
8
FT245BM
USB DP
7
5
V
C
C
V
C
C
V
C
C
I
O
3
26
13
1
2
3
4
1k5
33nF
3v3OUT
6
470R
A
V
C
C
30
0.1uF
G
N
D
G
N
D
A
G
N
D
9
17
29
RESET#
4
10k
4k7
Decoupling Capacitors
10uF
VCC
0.1uF
0.1uF
+
相關PDF資料 |
PDF描述 |
|---|---|
| FT6116 | 2K X 8 CMOS SRAM |
| FT8U100AX | FT8U100AX USB Compound Hub Controller |
| FTD1011 | Ultrahigh-Speed Switching Applications |
| FTD1012 | Load Switching Applications |
| FTD1014 | Load Switching Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT245BQ-REEL | 功能描述:USB 接口集成電路 USB to Parallel FIFO IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT245R | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB FIFO I.C. Incorporating FTDIChip-ID⑩ Security Dongle |
| FT245R_10 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB FIFO IC - Single chip USB to parallel FIFO bidirectional data transfer interface |
| FT245RL | 制造商:Future Technology Devices International 功能描述:USB FIFO IC 28-Pin SSOP 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO FIFO SMD SSOP28 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO FIFO, SMD, SSOP28, 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO INTERFACE, SSOP-28; USB Type:USB FIFO; USB Version:2.0; Supply Voltage Min:1.8V; Supply Voltage Max:5.25V; Digital IC Case Style:SSOP; No. of Pins:28; Data Rate:1Mbps; No. of Ports:2; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
| FT245RL-2000 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB FIFO IC - Single chip USB to parallel FIFO bidirectional data transfer interface |
發布緊急采購，3分鐘左右您將得到回復。