參數資料
型號： EVAL-AD5933EBZ
廠商： Analog Devices Inc
文件頁數： 27/40頁
文件大?。?/td> 0K
描述： BOARD EVALUATION FOR AD5933
產品培訓模塊： AD5933 Impedance to Digital Converter
ADP2102 DSP Battery Life Applications
Direct Digital Synthesis Tutorial Series (1 of 7): Introduction
Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action
Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter
Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction
Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter
Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator
標準包裝： 1
主要目的： 計時，直接數字合成（DDS）
嵌入式： 否
已用 IC / 零件： AD5933
主要屬性： 12 位數模轉換器，24 位調節字寬
次要屬性： 16MHz 2.7 V ~ 5.5 V 圖形用戶界面
已供物品： 板，纜線，CD
產品目錄頁面： 797 (CN2011-ZH PDF)
相關產品： AD5933YRSZ-REEL7-ND - NETWORK ANALYZER 12B 1MSP 16SSOP
AD5933YRSZ-ND - IC NTWK ANALYZER 12B 1MSP 16SSOP
Data Sheet
AD5933
Rev. E | Page 33 of 40
ELECTRO-IMPEDANCE SPECTROSCOPY
The AD5933 has found use in the area of corrosion monitoring.
Corrosion of metals, such as aluminum and steel, can damage
industrial infrastructures and vehicles such as aircraft, ships,
and cars. This damage, if left unattended, may lead to premature
failure requiring expensive repairs and/or replacement. In
many cases, if the onset of corrosion can be detected, it can
be arrested or slowed, negating the requirement for repairs or
replacement. At present, visual inspection is employed to detect
corrosion; however, this is time consuming, expensive, and
cannot be employed in hard-to-access areas.
An alternative to visual inspection is automated monitoring
using corrosion sensors. Monitoring is cheaper, less time
consuming, and can be deployed where visual inspections are
impossible. Electrochemical impedance spectroscopy (EIS) has
been used to interrogate corrosion sensors, but at present large
laboratory test instruments are required. The AD5933 offers an
accurate and compact solution for this type of measurement,
enabling the development of field deployable sensor systems
that can measure corrosion rates autonomously.
Mathematically, the corrosion of aluminum is modeled using an
RC network that typically consists of a resistance, RS, in series
with a parallel resistor and capacitor, RP and CP. A system metal
would typically have values as follows: RS is 10 to 10 k,
RP 1 is k to 1 M, and CP is 5 F to 70 F. Figure 38 shows
a typical Bode plot, impedance modulus, and phase angle vs.
frequency, for an aluminum corrosion sensor.
100k
10
0.1
FREQUENCY (Hz)
M
O
DUL
US
P
HAS
E
ANG
L
E
100k
05324-
043
–75
0
–50
–25
1
10
100
1k
10k
100
1k
10k
Figure 38. Bode Plot for Aluminum Corrosion Sensor
To make accurate measurements of these values, the impedance
needs to be measured over a frequency range of 0.1 Hz to 100 kHz.
To ensure that the measurement itself does not introduce a
corrosive effect, the metal needs to be excited with minimal
voltage, typically in the ±20 mV range. A nearby processor
or control unit such as the ADuC702x would log a single
impedance sweep from 0.1 kHz to 100 kHz every 10 minutes
and download the results back to a control unit. To achieve
system accuracy from the 0.1 kHz to 1 kHz range, the system
clock needs to be scaled down from the 16.776 MHz nominal
clock frequency to 500 kHz, typically. The clock scaling can be
achieved digitally using an external direct digital synthesizer
like the AD9834 as a programmable divider, which supplies a
clock signal to MCLK and which can be controlled digitally by
the nearby microprocessor.
相關PDF資料
PDF描述
VI-B2W-EW CONVERTER MOD DC/DC 5.5V 100W
VI-B2V-EW CONVERTER MOD DC/DC 5.8V 100W
Q2-Z-3-01-SS100FT HEATSHRINK POLY Q2Z 3"X100FT BLK
GEM18DRKF CONN EDGECARD 36POS DIP .156 SLD
848407-1 CONN LEAD ASSY SGL-END 20AWG 16"
相關代理商/技術參數
參數描述
EVAL-AD5933EBZ 制造商:Analog Devices 功能描述:IMPEDANCE CONVERTER EVALUATION BOARD
EVAL-AD5934EB 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk
EVAL-AD5934EBZ 功能描述:BOARD EVALUATION FOR AD5934 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
EVAL-AD607EBZ 功能描述:BOARD EVALUATION FOR AD607 RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796
EVAL-AD608EBZ 功能描述:BOARD EVALUATION FOR AD608 RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*