- 您現在的位置：買賣IC網 > PDF目錄17166 > EFM32-TG-STK3300 (Energy Micro)KIT STARTER EFM32 GECKO PDF資料下載
參數資料
| 型號： | EFM32-TG-STK3300 |
| 廠商： | Energy Micro |
| 文件頁數： | 59/136頁 |
| 文件大小： | 0K |
| 描述： | KIT STARTER EFM32 GECKO |
| 特色產品： | EFM32 Tiny Gecko |
| 標準包裝： | 1 |
| 系列： | EFM®32 |
| 類型： | MCU |
| 適用于相關產品： | EFM32-TGXXX |
| 所含物品： | 板，線纜，CD 和文檔 |
| 其它名稱： | 914-1018 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
29
www.energymicro.com
Fault
Handler
Bit name
Fault status register
during exception stacking
MSTKERR
during exception unstacking
MUNSKERR
Bus error:
-
during exception stacking
STKERR
during exception unstacking
UNSTKERR
during instruction prefetch
IBUSERR
Precise data bus error
PRECISERR
Imprecise data bus error
Bus fault
IMPRECISERR
Attempt to access a coprocessor
NOCP
Undefined instruction
UNDEFINSTR
Attempt to enter an invalid instruction set state
2
INVSTATE
Invalid EXC_RETURN value
INVPC
Illegal unaligned load or store
UNALIGNED
Divide By 0
Usage fault
DIVBYZERO
1Occurs on an access to an XN region even if the MPU is disabled, or not included in the device.
2Attempting to use an instruction set other than the Thumb instruction set.
2.4.2 Fault escalation and hard faults
All faults exceptions except for hard fault have configurable exception priority, see Section 4.3.9 (p.
102) . Software can disable execution of the handlers for these faults, see Section 4.3.10 (p. 103) .
Usually, the exception priority, together with the values of the exception mask registers, determines
whether the processor enters the fault handler, and whether a fault handler can preempt another fault
handler. as described in Section 2.3 (p. 22) .
In some situations, a fault with configurable priority is treated as a hard fault. This is called priority
escalation, and the fault is described as escalated to hard fault. Escalation to hard fault occurs when:
A fault handler causes the same kind of fault as the one it is servicing. This escalation to hard fault
occurs because a fault handler cannot preempt itself because it must have the same priority as the
current priority level.
A fault handler causes a fault with the same or lower priority as the fault it is servicing. This is because
the handler for the new fault cannot preempt the currently executing fault handler.
An exception handler causes a fault for which the priority is the same as or lower than the currently
executing exception.
A fault occurs and the handler for that fault is not enabled.
If a bus fault occurs during a stack push when entering a bus fault handler, the bus fault does not escalate
to a hard fault. This means that if a corrupted stack causes a fault, the fault handler executes even though
the stack push for the handler failed. The fault handler operates but the stack contents are corrupted.
Note
Only Reset and NMI can preempt the fixed priority hard fault. A hard fault can preempt any
exception other than Reset, NMI, or another hard fault.
2.4.3 Fault status registers and fault address registers
The fault status registers indicate the cause of a fault. For bus faults and memory management faults,
the fault address register indicates the address accessed by the operation that caused the fault, as
shown in Table 2.18 (p. 30) .
相關PDF資料 |
PDF描述 |
|---|---|
| HSC08DRYH-S13 | CONN EDGECARD 16POS .100 EXTEND |
| TH3D336M016A0600 | CAP TANT 33UF 16V 20% 2917 |
| GBA18DTKT-S288 | CONN EDGECARD 36POS .125 EXTEND |
| RSM03DRKN | CONN EDGECARD 6POS DIP .156 SLD |
| GBA22DRMI-S288 | CONN EDGECARD 44POS .125 EXTEND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EFM32TG-STK3300 | 制造商:Energy Micro AS 功能描述:STARTER KIT STK3300 TINY GEC 制造商:Energy Micro AS 功能描述:STARTER KIT, STK3300, TINY GECKO; Silicon Manufacturer:Energy Micro; Core Architecture:ARM; Core Sub-Architecture:Cortex-M3; Silicon Core Number:EFM32TG840; Silicon Family Name:EFM32; Kit Contents:Starter Kit EFM32TG840; SVHC:No SVHC;RoHS Compliant: Yes |
| EFM32WG230F128 | 功能描述:ARM微控制器 - MCU 128kb flash 32kb RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| EFM32WG230F128-QFN64 | 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, WONDER GECKO - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 128KB FLASH 64QFN |
| EFM32WG230F128-QFN64T | 制造商:Energy Micro AS 功能描述:WONDER GECKO 32 BIT ARM CORTEX MCU - Trays |
| EFM32WG230F128-QFN64-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 128KB FLASH 64QFN |
發布緊急采購，3分鐘左右您將得到回復。