- 您現在的位置：買賣IC網 > PDF目錄376993 > DSC-544-I-1-R Digital-to-Synchro Converter PDF資料下載
參數資料
| 型號： | DSC-544-I-1-R |
| 英文描述： | Digital-to-Synchro Converter |
| 中文描述： | 數字到同步器 |
| 文件頁數： | 3/6頁 |
| 文件大小： | 185K |
| 代理商： | DSC-544-I-1-R |
positive and negative pulsating power supply voltage levels will
consistently be lower than the constant DC levels of the DC sup-
ply. Since the voltage levels are lower, the power consumed will
be much less. The power dissipated as heat is equal to the
amplifier current times the difference in voltage between the
power supply and the output. For the DSC-544, the power dissi-
pated is reduced by approximately 50% for reactive loads.
Another advantage of deriving power from the reference input is
that the amplifier section power is easily transformer-isolated
from the D/R converter. The converter output isolation trans-
former can therefore be located in front of the power amplifiers.
Since it does not transfer power, it can be made smaller and an
internal transformer can be used for 60 Hz.
Minimum load impedances are listed in TABLE 1, under Drive
Capability. The DSC-544 is capable of driving the specified load
impedances under worst case conditions. The minimum load
impedances correspond to 4.5 VA at 400 Hz and 1.5 VA at 60 Hz
when frequencies and voltage levels are at their nominal values.
Adequate air circulation is required over the metal top of the con-
verter module. A thermal cutout will disable the converter’s out-
put amplifiers if its internal temperature reaches 125°C.The out-
put is automaticlly restored when the temperature drops below
125°C.
3
+v
- v
+DC SUPPLY LEVEL
-DC SUPPLY LEVEL
POSITIVE PULSATING
SUPPLY VOLTAGE
NEGATIVE PULSATING
SUPPLY VOLTAGE
AMPLIFIER OUTPUT
VOLTAGE ENVELOPE
FIGURE 2. PULSATING POWER SUPPLY
VOLTAGE WAVEFORMS
30
90
150
210
270
330
360
C (DEGREES)
I
R
0
θ
S1-S3 = V SIN
θ + 120°)
S3-S2 = V SIN(
θ + 240°)
S2-S1 = V SIN(
- V
+ V
FIGURE 3. SYNCHRO OUTPUT SIGNALS
tal input angle. A(
θ
), which is called the scale factor variation, is
a smooth function of
θ
without discontinuities and is less than
±0.001 for all values of
θ
. The total maximum variation of Ao
(1 + A(
θ
)) is therefore ±2%. Because A(
θ
) is so small, the DSC-
544 can be used to drive systems such as X-Y plotters or CRT
displays in which the sine and cosine outputs are used indepen-
dently (not ratiometrically as in a control transformer).
S3
2/3 Zso
2/3 Zso
2/3 Zso
S1
S2
Zso
L
FIGURE 4. Z
SO
MEASUREMENT
OUTPUT PHASING AND SCALE FACTOR
The analog output signals have the following phase relationship
and are shown in FIGURE 3.
S1-S3 = (RH-RL) Ao [1 + A(
θ
) sin
θ
]
S3-S2 = (RH-RL) Ao [1 + A(
θ
) sin (
θ
+ 120
°
)]
S2-S1 = (RH-RL) Ao [1 + A(
θ)
sin (
θ
+ 240
°
)]
The output amplitudes simultaneously track the reference volt-
age fluctuations because they are proportional to (RH-RL). The
amplitude factor Ao is 90/115 for 90V rms L-L output. The max-
imum variation in Ao from all causes is ±1.9%.
term A(
θ
) represents the variation of the amplitude with the digi-
The
DRIVING CT AND CDX LOADS
When driving CT and CDX loads the DSC-544 must have
enough steady-state power capability to drive the Zso of the
load. Zso (stator impedance with rotor open-circuited) is mea-
sured as shown in FIGURE 4.
相關PDF資料 |
PDF描述 |
|---|---|
| DSC015 | High-Voltage Switching Diode |
| DSC30T | 3.0A Power Rectifier |
| DSC30TB | 3.0A Power Rectifier |
| DSC30TC | 3.0A Power Rectifier |
| DSC30TE | 3.0A Power Rectifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSC544I3 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Converter IC |
| DSC-544-I-3-R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital-to-Synchro Converter |
| DSC550100L | 功能描述:兩極晶體管 - BJT SM SIG TRANS FLT LD 2.0x2.1mm RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2 |
| DSC5501T0L | 功能描述:射頻雙極小信號晶體管 Small Sig Transistor 2.0x2.1mm Flat lead RoHS:否 制造商:NXP Semiconductors 配置:Single 晶體管極性:NPN 最大工作頻率:7000 MHz 集電極—發射極最大電壓 VCEO:15 V 發射極 - 基極電壓 VEBO:2 V 集電極連續電流:0.15 A 功率耗散:1000 mW 直流集電極/Base Gain hfe Min: 最大工作溫度:+ 150 C 封裝 / 箱體:SOT-223 封裝:Reel |
| DSC557-0343FI0 | 制造商:Discera 功能描述:- Cut Tape Product 制造商:Discera 功能描述:Discera DSC557-0343FI0 SMD Crystal Oscillators |
發布緊急采購，3分鐘左右您將得到回復。