• <form id="ieqqw"></form>
  • <center id="ieqqw"></center><form id="ieqqw"><em id="ieqqw"><xmp id="ieqqw">
    <dfn id="ieqqw"><input id="ieqqw"><legend id="ieqqw"></legend></input></dfn>
    參數資料
    型號: DS3254N+
    廠商: Maxim Integrated Products
    文件頁數: 19/71頁
    文件大?。?/td> 0K
    描述: IC LIU DS3/E3/STS-1 144-CSBGA
    產品培訓模塊: Lead (SnPb) Finish for COTS
    Obsolescence Mitigation Program
    標準包裝: 160
    類型: 線路接口裝置(LIU)
    驅動器/接收器數: 4/4
    規程: IEEE 1149.1
    電源電壓: 3.135 V ~ 3.465 V
    安裝類型: 表面貼裝
    封裝/外殼: 144-BGA,CSPBGA
    供應商設備封裝: 144-TECSBGA(13x13)
    包裝: 托盤
    DS3251/DS3252/DS3253/DS3254
    26 of 71
    In E3 mode, HDB3 decoding is performed. RLCV is asserted during any RCLK cycle where the data on RDAT
    causes one of the following code violations:
    Hardware mode or ITU bit set to 0
    A BPV immediately preceded by a valid pulse (B, V) or by a valid pulse and a zero (B, 0, V).
    A BPV with the same polarity as the last BPV.
    The fourth zero in an EXZ occurrence (only in hardware mode or when ITU = 0).
    ITU bit set to 1
    A BPV with the same polarity as the last BPV.
    When RLCV is asserted to flag a BPV, the RDAT pin outputs a one. The state bit that tracks the polarity of the last
    BPV is toggled on every BPV, whether part of a valid B3ZS/HDB3 codeword or not.
    To support a glueless interface to a variety of neighboring components, the polarity of RCLK can be inverted.
    Normally, data is output on the RPOS/RDAT and RNEG/RLCV pins on the falling edge of RCLK. To output data on
    these pins on the rising edge of RCLK, pull the RCINV pin high (hardware mode) or set the RCINV configuration bit
    in the RCR register (CPU bus mode).
    The RCLK, RPOS/RDAT, and RNEG/RLCV pins can be tri-stated to support protection switching and redundant-
    LIU applications. This tri-stating capability supports system configurations where two or more LIUs are wire-ORed
    together and a system processor selects one to be active. To tri-state RCLK, RPOS/RDAT, and RNEG/RLCV,
    assert the
    RTS pin or the RTS configuration bit in the RCR register.
    8.7 Receive Line-Code Violation Counter
    The line-code violation counter is always enabled regardless of the settings of the RBIN pin or the RBIN
    configuration bit. The receiver has an internal 16-bit saturating counter and a 16-bit latch, which the CPU can read
    as registers RCVH and RCVL. The value of the internal counter is latched into the RCVH/RCVL register and
    cleared when the receive code-violation counter update bit, RCR:RCVUD, is changed from a zero to a one. The
    RCVUD bit must be cleared back to a zero before a new update can occur. If there is an LCV increment pulse and
    an update pulse in the same clock period, the counter is preset to a one rather than cleared so that the LCV is not
    missed. The counter is incremented when the RLCV pin flags a code violation as described in Section 8.6. The
    counter saturates at 65,535 (0FFFFh) and does not roll over.
    8.8 Receiver Power-Down
    To minimize power consumption when the receiver is not being used, assert the RPD configuration bit in the RCR
    register (CPU bus mode). When the receiver is powered down, the RCLK, RPOS/RDAT, and RNEG/RLCV pins are
    tri-stated. In addition, the RXP and RXN pins become high impedance.
    8.9 Receiver Jitter Tolerance
    The receiver exceeds the input jitter tolerance requirements of all applicable telecommunication standards in Table
    相關PDF資料
    PDF描述
    DS33M33N+ IC MAPPER ETHERNET 256CSBGA
    DS33R11+CJ2 IC ETH TXRX T1/E1/J1 256-BGA
    DS33R41+ IC TXRX ETHERNET MAP 400-BGA
    DS33W11DK+ IC MAPPING ETHERNET 256-CSBGA
    DS33Z11+UNUSED IC ETHERNET MAPPER 169-CSBGA
    相關代理商/技術參數
    參數描述
    DS3254N# 功能描述:網絡控制器與處理器 IC Quad DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS3254N+ 功能描述:網絡控制器與處理器 IC Quad DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS3254NA3 制造商:Maxim Integrated Products 功能描述:QUAD ENH DS3/E3 LIU REV A3 IND - Rail/Tube
    DS3256 功能描述:網絡控制器與處理器 IC X6 T3/E3 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS3256N 功能描述:網絡控制器與處理器 IC X6 T3/E3 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray