- 您現在的位置：買賣IC網 > PDF目錄4588 > DS2401Z+T&R (Maxim Integrated Products)IC SILICON SERIAL NUMBER SOT223 PDF資料下載
參數資料
| 型號： | DS2401Z+T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SILICON SERIAL NUMBER SOT223 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | * |
| 其它名稱： | DS2401Z+T&RDKR |
DS2401
1-Wire SIGNALING
The DS2401 requires a strict protocol to ensure data integrity. The protocol consists of four types of
signaling on one line: reset sequence with Reset Pulse and Presence Pulse, write 0, write 1, and read data.
All these signals except Presence Pulse are initiated by the bus master.
The initialization sequence required to begin any communication with the DS2401 is shown in Figure 5.
A reset pulse followed by a Presence Pulse indicates the DS2401 is ready to send or receive data given
the correct ROM command.
The bus master transmits (TX ) a reset pulse (tRSTL , minimum 480s). The bus master then releases the
line and goes into receive mode (RX). The 1-Wire bus is pulled to a high state via the 5k pullup resistor.
After detecting the rising edge on the data pin, the DS2401 waits (tPDH, 15-60s) and then transmits the
Presence Pulse (tPDL, 60-240s). The 1-Wire bus requires a pullup resistor range of 1.5k to 5k,
depending on bus load characteristics.
READ/WRITE TIME SLOTS
The definitions of write and read time slots are illustrated in Figure 6. All time slots are initiated by the
master driving the data line low. The falling edge of the data line synchronizes the DS2401 to the master
by triggering a delay circuit in the DS2401. During write time slots, the delay circuit determines when the
DS2401 will sample the data line. For a read data time slot, if a “0” is to be transmitted, the delay circuit
determines how long the DS2401 will hold the data line low overriding the “1” generated by the master.
If the data bit is a 1, the DS2401 will leave the read data time slot unchanged.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2401P+T&R | IC SILICON SERIAL NUMBER 6-TSOC |
| GMC60DRYI-S13 | CONN EDGECARD 120POS .100 EXTEND |
| ABC43DRYN-S13 | CONN EDGECARD 86POS .100 EXTEND |
| ABC43DRYH-S13 | CONN EDGECARD 86POS .100 EXTEND |
| RCB70DHBS | CONN EDGECARD 140PS R/A .050 DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2404 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:EconoRAM Time Chip |
| DS2404-001 | 制造商:Maxim Integrated Products 功能描述:ECONORAM/TIME, DIP16 (GENERIC) - Rail/Tube |
| DS2404-001+ | 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK SERL 512BYTE 16PDIP - Rail/Tube |
| DS2404B | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS2404B/T&R | 制造商:Maxim Integrated Products 功能描述:ECONORAM/TIME, SSOP16-TRL (GENERIC) - Tape and Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。