- 您現在的位置：買賣IC網 > PDF目錄9174 > DS1848E-050+T&R (Maxim Integrated Products)IC RES/MEM TEMP 50/10K 14-TSSOP PDF資料下載
參數資料
| 型號： | DS1848E-050+T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 10/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RES/MEM TEMP 50/10K 14-TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1,000 |
| 接片： | 256 |
| 電阻（歐姆）： | 10k，50k |
| 電路數： | 2 |
| 溫度系數： | 標準值 850 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 95°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 帶卷 (TR) |
DS1848
2 of 17
PIN DESCRIPTIONS
Name TSSOP BGA
Description
VCC
14
A3
Power Supply Terminal. The DS1848 will support supply
voltages ranging from +3.0V to +5.5V.
GND
7
D1
Ground Terminal.
SDA
1
B2
2-Wire Serial Data Interface. The serial data pin is for serial data
transfer to and from the DS1848. The pin is open drain and may
be wire-ORed with other open drain or open collector interfaces.
SCL
2
A2
2-Wire Serial Clock Input. The serial clock input is used to
clock data into the DS1848 on rising edges and clock data out on
falling edges.
WP
6
C1
Write Protect Input. If open or set to logic 1, all memory, control
registers, and Look-up tables are write protected. If set to a logic 0, the
device is not write protected and can be written to. The WP pin is pulled
high internally.
A0
3
A1
Address Input. Pins A0, A1, and A2 are used to specify the
address of each DS1848 when used in a multi-dropped
configuration.
A1
4
B1
Address Input.
A2
5
C2
Address Input.
H0
13
A4
High terminal of Resistor 0. For both resistors, it is
not required that the high terminal be connected to a potential
greater than the low terminal. Voltage applied to the high terminal
of each resistor cannot exceed VCC, or go below ground.
H1
11
B3
High terminal of Resistor 1.
L0
8
D3
Low terminal of Resistor 0. For both resistors, it is
not required that the low terminal be connected to a potential less
than the high terminal. Voltage applied to the low terminal of each
resistor cannot exceed VCC, or go below ground.
L1
10
C4
Low terminal of Resistor 1.
NC
9
D4
No Connect.
NC
12
B4
No Connect.
NC
C3
No Connect.
NC
D2
No Connect.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-23K-MW | CONVERTER MOD DC/DC 40V 100W |
| 74LVX138MTCX | DECODER/DEMUX 1-OF-8 LV 16TSSOP |
| VE-23J-MX-B1 | CONVERTER MOD DC/DC 36V 75W |
| FS7140-02G-XTD | IC CLOCK GEN PLL PROGR 16-SSOP |
| DS1848E-010+T&R | IC RES/MEM TEMP 10/10K 14-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1849B-000 | 制造商:Maxim Integrated Products 功能描述:FINISAR INTEGRATED CIRCUIT - Rail/Tube |
| DS1849B-004 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| DS1849B-008 | 制造商:Maxim Integrated Products 功能描述:DUAL TEMPERATURE-CONTROLLED NV DAC - Rail/Tube |
| DS1849B-008+ | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| DS1851 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Dual Temperature-Controlled NV Digital-to-Analog Converters |
發布緊急采購，3分鐘左右您將得到回復。