參數資料
型號: DS1682S
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: Timer or RTC
英文描述: 0 TIMER(S), TIME RECORDER, PDSO8
封裝: 0.150 INCH, SOP-8
文件頁數: 12/14頁
文件大小: 202K
代理商: DS1682S
DS1682 Total-Elapsed-Time Recorder with Alarm
7 of 14
ALARM
The alarm register is a 32-bit register that holds time in quarter-second resolution. When a nonzero
number is programmed into the alarm register, the
ALARM function is enabled and the DS1682 monitors
the values in the ETC for the programmed value in the alarm register. When the ETC matches the alarm
value, the alarm flag is set.
EEPROM ARRAY
When power is applied, the contents of the EEPROM are transferred to the configuration register, alarm
register, ETC, event counter, and user memory. When the event pin goes low, VCC must remain above
VCC minimum for tEW to ensure the EEPROM is properly written.
The EEPROM array for the ETC and the event counter is made up of three banks. Each bank can be
written a maximum of 50k times. The device switches between banks based upon the value in the event
counter. Resetting the event counter before the counter reaches 50,000 will cause additional writes to the
first bank, which can allow writes in excess of 50k. If the event counter is set to greater than 50k or 100k
prior to reset, the device stays on the selected bank. This could result in writes in excess of 50k to one
bank.
The configuration and alarm registers and the user memory are held in one bank of EEPROM. Writes at
the end of an event only occur if the data has changed in one or more of those registers.
User-modified data in any of the registers is stored in EEPROM only if the data was written while an
event was active and is stored when the event ends.
EVENT COUNTER REGISTER
This 17-bit event counter register set provides the total number of data samples logged during the life of
the product up to 131,072 separate events. The event counter consists of 2 bytes of memory in the
memory map plus the event counter MSB bit (ECMSB) in the configuration register. Once the event
counter reaches 1FFFFh, event counting stops.
RESET COMMAND
If RE is set to a 1, a reset occurs when a reset command is sent through the 2-wire bus. A reset command
is issued by writing 55h twice into memory location 1Dh. The writes need not be consecutive. Cycling
power on VCC prior to the second write terminates the reset sequence.
Upon reset, the ETC and event counter registers are cleared. The AF, RE, and ECMSB bits are cleared by
the device, and the configuration register becomes read-only. The data are written to the EEPROM, and
additional resets are ignored.
When a reset command is issued, no additional command should be issued during the EEPROM write
time (tEW).
相關PDF資料
PDF描述
DS1682 0 TIMER(S), TIME RECORDER, PDSO8
DS1685-3 1 TIMER(S), REAL TIME CLOCK, PDIP24
DS1687-5 1 TIMER(S), REAL TIME CLOCK, PDIP24
DS1685Q-3 1 TIMER(S), REAL TIME CLOCK, PQCC28
DS1685S-3 1 TIMER(S), REAL TIME CLOCK, PDSO24
相關代理商/技術參數
參數描述
DS1682S/GG8 制造商:Maxim Integrated Products 功能描述:
DS1682S/T&R 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK SERL 10BYTE 8SOIC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC TIMEKEEPER ALARM ELAPSE 8SOIC
DS1682S/T&R 功能描述:實時時鐘 Total-Elapsed-Time Recorder w/Alarm RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS1682S/TR 制造商:Maxim Integrated Products 功能描述:
DS1682S+ 功能描述:實時時鐘 Total-Elapsed-Time Recorder w/Alarm RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube