- 您現在的位置：買賣IC網 > PDF目錄376954 > DS1620S IC-SM-DIGITAL THERMOMETER PDF資料下載
參數資料
| 型號： | DS1620S |
| 元件分類： | 溫度傳感器 |
| 英文描述： | IC-SM-DIGITAL THERMOMETER |
| 中文描述： | 集成電路釤數字溫度計 |
| 文件頁數： | 6/13頁 |
| 文件大?。?/td> | 539K |
| 代理商： | DS1620S |
DS1620
6 of 13
operation of the CLK/
CONV
pin is as a normal clock in concert with DQ and
RST
. This bit is stored in
nonvolatile E
2
memory, capable of at least 50,000 writes. The DS1620 is shipped with CPU=0.
1SHOT = One–Shot Mode. If 1SHOT is 1, the DS1620 will perform one temperature conversion upon
reception of the Start Convert T protocol. If 1SHOT is 0, the DS1620 will continuously perform
temperature conversion. This bit is stored in nonvolatile E
2
memory, capable of at least 50,000 writes.
The DS1620 is shipped with 1SHOT=0.
For typical thermostat operation, the DS1620 will operate in continuous mode. However, for applications
where only one reading is needed at certain times or to conserve power, the one–shot mode may be used.
Note that the thermostat outputs (T
HIGH
, T
LOW
, T
COM
) will remain in the state they were in after the last
valid temperature conversion cycle when operating in one–shot mode.
OPERATION IN STAND–ALONE MODE
In applications where the DS1620 is used as a simple thermostat, no CPU is required. Since the
temperature limits are nonvolatile, the DS1620 can be programmed prior to insertion in the system. In
order to facilitate operation without a CPU, the CLK/
CONV
pin (pin 2) can be used to initiate
conversions. Note that the CPU bit must be set to 0 in the configuration register to use this mode of
operation. Whether CPU=0 or 1, the 3–wire port is active. Setting CPU=1 disables the stand–alone mode.
To use the CLK/
CONV
pin to initiate conversions,
RST
must be low and CLK/
CONV
must be high. If
CLK/
CONV
is driven low and then brought high in less than 10 ms, one temperature conversion will be
performed and then the DS1620 will return to an idle state. If CLK/
CONV
is driven low and remains low,
continuous conversions will take place until CLK/
CONV
is brought high again. With the CPU bit set to 0,
the CLK/
CONV
will override the 1SHOT bit if it is equal to 1. This means that even if the part is set for
one–shot mode, driving CLK/
CONV
low will initiate conversions.
3–WIRE COMMUNICATIONS
The 3–wire bus is comprised of three signals. These are the
RST
(reset) signal, the CLK (clock) signal,
and the DQ (data) signal. All data transfers are initiated by driving the
RST
input high. Driving the
RST
input low terminates communication. (See Figures 4 and 5.) A clock cycle is a sequence of a falling edge
followed by a rising edge. For data inputs, the data must be valid during the rising edge of a clock cycle.
Data bits are output on the falling edge of the clock and remain valid through the rising edge.
When reading data from the DS1620, the DQ pin goes to a high-impedance state while the clock is high.
Taking
RST
low will terminate any communication and cause the DQ pin to go to a high-impedance
state.
Data over the 3–wire interface is communicated LSB first. The command set for the 3–wire interface as
shown in Table 3 is as follows.
Read Temperature [AAh]
This command reads the contents of the register which contains the last temperature conversion result.
The next nine clock cycles will output the contents of this register.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1620 | Digital Thermometer and Thermostat |
| DS1629 | 2-Wire Digital Thermometer and Real Time Clock |
| DS1630ABL-70 | NVRAM (Battery Based) |
| DS1630ABL-70-IND | NVRAM (Battery Based) |
| DS1630ABL-85 | NVRAM (Battery Based) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1620S/T&R | 制造商:Maxim Integrated Products 功能描述:DIGITAL THERM. 8P SO 208M TRL - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC THERMOMETER/STAT DIG 8-SOIC |
| DS1620S/T&R | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS1620S+ | 功能描述:板上安裝溫度傳感器 Digital Thermometer & Thermostat RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS1620S+T&R | 制造商:Maxim Integrated Products 功能描述:TEMP SENSOR DGTL 3-WIRE 8SOIC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC THERMOMETER/STAT DIG 8-SOIC 制造商:Maxim Integrated Products 功能描述:Board Mount Temperature Sensors Digital Thermometer & Thermostat |
| DS1620S+T&R/C01 | 制造商:Maxim Integrated Products 功能描述:DIGITAL THERMOMETER AND THERMOSTAT - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。