- 您現在的位置：買賣IC網 > PDF目錄376952 > DS1395S RAMified Real Time Clock PDF資料下載
參數資料
| 型號： | DS1395S |
| 英文描述： | RAMified Real Time Clock |
| 中文描述： | 網狀實時時鐘 |
| 文件頁數： | 2/19頁 |
| 文件大?。?/td> | 193K |
| 代理商： | DS1395S |
DS1395/DS1397
020794 2/19
PIN DESCRIPTIONS
V
DD,
V
SS
–
Bus operational power is supplied to the part
via these pins. The voltage level present on these pins
should be monitored to transition between operational
power and battery power.
D0-D7 – Data Bus (bidirectional):
Data is written into
the device from the data bus if either XRAM or RTC is
asserted during a write cycle at the rising edge of a WR
pulse. Data is read from the device and driven onto the
data bus if either XRAM or RTC is asserted during a
read cycle when the RD signal is low.
A0-A5 – Address Bus (input):
Various internal regis-
ters of the device are selected by these lines. When
RTC is asserted, A0 selects between the indirect ad-
dress register and RTC data register. When the XRAM
is asserted, A0-A5 addresses a 32–byte page of RAM.
When A5 is high, the RAM page register is accessible.
When A5 is low, A0-A4 address the 32-byte page of
RAM.
RD - Read Strobe (input):
Data is read from the se-
lected register and driven onto the data bus by the de-
vice when this line is low and either RTC or XRAM is as-
serted.
WR - Write Strobe (input):
Data is written into the de-
vice from the data bus on the rising edge after a low
pulse on this line when the device has been selected by
either the XRAM or RTC signals.
STBY - Standby (input):
Accesses to the device are
inhibited and outputs are tri-stated to a high impedance
state when this signal is asserted low. All data in RAM of
the device is preserved. The real time clock continues
to keep time.
If a read or write cycle is in progress when the STBY sig-
nal is asserted low, the internal cycle will be terminated
when either the external cycle completes or when the in-
ternal chip enable condition (V
DD
is 4.25 volts, typical) is
negated, whichever occurs first.
RTC - Real Time Clock Select (input):
When this sig-
nal is asserted low, the real time clock registers are ac-
cessible. Registers are selected by the A0 line. Data is
driven onto the data bus when RD is low. Data is re-
ceived from the bus when WR is pulsed low and then
high.
SQW - Square Wave (output):
Frequency selectable
output. Frequency is selected by setting register A bits
RS0-RS3. See Table 2 for frequencies that can be se-
lected.
XRAM - Extended RAM Select (input):
When this sig-
nal is asserted low, the extended RAM bytes are acces-
sible. The XRAM page register is selected when the A5
address line is high. A 32-byte page of RAM is accessi-
ble when A5 is low. A0-A4 select the bytes within the
page of RAM pointed to by the page register. Data is
driven onto the data bus when RD is low. Data is re-
ceived from the bus when WR is pulsed low and then
high.
IRQ - Interrupt Request (output):
The IRQ signal is an
active low, open drain output that is used as a processor
interrupt request. The IRQ output follows the state of
the IRQF bit (bit 7) in status register C. IRQ can be as-
serted by the alarm, update ended, or periodic interrupt
functions depending on the configuration of register B.
RESET - Reset (input):
The reset signal is used to ini-
tialize certain registers to allow proper operation of the
RTC module. When RESET is low, the following oc-
curs.
1. The following register bits are cleared:
a. Periodic interrupt (PIE)
b. Alarm interrupt enable (AIE)
c. Update ended interrupt (UF)
d. Interrupt request flag (IRQF)
e. Periodic interrupt flag (PF)
f. Alarm interrupt flag (AF)
g. Square wave output enable (SQWE)
h. Update ended interrupt enable (UIE)
2. The IRQ pin is in the high impedance state.
3. The RTC is not processor accessible.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1402D-41 | iButton Probe Component Parts |
| DS1402 | iButton Probe Component Parts |
| DS1402D-003 | iButton Probe Component Parts |
| DS1402D-010 | iButton Probe Component Parts |
| DS1402D-011 | iButton Probe Component Parts |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1395SN | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Peripheral IC |
| DS1397 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:RAMified Real Time Clock |
| DS-14 | 功能描述:非熱縮管和套管 FLEX BRAIDED SHIELD 14MM X 100M ROLL RoHS:否 制造商:Panduit 產品:Cable Wraps 類型:Spiral 顏色:Black 材料:PP 內徑:0.03 in 長度:100 ft |
| DS14-00 | 制造商:FLOWLINE 功能描述:Sensor, Liquid Level, Ultrasonic Switch/Control 4 Relays; Range 49.2 in, 1NPT |
| DS1-40-0001 | 制造商:SCHURTER 制造商全稱:Schurter Inc. 功能描述:Storage Choke, fully potted resign |
發布緊急采購，3分鐘左右您將得到回復。