參數資料
型號: DM164134
廠商: Microchip Technology
文件頁數: 72/116頁
文件大小: 0K
描述: KIT DEV PIC18F4XK22
標準包裝: 1
系列: PIC® 18F
類型: MCU
適用于相關產品: PIC18F4XK22,PIC18F2XK22
所含物品: 板,文檔
2006 Microchip Technology Inc.
DS41159E-page 57
PIC18FXX8
4.13
Status Register
The Status register, shown in Register 4-2, contains the
arithmetic status of the ALU. The Status register can be
the destination for any instruction, as with any other
register. If the Status register is the destination for an
instruction that affects the Z, DC, C, OV or N bits, then
the write to these five bits is disabled. These bits are set
or cleared according to the device logic. Therefore, the
result of an instruction with the Status register as
destination may be different than intended.
For example, CLRF STATUS will clear the upper three
bits and set the Z bit. This leaves the Status register as
000u u1uu
(where u = unchanged).
It is recommended, therefore, that only BCF, BSF,
SWAPF,
MOVFF
and MOVWF instructions are used to
alter the Status register, because these instructions do
not affect the Z, C, DC, OV or N bits from the Status
register. For other instructions which do not affect the
status bits, see Table 25-2.
REGISTER 4-2:
STATUS REGISTER
Note:
The C and DC bits operate as a Borrow
and Digit
Borrow bit respectively, in
subtraction.
U-0
R/W-x
—N
OV
Z
DC
C
bit 7
bit 0
bit 7-5
Unimplemented: Read as ‘0’
bit 4
N: Negative bit
This bit is used for signed arithmetic (2’s complement). It indicates whether the result of the ALU
operation was negative (ALU MSb = 1).
1
= Result was negative
0
= Result was positive
bit 3
OV: Overflow bit
This bit is used for signed arithmetic (2’s complement). It indicates an overflow of the 7-bit
magnitude which causes the sign bit (bit 7) to change state.
1
= Overflow occurred for signed arithmetic (in this arithmetic operation)
0
= No overflow occurred
bit 2
Z: Zero bit
1
= The result of an arithmetic or logic operation is zero
0
= The result of an arithmetic or logic operation is not zero
bit 1
DC: Digit Carry/Borrow bit
For ADDWF, ADDLW, SUBLW and SUBWF instructions:
1
= A carry-out from the 4th low-order bit of the result occurred
0
= No carry-out from the 4th low-order bit of the result
Note:
For Borrow, the polarity is reversed. A subtraction is executed by adding the 2’s
complement of the second operand. For rotate (RRCF, RRNCF, RLCF and RLNCF)
instructions, this bit is loaded with either bit 4 or bit 3 of the source register.
bit 0
C: Carry/Borrow bit
For ADDWF, ADDLW, SUBLW and SUBWF instructions:
1
= A carry-out from the Most Significant bit of the result occurred
0
= No carry-out from the Most Significant bit of the result occurred
Note:
For Borrow, the polarity is reversed. A subtraction is executed by adding the 2’s
complement of the second operand. For rotate (RRF, RLF) instructions, this bit is
loaded with either the high or low-order bit of the source register.
Legend:
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
-n = Value at POR
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
相關PDF資料
PDF描述
AIUR-07-221K INDUCTOR POWER 220UH 10% T/H
MAX8903CETI+ IC DC/DC CHARGER LI+ 2A 28-TQFN
MAX11080GUU/V+T IC LI/BATTERY MANAGEMENT 38TSSOP
MAX11081GUU+T IC FAULT MON BATT 12CH 38-TSSOP
MAX11081GUU/V+T IC FAULT MON BATT 12CH 38TSSOP
相關代理商/技術參數
參數描述
DM164135 制造商:Microchip Technology Inc 功能描述:KIT, ONEPIC DEMO BOARD, PLUS PICKIT 3 制造商:Microchip Technology Inc 功能描述:KIT, ONEPIC DEMO BOARD, PLUS PICKIT 3; SVHC:No SVHC (19-Dec-2012) ;RoHS Compliant: Yes 制造商:Microchip Technology Inc 功能描述:One PIC MCU Platform Board with PICkit 3
DM164135 制造商:Microchip Technology Inc 功能描述:PICKIT 3 IN-CIRCUIT DEBUGGER
DM173001 功能描述:開發板和工具包 - PIC / DSPIC PICDEM 17 PIC17CXX RoHS:否 制造商:Microchip Technology 產品:Starter Kits 工具用于評估:chipKIT 核心:Uno32 接口類型: 工作電源電壓:
DM180021 功能描述:開發板和工具包 - PIC / DSPIC PIC18 Starter Kit RoHS:否 制造商:Microchip Technology 產品:Starter Kits 工具用于評估:chipKIT 核心:Uno32 接口類型: 工作電源電壓:
DM1800-434MB 功能描述:射頻模塊 DM1800 Base Station 433.92 MHz RoHS:否 制造商:Linx Technologies 產品:Transceiver Modules 頻帶:902 MHz to 928 MHz 輸出功率:- 15.5 dBm to + 12.5 dBm 接口類型:UART 工作電源電壓:- 0.3 VDC to + 5.5 VDC 傳輸供電電流:38.1 mA 接收供電電流:22.7 mA 天線連接器類型:U.FL 最大工作溫度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm