- 您現在的位置：買賣IC網 > PDF目錄366891 > CR16HCT9VJE8 Microcontroller PDF資料下載
參數資料
| 型號： | CR16HCT9VJE8 |
| 英文描述： | Microcontroller |
| 中文描述： | 微控制器 |
| 文件頁數： | 50/157頁 |
| 文件大?。?/td> | 1256K |
| 代理商： | CR16HCT9VJE8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁
www.national.com
50
External Event Clock
The TnB I/O pin can be configured to operate as an external
event input clock for either of the two 16-bit counters. This in-
put can be programmed to detect either rising or falling edg-
es. The minimum pulse width of the external signal is one
system clock cycle. This means that the maximum frequency
at which the counter can run in this mode is one-half of the
system clock frequency. This clock source is not available in
the capture modes (modes 2 and 4) because the TnB pin is
used as one of the two capture inputs.
Pulse Accumulate Mode
The counter can also be configured to count prescaler output
clock pulses when the TnB is high and not count when TnB
is low, as illustrated in Figure 13. The resulting count is an in-
dicator of the cumulative time that TnB is high. This is called
the “pulse accumulate” mode. In this mode, an AND gate
generates a clock signal for the counter whenever a prescal-
er clock pulse is generated and TnB input is high. (The polar-
ity of the TnB signal is programmable, so the counter can
count when TnB is low rather than high.) The pulse accumu-
late mode is not available in the capture modes (modes 2 and
4) because the TnB pin is used as one of the two capture in-
puts.
Slow Clock
The slow clock is generated by the Dual Clock and Reset
(CLK2RES) module. The clock source is either the divided
fast clock or the external 32.768 kHz clock crystal (if available
and selected). The slow clock can be used as the clock
source for the two 16-bit counters. Because the slow clock
can be asynchronous to the system clock, a circuit is provid-
ed to synchronize the clock signal to the high-frequency sys-
tem clock before it is used for clocking the counters. The
synchronization circuit requires that the slow clock operate at
no more than one-fourth the speed of the system clock.
Limitations in Low-Power Modes
The Power Save mode uses the low-frequency clock as the
system clock. In this mode, the slow clock cannot be used as
a clock source for the timers because both CLK and SLCLK
are driven then at the same frequency, and the 2:1 system-
clock to input clock ratio needed for the synchronization can-
not be maintained. However, the External Event Clock and
Pulse Accumulate Mode will still work, as long as the external
event pulses are at least the size of the whole slow-clock pe-
riod. Using the prescaled system clock will also work, but at
a much slower rate than the original system clock.
Some Power Save modes stops the system clock (the high-
frequency and/or low-frequency clock) completely. If the sys-
tem clock is stopped, the timer stops counting until the sys-
tem clock resumes operation.
I
n the Idle or Halt mode, the system clock stops completely,
which stops the operation of the timers. In that case, the tim-
ers stop counting until the system clock resumes operation.
Figure 12.
Clock Source Block Diagram
Prescaler Register
TnPRSC
Prescaler Counter
5-bit
System
Clock
Reset
TnB
Pulse
Accumulate
External
Event
No Clock
Prescaled
Clock
Counter I
Clock
Select
Counter II
Clock
Select
Counter I
Clock
Counter II
Clock
Synchr.
Figure 13.
Pulse Accumulate Mode Operation
TnB
Prescaler Output
Counter Clock
相關PDF資料 |
PDF描述 |
|---|---|
| CR16HCT9VJE8Y | Microcontroller |
| CR16HCT9VJE9 | Microcontroller |
| CR16HCT9VJE9Y | Microcontroller |
| CR16MCT5VJE8Y | Microcontroller |
| CR16MCT5VJE9Y | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CR16HCT9VJE8Y | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| CR16HCT9VJE9 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| CR16HCT9VJE9Y | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| CR16HCT9VJEX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CR16MCT9/CR16MCT5/CR16HCT9/CR16HCT5 16-Bit Reprogrammable/ROM Microcontroller |
| CR16HCT9VJEXY | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CR16MCT9/CR16MCT5/CR16HCT9/CR16HCT5 16-Bit Reprogrammable/ROM Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。