- 您現在的位置：買賣IC網 > PDF目錄384222 > CM1481 Non-Predictive Selcall Module PDF資料下載
參數資料
| 型號： | CM1481 |
| 英文描述： | Non-Predictive Selcall Module |
| 中文描述： | 非預測Selcall模塊 |
| 文件頁數： | 16/24頁 |
| 文件大?。?/td> | 162K |
| 代理商： | CM1481 |
16
Functional Descriptions
Lead-In
Delay
PTT Out
(active "low")
Tone Out
Selcall Tones
Lead-In
Delay
Tone Out
Tone Out
Lead-In Tone with No Gap
Lead-In Delay
Lead-In Tone with Gap
--
the gap is 1 tone-length
Selcall
Tones
Selcall
Tones
Lead-In
Tone
Lead-In
Tone
The CM1481 has two audio operational modes -
Quiet/Open operations are initiated by:
(i) Pressing the Quiet/Open button (Dual Button operation) or a short press of the
Operate button (Single Button operation).
‘Quiet and Open’
.
Quiet operations are initiated by:
(i) A Timed Mute Reset operation.
(ii) A Remote Reset command received.
Quiet
The radio Rx audio is muted.
PTT (Tx) action is disabled.
Selcalling can either be disabled or enabled via initial configuration. There are no operational
alerts except for PTT and Call Action Disabled or Selcall Transmitted (if configured).
Open
Open modes can be configured to either
Unmuted
If called in an “Open” mode received Selcall tones will be output at the loudspeaker.
Configured as Open Mode:
Unmuted:
The radio is unmuted (MUTE CTRL inactive) and the loudspeaker (hash) is enabled. All
functions are enabled and operate as configured.
Transparent:
The radio audio circuits act as if squelched; Audio output is dependant upon the presence
of an RF carrier (BUSY input). MUTE CTRL is only inactive if the BUSY input is active.
or
Transparent
states.
Quiet/Open
Modes
Lead-In Tone
To operate on and gain access to, repeater systems the Selcall address output of the
module can be preceded by an extended tone. At configuration the tone operation, fre-
quency and length can be set; if required a single Selcall tone-period gap between the
lead-In tone and the Selcall address may be set.
Confgured as Lead-In Tone Length:, Lead-In Tone Dgt: and Lead-In Gap:
A configurable delay period between the operation of the PTT and the Selcall Tone output
from the module. This function is available to allow sufficient time for the transmitter to
stabilize before modulation.
Configured as Lead-In Delay:
Fig.9 Lead-In Tone and Delay
相關PDF資料 |
PDF描述 |
|---|---|
| CM150DY12E | TRANSISTOR | IGBT POWER MODULE | HALF BRIDGE | 600V V(BR)CES | 150A I(C) |
| CM150E3Y12E | TRANSISTOR | IGBT POWER MODULE | INDEPENDENT | 600V V(BR)CES | 150A I(C) |
| CM150E3Y24E | TRANSISTOR | IGBT POWER MODULE | INDEPENDENT | 1.2KV V(BR)CES | 150A I(C) |
| CM150DY24E | TRANSISTOR | IGBT POWER MODULE | HALF BRIDGE | 1.2KV V(BR)CES | 150A I(C) |
| CM200DU12H | TRANSISTOR | IGBT POWER MODULE | HALF BRIDGE | 600V V(BR)CES | 200A I(C) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CM1481-02DE | 功能描述:電磁干擾濾波器 2-ch Headset Speaker EMI Filter with ESD RoHS:否 制造商:STMicroelectronics 電容:12 pF 電路類型: 最大直流電流: 最大直流電阻: 電壓額定值:6 V 容差: 端接類型:SMD/SMT 工作溫度范圍:- 30 C to + 85 C 系列:EMIF03 |
| CM1482 | 制造商:CML 制造商全稱:Chicago Miniature Lamp,inc 功能描述:G-4 1/2 Miniature Bayonet Base |
| CM1482-02DE | 功能描述:電磁干擾濾波器 2-ch Headset Mic EMI Filter with ESD RoHS:否 制造商:STMicroelectronics 電容:12 pF 電路類型: 最大直流電流: 最大直流電阻: 電壓額定值:6 V 容差: 端接類型:SMD/SMT 工作溫度范圍:- 30 C to + 85 C 系列:EMIF03 |
| CM1483 | 制造商:CML 制造商全稱:Chicago Miniature Lamp,inc 功能描述:G-4 1/2 Miniature Bayonet Base |
| CM1483-02DE | 功能描述:電磁干擾濾波器 L-C EMI Filter with ESD Protection RoHS:否 制造商:STMicroelectronics 電容:12 pF 電路類型: 最大直流電流: 最大直流電阻: 電壓額定值:6 V 容差: 端接類型:SMD/SMT 工作溫度范圍:- 30 C to + 85 C 系列:EMIF03 |
發布緊急采購，3分鐘左右您將得到回復。