- 您現在的位置：買賣IC網 > PDF目錄379870 > CE6353 (Intel Corp.) Nordig Unified DVB-T COFDM Terrestrial Demodulator for PC-TV and Hand-held Digital TV (DTV) PDF資料下載
參數資料
| 型號： | CE6353 |
| 廠商： | Intel Corp. |
| 英文描述： | Nordig Unified DVB-T COFDM Terrestrial Demodulator for PC-TV and Hand-held Digital TV (DTV) |
| 中文描述： | NorDig統一的DVB - T的COFDM地面解調器為PC - TV和手持式數字電視（DTV） |
| 文件頁數： | 15/26頁 |
| 文件大小： | 322K |
| 代理商： | CE6353 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
CE6353
Data Sheet
15
Intel Corporation
3.0 Interfaces
3.1 2-Wire Bus
3.1.1 Host
The primary 2-wire bus serial interface uses pins:
DATA1 (pin 5) serial data, the most significant bit is sent first.
CLK1 (pin 4) serial clock.
The 2-wire bus address is determined by applying VDD or VSS to the SADD[4:0] pins.
In TNIM evaluation applications, the 2-wire bus address is 0001 111 R/W with the pins connected as follows:
When the CE6353 is powered up, the RESET pin 9 should be held low for at least 50 ms after VDD has reached
normal operation levels. As the RESET pin goes high, the logic levels on SADD[4:0] are latched as the 2-wire bus
address. ADDR[0] is the R/W bit.
The circuit works as a slave transmitter with the lsb set high or as a slave receiver with the lsb set low. In receive
mode, the first data byte is written to the RADD virtual register, which forms the register sub-address. The RADD
register takes an 8-bit value that determines which of 256 possible register addresses is written to by the following
byte. Not all addresses are valid and many are reserved registers that must not be changed from their default
values. Multiple byte reads or writes will auto-increment the value in RADD, but care should be taken not to access
the reserved registers accidentally.
Following a valid chip address, the 2-wire bus STOP command resets the RADD register to 00. If the chip address
is not recognized, the CE6353 will ignore all activity until a valid chip address is received. The 2-wire bus START
command does NOT reset the RADD register to 00. This allows a combined 2-wire bus message, to point to a
particular read register with a write command, followed immediately with a read data command. If required, this
could next be followed with a write command to continue from the latest address. RADD would not be sent in this
case. Finally, a STOP command should be sent to free the bus.
When the 2-wire bus is addressed (after a recognized STOP command) with the read bit set, the first byte read out
is the contents of register 00.
3.1.2 Tuner
The CE6353 has a General Purpose Port that can be configured to provide a secondary 2-wire bus. See register
GPP_CTL address 0x8C.
Master control mode is selected by setting register SCAN_CTL (0x62) [b3] = 1.
The allocation of the pins is: GPP0 pin 35 = CLK2, GPP1 pin 36 = DATA2.
ADDR[7]
ADDR[6]
ADDR[5]
ADDR[4]
ADDR[3]
ADDR[2]
ADDR[1]
Not programmable
SADD[1]
SADD[0]
VSS
VSS
VSS
VDD
VDD
VDD
VDD
相關PDF資料 |
PDF描述 |
|---|---|
| CE66P1 | 0.35um CMOS Technology |
| CE66P2 | 0.35um CMOS Technology |
| CE66P3 | 0.35um CMOS Technology |
| CE66P4 | 0.35um CMOS Technology |
| CE66P5 | 0.35um CMOS Technology |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CE645W5H56VJIBF | 制造商: 功能描述: 制造商:undefined 功能描述: |
| CE64MGMVA-F1050-D | 制造商:Delkin Devices 功能描述:64GB CF, SLC NAND, -40 TO 85C OPERATING TEMP, LOCKED BOM, MA - Bulk |
| CE66 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:0.35um CMOS Technology |
| CE66.5100.151 | 功能描述:交流電源輸入模塊 CE PWR ENTRY MODULE W. FILTER 10A RoHS:否 制造商:Schurter 過濾:Yes 過濾器類型:IEC Inlet Filters 產品:Inlets 電流額定值:4 A 電壓額定值:250 VAC 外殼材料:Thermoplastic 安裝風格:Panel, Screw 端接類型:Quick Connect 工作溫度范圍:- 25 C to + 85 C 連接器類型:C-14 |
| CE66P1 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:0.35um CMOS Technology |
發布緊急采購，3分鐘左右您將得到回復。