- 您現在的位置：買賣IC網 > PDF目錄379737 > CC2420DK (Electronic Theatre Controls, Inc.) LC2MOS 5 O RON SPST Switch; Package: PDIP; No of Pins: 16; Temperature Range: Industrial PDF資料下載
參數資料
| 型號： | CC2420DK |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | LC2MOS 5 O RON SPST Switch; Package: PDIP; No of Pins: 16; Temperature Range: Industrial |
| 中文描述： | 2.4 GHz IEEE 802.15.4標準/ ZigBee功能的RF收發器 |
| 文件頁數： | 57/87頁 |
| 文件大小： | 1418K |
| 代理商： | CC2420DK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁
SmartRF
CC2420
of security even with a low-cost 8 bit
controller.
Low cost systems
As the
CC2420
provides 250 kbps multi-
channel performance without any external
filters, a very low cost system can be
made.
A differential antenna will eliminate the
need for a balun, and the DC biasing can
be achieved in the antenna topology.
Battery operated systems
In low power applications, the
CC2420
should be powered down when not being
active. Extremely low power consumption
may be achieved when disabling also the
voltage
regulator.
reprogramming of the register and RAM
configuration.
This
will
require
BER / PER measurements
CC2420
includes test modes where data is
received infinitely and output to pins
(
RX_MODE
2, see page 38). This mode
may be used for Bit Error Rate (BER)
measurements. However, the following
actions must be taken to do such a
measurement:
A preamble and SFD sequence
must be used, even if pseudo
random data is transmitted, since
receiving the DSSS modulated
signal
requires
synchronisation,
synchronisation like e.g. in 2FSK
systems. The
SYNCWORD
may be
set to another value to fit to the
measurement setup if necessary.
symbol
not
bit
The data transmitted over air must
be spread according to [1] and the
description on page 22. This
means that the transmitter used
during measurements must be
able to do spreading of the bit
data to chip data. Remember that
the
chip
sequence transmitted by
the test setup is not the same as
the
bit
sequence, which is output
by
CC2420
.
When operating at or below the
sensitivity limit,
CC2420
may lose
symbol synchronisation in infinite
receive mode. A new SFD and
restart of the receiver may be
required
to
synchronisation.
re-gain
In
communication is based on packets. The
sensitivity limit specified by [1] is based on
Packet Error Rate (PER) measurements
instead of BER. This is a more accurate
measurement of the true RF performance
since it mirrors the way the actual system
operates.
an
IEEE
802.15.4
system,
all
Chipcon recommends performing PER
measurements
instead
measurements
to
performance of IEEE 802.15.4 systems.
To do PER measurements, the following
may be used as a guideline:
of
BER
the
evaluate
A valid preamble, SFD and length
field must be used for each
packet.
The PSDU (see Figure 16 on
page 34) length should be 20
bytes for sensitivity measurements
as specified by [1].
The sensitivity limit specified by [1]
is the RF level resulting in a 1%
PER. The packet sample space
for a given measurement must
then be >> 100 to have a
sufficiently large sample space.
E.g. at least 1000 packets should
be
used
to
sensitivity.
measure
the
The data transmitted over air must
be spread according to [1] and the
description on page 22. Pre-
generated packets may be used,
although [1] requires that the PER
is averaged over random PSDU
data.
The
CC2420
receive FIFO may be
used to buffer data received
during PER measurements, since
it is able to buffer up to 128 bytes.
The
control register should be set to
MDMCTRL1.CORR_THR
Chipcon AS
SmartRF
CC2420 Preliminary Datasheet (rev 1.2), 2004-06-09
Page 57 of 87
相關PDF資料 |
PDF描述 |
|---|---|
| CC2420SK | 2.4 GHz IEEE 802.15.4 / ZigBee-ready RF Transceiver |
| CC4V | SM WATCH CRYSTAL MIL TEMP |
| CC4V-T1 | SM WATCH CRYSTAL MIL TEMP |
| CC5003GAP | ISOLATED RESISTOR NETWORK |
| CC5003DG | ISOLATED RESISTOR NETWORK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CC2420EMK | 功能描述:Zigbee/802.15.4開發工具 CC2420 EVALUATION KT (2)PCBs & (2)ANTENNA RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:EM35x 頻率:2.4 GHz 接口類型:USB 工作電源電壓: |
| CC2420RGZ | 制造商:Texas Instruments 功能描述:IC, RF TXRX, 2400MHZ TO 2483.5MHZ, QLP48; Frequency Min:2.4GHz; Frequency Max:2.4835GHz; Modulation Type:O-QPSK; Receiving Current:18.8mA; Transmitting Current:17.4mA; RF IC Case Style:QLP; No. of Pins:48; Supply Voltage Min:1.6V |
| CC2420RGZR | 制造商:Texas Instruments 功能描述:IC, RF TXRX, 2400MHZ TO 2483.5MHZ, QLP48; Frequency Min:2.4GHz; Frequency Max:2.4835GHz; Modulation Type:O-QPSK; Data Rate:250Kbps; Receiving Current:18.8mA; RF IC Case Style:QLP; No. of Pins:48; Supply Voltage Min:1.6V ;RoHS Compliant: Yes |
| CC2420RGZT | 制造商:Texas Instruments 功能描述:IC RF TXRX ZIGBEE 2.4GHZ 48VQFN |
| CC2420-RTB1 | 功能描述:射頻收發器 Sgl-Chip 2.4GHz IEEE & ZigBee Ready RF RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。