- 您現在的位置：買賣IC網 > PDF目錄379714 > C10013SK (Hamamatsu Photonics) Flat panel sensor High reliability, high sensitivity PDF資料下載
參數資料
| 型號： | C10013SK |
| 廠商： | Hamamatsu Photonics |
| 英文描述： | Flat panel sensor High reliability, high sensitivity |
| 中文描述： | 平板傳感器高可靠性，高靈敏度 |
| 文件頁數： | 4/6頁 |
| 文件大?。?/td> | 132K |
| 代理商： | C10013SK |
Flat panel sensor
C10013SK
4
I
System requirements
To operate C10013SK at full performance, the following system and peripherals are required.
· PC: IBM compatible PC running on Windows XP
· Digital frame grabber card: Monochrome 16 bits or more, pixel clock 13 MHz or more, LVDS interface synchronous signal (See
the frame grabber manual.)
The National Instruments IMAQ PCI-1424 (NI parts No. 777662-02) frame grabber has been verified to successfully acquire 12-
bit digital images from C10013SK. The IMAQ PCI-1422 (NI pats No. 777959-02) also acquires satisfactory images from C10013SK.
You can utilize the demonstration software that comes with the frame grabber as a simple viewer, to acquire and save an image.
To do so, refer to the frame grabber user’s guide for how to use the camera information file for the demonstration software.
· Power source: A.vdd = +5.0 ± 0.1 V (700 mA), D.vdd = +5.0 ± 0.1 V (600 mA).
Please use of a series power supply. (Avoid using a switching power supply.) A power cable (terminated with an
FGG.2B.307.CLAD92Z plug at one end and open at the other end; 2 m; see Table 2.), an external trigger cable (terminated with
an FFA.0S.302.CLAC37 plug at one end and open at the other end; 5 m; see table 3.) and an earth cable (AWG 18; 4 m) comes
supplied with C10013SK. An optional frame grabber cable for interface with the 40-pin receptacle (see Table 1) on C10013SK
is also available for synchronous signal, video output and external control.
The voltages described above are specified at the flat panel sensor side. The impedance of the power cable attached with the
flat panel sensor is low enough but it causes 0.1 V approx. drop. Therefore the voltage at the power source side should be set
0.1 V higher than the voltage specified above.
Install a noise filter on the AC power input line to prevent surges on the AC line.
To supply the synchronous signal through ExtTrgGrb, apply high level of TTL to ExtTrgLemo and IntExt, or leave them without
connection. On the contrary, to use ExtTrgLemo, set high level to ExtTrgGrb and IntExt, or leave them without connection. The
earth terminal must be connected to a stable earth point to eliminate noise from surroundings.
Table 1:
Pin assignment of 40-pin receptacle
Pin No.
Signal
1
Data1+ (LSB)
2
Data2+
3
Data3+
4
Data4+
5
Data5+
6
Data6+
7
Data7+
8
Data8+
9
Data9+
10
Data10+
11
Data11+
12
Data12+ (MSB)
13
Reserved
14
Reserved
15
Reserved
16
Reserved
17
ExtTrgGrb (TTL)
18
Vsync+
19
Hsync+
20
Pclk+
Unless otherwise noted, signal level is LVDS.
40-pin receptacle: 10240-52B2PL made by 3M Co. Ltd.
Mating plug: 10140-6000EL made by 3M Co. Ltd.
Pin No.
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
Signal
Data1- (LSB)
Data2-
Data3-
Data4-
Data5-
Data6-
Data7-
Data8-
Data9-
Data10-
Data11-
Data12- (MSB)
Reserved
Reserved
GND
GND
IntExt (TTL)
Vsync-
Hsync-
Pclk-
Table 2:
Power pin assignment and cable color
Pin No.
1
2
3
4
5
6
7
Shield
7-pin power receptacle: ECG.2B.307.CLV made by LEMO S. A.
Mating power plug: FGG.2B.307.CLAD92Z made by LEMO S. A.
Color
Brown
Red
Orange
Yellow
Green
Blue
Purple
-
Signal
Reserved
Reserved
Reserved
Analog GND
Analog +5 V
Digital GND
Digital +5 V
Analog GND
Table 3:
External trigger pin assignment and cable color
Pin No.
1
2
Shield
2-pin receptacle: ECP.0S.302.CLL made by LEMO S. A.
Mating plug: FFA.0S.302.CLAC37 made by LEMO S. A.
Color
Red
Black
-
Signal
ExtTrgLemo (TTL)
Signal GND
Analog GND
相關PDF資料 |
PDF描述 |
|---|---|
| C10082CA | Mini-spectrometer TM series |
| C10082CAH | Mini-spectrometer TM series High sensitivity type (integrated with back-thinned type CCD image sensor) |
| C10083CA | Mini-spectrometer TM series |
| C10083CAH | Mini-spectrometer TM series High sensitivity type (integrated with back-thinned type CCD image sensor) |
| C10082MD | Mini-spectrometer TM series Integrating optical system, image sensor and circuit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| C100190-1 | 制造商:Glenair Inc 功能描述:ADAPTER - Bulk |
| C100190-2 | 制造商:Glenair Inc 功能描述:ADAPTER - Bulk |
| C100190-7 | 制造商:Glenair Inc 功能描述:ADAPTER - Bulk |
| C1001A.18.02 | 功能描述:2C/20AWG 7/28TC UNSHIELD 500' RoHS:是 類別:線纜，導線 >> 多芯導線 系列:- 標準包裝:1 系列:* 其它名稱:2131610.00 |
| C-1001E | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SINGLE DIGIT DISPLAY |
發布緊急采購，3分鐘左右您將得到回復。